The present work is focused on the synthesis of CoCrFeMnNi high entropy alloy (HEA) interstitially alloyed with nitrogen via powder metallurgy routes. Using a simple method, nitrogen was introduced to the HEA from the protective N2 gas atmosphere during mechanical alloying (MA) processing. The lattice parameter and amount of nitrogen in HEA were observed to be linearly proportional to the milling duration. The limited solubility of nitrogen in the main face centered cubic (FCC) phase resulted in the in-situ formation of nitrides and, accordingly, significant increase in the hardness values. It has been shown that fabrication of such nitrogen-doped HEA bulk materials can be conveniently achieved by a simple combination of MA + spark plasma sintering processes, without the need for adding nitrogen from other sources.
12 October 2018 in Journal of Thermal Spray Technology
The temperature dependence of tensile characteristics and fracture toughness of the standardly heat-treated low-alloyed steel OCHN3MFA along with three additionally heat-treated grades was experimentally studied. In the temperature range of ⟨−196; 22⟩ °C, all the additional heat treatments transferred the standard steel from a high- to ultra-high strength levels even with improved tensile ductility characteristics. This could be explained by a reduction of the inclusion content, refinement of the martensitic blocks, ductile retained austenite content, and homogenization of the shape ratio of martensitic laths as revealed by metallographic, X-ray, and EBSD techniques. On the other hand, the values of the fracture toughness of all grades were found to be comparable in the whole temperature range as the cause of a high stress triaxiality in the pre-cracked Charpy V-notch samples. The values of the fracture toughness of the standard steel grade could be predicted well using the fracture model proposed by Pokluda et al. based on the tensile characteristics. Such a prediction failed in the case of additionally heat-treated grades due to the different temperature dependence of the fracture mechanisms occurring in the tensile and fracture-toughness tests. While the tensile samples fractured in a ductile-dimple mode at all temperatures, the fracture-toughness specimens exhibited a transition from the ductile to quasi-brittle fracture mode with decreasing temperature. This transition could be interpreted in terms of a transfer from the model proposed by Rice and Johnson to the model of Tvergaard and Hutchinson.
1 July 2025 in The Journal of the Acoustical Society of America
Cold-sprayed metallic deposits are additively manufactured materials containing high levels of compressive residual stress. Here, we show that the presence and intensity of this stress can be analyzed using laser-ultrasonics, provided that the sprayed material is ferromagnetic and magnetostrictive, as in the case of pure nickel. Contactless resonant ultrasound spectroscopy is used to monitor the evolution of shear modulus and internal friction parameter of two polycrystalline Ni deposits with temperature over the Curie point, which enables a direct assessment of the strength of magnetoelastic softening that is known to be strongly stress-dependent. In addition, the proposed methodology is also shown to be suitable for in situ observation of the recrystallization process in the vicinity of the Curie point, as well as inspecting the homogeneity of the residual stress level across the thickness of the cold-sprayed deposit. Finally, a methodology for room temperature probing of the magnetoelastic coupling is proposed and tested on the examined materials.