The problem of intensification of the melt crystal growth process has been analyzed using CdTe as an actual material. Numerical simulation of 100 mm diameter CdTe crystal growth using the VGF technique has been carried out. The heat–mass transfer was controlled by introducing low-frequency oscillating baffle into the melt, which is a so-called axial vibrational control (AVC) technique. The baffle configuration has been optimized to destroy solid “tails”, which were formed near the crucible walls at high cooling rates due to the low thermoconductivity and the corresponding latent heat. Analysis of CdTe homogeneity range showed that during fast crystal cooling, Te micro precipitations were formed, resulting from the decay of oversaturated Cd-rich nonstoichiometric solid solution during the Bridgman crystal growth technique. After full crystallization, a VGF-grown CdTe crystal stays inside the phase field of the high-temperature wurtzite polymorph. This makes it possible to go through the polymorph transition without Te micro-precipitating using the advantages of the VGF-specific feature of very slow cooling.
A problem of efficacy of crystal growth methods for crystallization from solutions or melt has been investigated. The axial vibrational control (AVC) technique was considered as a perspective method to manage both heat-mass transfer and chemical component composition of the melts in the case of crystallization of complex chemical compounds. Numerical modeling and the search for generalized dependencies made it possible to predict the AVC parameters that provide optimal heat and mass transfer modes for creating flat liquid-solid interfaces, as well as the component composition of dissociated melts of various chemical compounds—Ge, NaNO3, CdTe.
Based on the P-T-X-Y diagram of ternary B-O-H system fulfilled by a graphical thermodynamic method the conditions of preparing the boron oxide (III) with controlled water content have been determined. Using the method of the direct determination of intercalated water in high-purity boron oxide a comparative study of the residual intercalated water and OH-groups content in a commercial product and fabricated high-purity boron oxide have been conducted. It has been shown that under traditional high-purity boron oxide synthesis conditions, a clear correlation between the residual intercalated water content and the OH groups content is impossible because of the need to control more than three intensive thermodynamic parameters at synthesis.