The issue of monitoring the structural condition of bridges is becoming a top priority worldwide. As is well known, any infrastructure undergoes a progressive deterioration of its structural conditions due to aging by normal service loads and environmental conditions. At the same time, it may suffer serious damages or collapse due to natural phenomena such as earthquakes or strong winds. For this reason, it is essential to rely on efficient and widespread monitoring techniques applied throughout the entire road network. This paper aims to introduce an integrated procedure for structural and material monitoring. With regard to structural monitoring, an innovative approach for monitoring based on Vehicle by Bridge Interaction (VBI) will be proposed. Furthermore, with regard to material monitoring, to evaluate concrete degradation, a non-invasive method based on the continuous monitoring of the pH, as well as chloride and sulfate ions concentration in the concrete, is presented.
1 September 2018 in Surface and Coatings Technology
The influence of the microstructural transformations upon heat treatments on the wear resistance of Fe-W coatings is studied. The coatings are electrodeposited from a glycolate-citrate plating bath with 24 at.% of W, and the wear resistance is investigated under dry friction conditions using ball-on-disc sliding tests. The samples were annealed in Ar atmosphere at different temperatures up to 800 °C. The microstructural transformations were studied by means of X-ray Diffraction (XRD), Scanning Electron Microscopy (SEM), and Electron Backscattered Diffraction (EBSD) technique. Except for the coating annealed at 800 °C, all the tested coatings suffered severe tribo-oxidation which resulted in the formation of deep cracks, i.e., ~15 μm in depth, within the wear track. The precipitation of the secondary phases, i.e., Fe2W and FeWO4, on the surface of the sample annealed at 800 °C increased the resistance to tribo-oxidation leading to wear tracks with an average depth of ~3 μm. Hence, the Fe-W coating annealed at 800 °C was characterized with a higher wear resistance resulting in a wear rate comparable to electrodeposited hard chromium coatings, i.e., 3 and 4 × 10−6 mm3/N m, respectively.
β-naphthol was one of the first additives introduced for smooth and homogeneous tin electrodeposition. Although it can be oxidized under the plating conditions, forming either 1,2-napthoquinone or polymeric materials based on naphthioxides, it is still in use. In this work, an investigation of its more stable form, alkoxylated β-naphthol (ABN), on tin plating is undertaken. For this purpose, chloride based (pH ~5) and methane sulfonic acid (MSA, pH ~0.5) electrolytes, including ABN, were prepared. Reaction kinetics were studied by polarization, Tafel measurements, and cyclic voltammetry. Tin electrodeposits were obtained on flat brass substrates. Surface morphology and preferred crystal orientation were studied by Scanning Electron Microscopy (SEM) and X-ray Diffraction (XRD). In both studied electrolytes ABN acts as an inhibitor but in the case of the chloride electrolyte it is more pronounced. In the MSA electrolyte this effect was overlaid by the presence of tin-citrate complexes. In the chloride-based electrolyte, ABN has a grain refining effect, while in the MSA electrolyte an increase of ABN concentration leads to a slight enlargement of the average grain size. X-ray analysis shows a constant decrease of the (101) intensity with increasing concentration of ABN for the sample deposited from both baths.