The technique of alloying X120Mn12 steel substrate by plasma transferred arc process was used for development of a surface having high wear resistance. High carbon ferrochromium, ferrotungsten, and nickel-aluminum intermetallic powders were combined to form M7C3 carbides inside Fe-based composite surface coating. The phase transformations on these coated surfaces were comprehensively examined by using a combination of scanning electron microscopy (SEM) with energy dispersive spectrometry microanalysis, differential thermal analysis and X-ray diffraction (XRD). The microstructure studies of the superficial layers of the coating revealed a phase mixture of interdendritic austenite (γ) phase structure and fine eutectic M7C3 carbides. The new formed coated surfaces were investigated by change of alloying elements (Cr, W, Ni), size of dendrites, change of eutectic reaction temperatures, hardness, carbide volume ratio of hard phases, and coating thickness as the processing parameters (powder feed rate and heat input). The dry sliding wear tests were performed on a pin on disc machine. The wear rates of the tests were affected by the powder feed rate, powder type, and applied load. Results revealed that processing powder combination used in this study (FeCrC–FeW–NiAl) provided the best option with superior combination of properties on surface of X120Mn12 steel substrate.
The purpose of this study is to determine the grindability and kinetic behavior of clinker and colemanite in cement production when they are ground separately and together. Bond and Hardgrove grindability methods were employed to determine grindability properties clinker and colemanite by varying proportions. Bond work index (BWI) values of clinker and colemanite are 18.89 kWh/t and 12.33 kWh/t, respectively. BWI value of mixture decreases by added colemanite and the experimental BWI values of mixtures were lower than those of calculated, considering their proportions. Hardgrove grindability index (HGI) values of clinker and colemanite are 51.81 and 99.62, and Blaine fineness values are 920 cm2/g and 2430 cm2/g, respectively. As colemanite addition increases HGI and Blaine fineness values also increase. Experimental Blaine fineness values are greater than calculated values meaning that during intergrinding different ingredients do not show the same behavior as in the case of separate grinding. These findings explain that clinker particles have an abrasion effect thus an extra grinding effect on colemanite particles. The specific rates of breakage were determined through kinetic experiments to understand the grinding mechanisms of colemanite, clinker and their mixtures. The model parameters of Si, aT, and α were established in kinetic experiments.
11 July 2016 in International Journal of Coal Preparation and Utilization
Grindability of a coal is generally represented in terms of the Hard Groove Grindability Index (HGI); a coal of lower HGI needs more energy to be ground. Samples of this study were taken from the Amasra coalfield of the Zonguldak Hard Coal Basin to determine if coal grindability varies with the burial depth of coals. Samples from different burial depths were analyzed and corresponding HGI values were obtained. HGI values of the original samples were found between 51.43 and 79.26. A float-and-sink analysis was performed for some of the original samples and it was found that the HGI values of floated coal samples change between 49.04 and 73.52. A new method, which employs proximate and petrographic analysis data and the burial depth, was proposed for the prediction of HGI. Correlation of HGI with burial depth or the discrimination of floated and original coal currently exists. Correlations of the proposed methods have satisfactory coefficient of determination values (R2 =.75, R2 = .86) for the original and floated coal samples studied. This new proposed method was tested on the data and the previously studied original and floated coal samples of the Zonguldak coalfield and yielded a good correlation (R2 = .87, R2 = .90). The proposed method can be considered to yield reasonable predictions for the Amasra coalfield.