In this paper, the interactions between two parallel cracks are investigated experimentally and numerically. Finite element models have been established to obtain the stress intensity factors and stress distributions of the parallel cracks with different positions and sizes. Fatigue crack growth tests of 304 stainless steel specimens with the single crack and two parallel cracks have been conducted to confirm the numerical results. The numerical analysis results indicate that the interactions between the two parallel cracks have an enhancement or shielding effect on the stress intensity factors, depending on the relative positions of the cracks. The criterion diagram to determine the enhancement or shielding effect between two parallel cracks is obtained. The changes of the stress fields around the cracks have been studied to explain the mechanism of crack interactions.
In this paper, the interactions between double cracks with a co-bisector-line were investigated theoretically and experimentally. Fatigue crack growth tests of specimens with a single crack or double cracks were carried out to measure the crack growth rates, and finite element calculations were performed to obtain the stress intensity factors at crack tips. It was found that when the double cracks are in co-bisector-line, they present shielding interactions which reduce the stress intensity factors at crack tips as well as the crack growth rates. By modifying the stress intensity factors and the Paris equation considering the shielding interactions, a new simplification method was proposed to simplify the double cracks into a single crack with the same crack growth rates.
In this paper, interactions of double parallel cracks were studied by performing experiments and numerical simulations. Fatigue crack propagation tests were carried out to measure crack growth rates in the specimens with double parallel cracks or a single crack. Finite element method was adopted to calculate stress intensity factors at the crack tips. Results show that the double parallel cracks at different positions present a shielding effect or enhancement effect on crack growth rates and stress intensity factors. When the double parallel cracks are offset, crack interactions mostly behave as enhancement effects. Empirical formulas were obtained to calculate the stress intensity factor at the “dangerous” crack tip of the double parallel cracks. By modifying the material parameters in Paris equation of the single crack, the double parallel cracks are simplified into a single crack with the same crack growth rates.
Conically corrugated tube is a new type of high-efficiency heat exchange tube. In this paper, the mechanical and heat transfer properties of conically corrugated tubes formed by the cold rolling of smooth tubes are studied through experimental measurement and numerical simulation to lay the foundations for applying the tubes in heat exchangers. The results show that while conically corrugated tube has a lower axial elastic stiffness compared with smooth tube, conically corrugated tube has a higher yield strength and ultimate strength. Unlike smooth tubes, conically corrugated tubes develop three-dimensional stresses when an axial tensile load is applied to them. In addition, the heat transfer coefficient of conically corrugated tube is 15%, 17%, and 115% higher than that of spiral grooved tube, convergent divergent tube, and smooth tube, respectively. Finally, the correlation equations of the axial stress concentration factor, stiffness equivalent coefficient, Nusselt number, and flow resistance coefficient of conically corrugated tubes are obtained for engineering application.
Having higher capacity to undertake pressures and larger compensation ability compared with the U-shape bellows, toroidal or Ω-shape bellows are being more and more widely used in engineering. The wave-shape and wall thickness reduction of bellows are the most important parameters for measuring the hydroforming quality of the bellows. In order to provide references for actual manufacturing, it is valuable to study the factors influencing the hydroforming process and quality of the bellows. In this paper, finite element simulations of the hydroforming process of a monolayer and single-wave toroidal bellows and a two-layer and four-wave toroidal bellows were carried out. Stress and strain distributions before and after unloading were analyzed and the wave height and wall thickness reduction were examined. The numerical results were verified by the actual hydroforming measurements. In addition, ranges of the significant structural or operating factors for producing better bellows were studied and a formula to compute the wall thickness reduction was fitted based on the sufficient numerical results of the hydroforming simulations.
23 September 2016 in Asia-Pacific Journal of Chemical Engineering