Continuous casting is one of the steel production stages, during which the improvement in the metallurgical purity of steel can be additionally affected by removing nonmetallic inclusions (NMIs). This can be achieved by means of various types of flow controllers, installed in the working space of the tundish. The change in the steel flow structure, caused by those flow controllers, should lead to an intensification of NMIs removal from the liquid metal to the slag. Therefore, it is crucial to understand the behavior of nonmetallic inclusions during the flow of liquid steel through the tundish, and particularly during their distribution. The presented paper reports the results of the modeling studies of NMI distribution in liquid steel, flowing through the tundish. CFD modeling methods—using different models and computation variants—were employed in the study. The obtained CFD results were compared with the results of laboratory tests (using a tundish water model). The results of the performed investigations allow us to compare both methods of modeling; the investigated phenomena were microparticle distribution and mass microparticle concentration in the model fluid. The validation of the CFD results verified the analyzed computation variants. The aim of the research was to determine which numerical model is the best for describing the studied phenomenon. This will be used as the first phase of a larger research program which will provide for a comprehensive study of the distribution of NMIs flowing through tundish steel.

High-quality steels are defined primarily by a small quantity of non-metallic inclusions and a high degree of chemical homogenisation. The ladle furnace (LF) is the most important metallurgical unit in which the quantity of non-metallic inclusions can be significantly reduced while ensuring metal chemical homogenisation. It is achieved largely due to appropriate controlling and the use of increasingly developed inert gas purging techniques. Various types of porous plugs (channel or radial type) are used in the metallurgical ladles. In aggregate units of intermediate-ladle type, various types of channel plugs and/or gas curtains are successfully used. In the research presented herein, a new and innovative module for inert gas injection into liquid steel for deep refining was tested. The presented research relates to the innovative module using to replace the standard porous plug in the steelmaking ladle on the outside-furnace (LF) processing station. Hybrid modelling methods (numerical and physical modelling) were used to carry out research. Module using causes significantly faster alloy additive dispersion in ladle volume compared with the standard solution (the standard porous plug). Furthermore, the obtained flowing structure positively affects liquid steel refining and mixing processes after alloy additive addition. A new technological solution, i.e., gas-injection module—differs from the traditional porous plugs currently used in the steel mills in terms of geometric parameters, external and internal structure, and what is most importantly, terms of the active surface area—shall be understood in as the surface area wherein slots occur.