Fushun Xu

Dr. Fushun Xu


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 January 2019 in Metals
Verified
Journal Article
Open access
PDF file
JZJiuhui Zhao
Jiuhui Zhao
YDYunlai Deng
Yunlai Deng
FXFushun Xu
Fushun Xu
JZJin Zhang
Jin Zhang
Fine-grained (average gain size 3.8 μm) and coarse-grained (average gain size 24.9 μm) Al-Zn-Mg-Cu alloys were subjected to isothermal compression at 10−3 s−1 and temperature ranges from 300 °C to 450 °C. The grain structures after isothermal compression were observed by electron backscatter diffraction (EBSD). The results show that the continuous dynamic recrystallization (CDRX) mechanism dominated to form sub-grains in grain interiors during isothermal compression of coarse-grained materials, and sub-grains were gradually developed in grain interiors as the effective strain increased. Discontinuous dynamic recrystallization (DDRX) was the main recrystallization mechanism during isothermal compression of fine-grained materials, in which finer recrystallized grains were formed at grain boundaries. The temperature of isothermal compression had little influence on the recrystallization when the growth of recrystallized grains was slight, and sub-grains were hardly developed in fine-grain interiors.

22 January 2019 in Materials
Verified
Journal Article
Open access
PDF file
JZJin Zhang
Jin Zhang
ZJZhen Jiang
Zhen Jiang
FXFushun Xu
Fushun Xu
MCMingan Chen
Mingan Chen
The effects of pre-stretching on creep behavior, mechanical properties and microstructure during the creep aging process of Al-Cu-Li alloy were investigated. AA2195 was taken as the representative of Al-Cu-Li alloys. It is found that the total creep strain and strength property of creep aged AA2195 specimens can be improved through effective pre-stretching. Unlike with artificial aging, yield strength increased increasing by 47%. The TEM images show that the constitution of aging precipitates in the creep-aged specimens are obviously changed by pre-stretching. Precipitates in the 2% pre-stretched specimen are mainly composed of T1 phase, while a great amount of θ’ phase accompanied with a few T1 phase were found in the non-pre-stretched specimen. Moreover, pre-stretching introduces many dislocations which benefit the creep deformation, but the increasing dislocation density also accelerates the nucleation and growth of the precipitates as well. The premature T1 phase has a great blocking effect to the dislocation motion, creating a lower decrease rate but a longer duration in the early creep stage. Except for the initial dislocations, the dislocation motion in the creep aging process is also a favorable factor to precipitate the T1 phase.

24 September 2019 in Metals
Verified
Journal Article
Open access
PDF file
JZJin Zhang
Jin Zhang
ZLZhide Li
Zhide Li
FXFushun Xu
Fushun Xu
CBChongjun Bao
Chongjun Bao
After aging heat treatment, Al-Cu-Li alloy, in general, contains a variety of precipitated phases that jointly influence the age-strengthening effect on the alloy. In this work, a multiphase-coupled strengthening model has been established on the basis of a dislocation bypassing mechanism. The model considered situations with different proportions of two strengthening phases, T1 and θ′, and then obtained the dimension and volume fractions of these two strengthening phases via experiments. The values predicted by the multiphase-coupled strengthening model and the classical strengthening superposition model were compared with the measured results. The multiphase-coupled strengthening model established in this work had better consistency with the measured results. Moreover, the modeling method proposed in the paper can also be extended to the system having over two primary strengthening phases. Hence, the model can contribute towards the development of a multi-component precipitation strengthening process for aluminum alloys.