Domenico Zito

Prof. Domenico Zito


Research Focus & Metrics

Academic Career Length

24Years (2003-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 October 2016 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
DPDomenico Pepe
Domenico Pepe
DZDomenico Zito
Domenico Zito
This paper presents two 4-bit (16-phase) mm-wave vector modulator phase shifters exploiting a novel in-phase and quadrature signal generator that consists of a single-input double-output cascode amplifier incorporating a lumped-element coupled-line quadrature coupler. The two circuit implementations have been designed and fabricated in a 28 nm fully depleted silicon-on-insulator CMOS. The first (PS1) achieves a higher gain and the second (PS2) has a more compact area (reduced to about 50%). Each consumes 18 mA from a 1.2 V supply. PS1 exhibits an average gain of 2.3 dB at 87.4 GHz and B 3dB from 78.8 to 92.8 GHz; rms gain error of 1.68 dB at 87.4 GHz and <;2 dB in the B 3dB ; rms phase error of 9.4° at 87.4 GHz and <;11.9° in B 3dB ; S 11 <; -10.5 dB in B 3dB ; average P 1dB of -7 dBm; and average noise figure (NF) equal to 10.8 dB at 87 GHz. PS2 exhibits an average gain of 0.83 dB at 89.2 GHz and B 3dB from 80.2 to 96.8 GHz; rms gain error of 1.46 dB at 89.2 GHz and <;2 dB in B 3dB ; rms phase error of 11.2° at 89.2 GHz and <;11.9° in B 3dB ; S 11 <; -11.5 dB in B 3dB ; average P 1dB of -6 dBm; and average NF of 11.9 dB at 89 GHz.

26 February 2020 in IEEE Transactions on Geoscience and Remote Sensing
Verified
Journal Article
Closed access
Federico AlimentiFederico Alimenti
Federico Alimenti
Stefania BonafoniStefania Bonafoni
Stefania Bonafoni
EGElisa Gallo
Elisa Gallo
VPValentina Palazzi
Valentina Palazzi
Roberto Vincenti GattiRoberto Vincenti Gatti
Roberto Vincenti Gatti
Tommaso MoramarcoTommaso Moramarco
Tommaso Moramarco
River discharge is an important variable to measure in order to predict droughts and flood occurrences. Once the cross-sectional geometry of the river is known, discharge can be inferred from water level and surface flow velocity measurements. Since river discharges are of particular interest during extreme weather events, when river sites cannot be safely accessed, noncontact sensing technologies are particularly appealing. To this purpose, this work proposes a prototype of a low-cost continuous wave (CW) Doppler radar sensor, which is able to monitor the surface flow velocity of rivers. The prototype is tested at two gauged sites in central Italy, along the Tiber River. The surface flow velocity distribution across the river is monitored by means of the analysis of received Doppler signal. The surface velocity statistics are then extracted using a novel algorithm that is optimized to run on a microprocessor platform with minimal computing power (ArduinoUNO). In particular, the radar measurements are used to initialize a 2-D entropy-based velocity model (EVM) that is able to estimate river discharges in any flow condition. Finally, the results concerning the observed discharge provided by the EVM prove to be comparable with those obtained with more expensive commercial solutions. The results are important since the described methodology can be extended to small-size Doppler radar sensors onboard unmanned aerial vehicles (UAVs), the latter providing a method for mapping surface velocity of rivers.

20 May 2010 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
FZFabio Zito
Fabio Zito
DPDomenico Pepe
Domenico Pepe
DZDomenico Zito
Domenico Zito
A low-complexity fully integrated ultrawideband (UWB) monocycle pulse generator realized in 90-nm CMOS technology by ST-Microelectronics is presented. The circuit provides a monocycle pulse when activated by a negative edge of an external trigger signal provided by a microcontroller by exploiting the operating principle of nonlinear waveform shapers. This pulse generator represents a building block of an innovative wearable system-on-chip UWB radar on silicon for cardiopulmonary monitoring. On-chip measurements show that the pulse generator provides monocycle pulses with a duration time equal to 380 ps and a peak-to-peak amplitude of 660 mV (including the losses of the microprobes, cables, and electrostatic-discharge-protected pads), which are in very good agreement with the postlayout simulations. The power consumption is 19.8 mW from a 1.2-V power supply.

23 June 2009 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
DZDomenico Zito
Domenico Zito
AFAlessandro Fonte
Alessandro Fonte
DPDomenico Pepe
Domenico Pepe
In this letter, the experimental proofs of two microwave active inductors with very high quality factor, namely Differential Boot-Strapped Inductor (D-BSI) and Cross-Coupled Differential Boot-Strapped Inductor (CCD-BSI), are presented. These circuits can be effectively implemented in modern RF-CMOS processes for high-Q equivalent integrated inductors at high frequency. The cases of study at 13 GHz have been designed and implemented in a modern standard 90 nm bulk CMOS process. The measurements on the test-chips show an equivalent inductance close to 3.2 nH with an associated quality factor up to 400 and a wide linearity range.

9 November 2017 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
DPDomenico Pepe
Domenico Pepe
DZDomenico Zito
Domenico Zito
APAndrea Pallotta
Andrea Pallotta
LLLuca Larcher
Luca Larcher
This letter presents a four-way parallel–series power amplifier (PA) in 55-nm SiGe BiCMOS with in-line coplanar transformers for output power combining, and input/interstage power splitting. The in-line geometry allows an area efficient impedance matching design and an effective input signals routing to the individual PA stages without phase mismatch. The measurements show that the PA delivers a maximum output power of 23.4 dBm, an output-referred P1dB of 20 dBm, a gain of 23.8 dB, and a maximum power added efficiency of 12.5%, at 66 GHz, with a record power density (output power/active area) of 1.29 W/mm2 among PAs on silicon technologies operating beyond 40 GHz.

2 November 2017 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
DPDomenico Pepe
Domenico Pepe
ICIlias Chlis
Ilias Chlis
DZDomenico Zito
Domenico Zito
The transformer-based input integrated matching allows the realization of the simultaneous optimum noise and maximum power transfer input impedance matching in cascode amplifiers by exploiting the mutual coupling between the two spirals of an integrated transformer. This technique has been adopted to design LNAs operating in the microwave and millimeter-wave frequency ranges; however, the analytical proofs are still missing. This paper addresses for the first time a complete and in-depth study of the circuit topology and design technique in order to provide the analytical proofs. In-depth analyses are also used to get useful circuit insights, derive effective design equations, and carry out a direct comparison with the most widespread cascode low-noise amplifier with inductive degeneration through circuit design under the same conditions.