The periodicity and density of atomic arrangement vary with the crystal orientation, which results in different deformation mechanisms and mechanical properties of γ-TiAl. In this paper, the anisotropic characteristics for γ-TiAl with (100), ( ) and (111) surfaces during nanoindentation at 300 K have been investigated by molecular dynamics simulations. It is found that there is no obvious pop-in event in all load-depth curves when the initial plastic deformation of γ-TiAl samples occurs, because the dislocation nucleates before the first load-drop; while a peak appears in both the unloading curves of the ( ) and (111) samples due to the release of energy. Stacking faults, twin boundaries and vacancies are formed in all samples; however, interstitials are formed in the (100) sample, a stacking fault tetrahedron is formed in the (111) sample; and two prismatic dislocation loops with different activities are formed in the ( ) and (111) samples, respectively. It is also concluded that the values of the critical load, strain energy, hardness and elastic modulus for the (111) sample are the maximum, and for the (100) sample are the minimum. Furthermore, the orientation dependence of the elastic modulus is greater than the hardness and critical load.
In this paper, molecular dynamics simulations are performed to study the annealing process of γ-TiAl alloy with different parameters after introducing residual stress into prepressing. By mainly focusing on the dynamic evolution process of microdefects during annealing and the distribution of residual stress, the relationship between microstructure and residual stress is investigated. The results show that there is no phase transition during annealing, but atom distortion occurs with the change of temperature, and the average grain size slightly increases after annealing. There are some atom clusters in the grains, with a few point defects, and the point defect concentration increases with the rise in temperature, and vice versa; the higher the annealing temperature, the fewer the point defects in the grain after annealing. Due to the grain boundary volume shrinkage and and an increase in the plastic deformation of the grain boundaries during cooling, stress is released, and the average residual stress along Y and Z directions after annealing is less than the average residual stress after prepressing.
8 December 2023 in Measurement Science and Technology
A rolling bearing fault diagnosis method based on the Markov transition field (MTF) and multi-scale feature aggregation convolutional neural network (MFACNN) is proposed to address the problems of excessive parameter number, slow training speed, and insufficient generalization of traditional CNNs. Firstly, the original vibration signal is input into the MTF and converted into two-dimensional images with time correlation. Then, in order to effectively aggregate feature information at different scales and levels, a MFA module is presented to capture rich information from feature maps at different scales and assign different weights to these features for fusion. Secondly, while ensuring the lightweight of the model, utilizing feature information of different resolutions, a lightweight feature fusion module is put forward to fuse multiple feature maps together to improve the performance and efficiency of the model. On this basis, an MFACNN model is constructed. Finally, the two-dimensional images are input into MTF-MFACNN and experimentally validated using two different datasets. The results show that the proposed method has faster calculation speed, higher fault recognition accuracy, and stronger generalization performance compared to other methods.