High-purity (99.999%) nickel with lamellar-structure grains (LG) was obtained by room-temperature rolling and cryorolling in this research, and then annealed at different temperatures (75 °C, 160 °C, and 245 °C). The microstructure was characterized by transmission electron microscopy. The grain growth mechanism during annealing of the LG materials obtained via different processes was studied. Results showed that the LG high-purity nickel obtained by room-temperature rolling had a static discontinuous recrystallization during annealing, whereas that obtained by cryorolling underwent static and continuous recrystallization during annealing, which was caused by the seriously inhibited dislocation recovery in the rolling process under cryogenic conditions, leading to more accumulated deformation energy storage in sheets.
After aging heat treatment, Al-Cu-Li alloy, in general, contains a variety of precipitated phases that jointly influence the age-strengthening effect on the alloy. In this work, a multiphase-coupled strengthening model has been established on the basis of a dislocation bypassing mechanism. The model considered situations with different proportions of two strengthening phases, T1 and θ′, and then obtained the dimension and volume fractions of these two strengthening phases via experiments. The values predicted by the multiphase-coupled strengthening model and the classical strengthening superposition model were compared with the measured results. The multiphase-coupled strengthening model established in this work had better consistency with the measured results. Moreover, the modeling method proposed in the paper can also be extended to the system having over two primary strengthening phases. Hence, the model can contribute towards the development of a multi-component precipitation strengthening process for aluminum alloys.
Cryogenic forming overcomes room-temperature limitations by leveraging the enhanced strength–ductility synergy in Al alloys. To explore the forming limits of AA5052 sheet under cryogenic forming conditions, quasi-in situ tensile tests were conducted and digital image correlation techniques were employed to examine strain distribution, surface roughness evolution, and forming limit curves of the AA5052 sheet in the tensile deformation process. Experimental results show that the maximum equivalent forming limit at −196 °C increases to 50.7% from 19.9% at room temperature, representing a 250% increase. At the same time, the surface roughness evolution rate increases by 60% from 2713 nm at room temperature to 4414 nm at −196 °C. Cryogenic conditions suppress dislocation annihilation and dynamic recovery, enhancing strain hardening, resulting in higher forming limits. Additionally, intensified grain rotation and more dislocation slip accelerate surface roughening, which influences the development of the geometric heterogeneity coefficient. By introducing a strain-dependent surface roughening coefficient, the Marciniak–Kuczyński (M-K) model was modified and was used to quantitatively characterize the heterogeneity during deformation, and subsequently analyzes its impact on the prediction of forming limits for AA5052 from room temperature (25 °C) to cryogenic temperature (−196 °C). The modified model reduces the prediction standard deviation by more than 70% and the identified mechanisms offer theoretical guidance for optimizing cryogenic forming process parameters for Al alloy components with complex geometries.