16 September 2022 in IEEE Transactions on Microwave Theory and Techniques
A 16-element 140–160-GHz phased array transceiver is reported. The chipset is fabricated using STMicroelectronics’ 55-nm SiGe BiCMOS process. Five different chips are implemented: a 4-channel transmitter with a maximum gain per channel of 15 dB and 0-dBm saturated output power; a 4-channel receiver with a maximum gain of 8 dB, a $-$ 10.4-dBm input 1-dB compression point (IP ${_\mathrm{1\,dB}}$ ), and a minimum noise figure (NF) of 15.6 dB per channel; a 0–1-GHz to 140–160-GHz I/Q up-converter with integrated frequency doubler, exhibiting a $-$ 13.5-dB conversion gain (CG) and $-$ 6-dBm output 1-dB compression point using a 70–80-GHz local oscillator (LO); a 140–160-GHz to 0–1-GHz I/Q down-converter with integrated frequency doubler, exhibiting a CG of 0 dB and IP ${_\mathrm{1\,dB}}$ of 0 dBm using a 70–80-GHz LO and an 11.67–13.33-GHz to 70–80-GHz x6 frequency multiplier for the LO, delivering 5.6-dBm maximum output power. The chips are assembled together with 16 cavity-backed aperture-coupled patch antennas using a high-performance and low-cost commercial PCB, supported over a heat sink. The main challenges encountered during the integration of the proposed system are also discussed. The complete system is used to build a wireless radio link in the laboratory, demonstrating 2-D beam steering in a range of $\pm$ 30 $^\circ$ .
9 November 2017 in IEEE Microwave and Wireless Components Letters
This letter presents a four-way parallel–series power amplifier (PA) in 55-nm SiGe BiCMOS with in-line coplanar transformers for output power combining, and input/interstage power splitting. The in-line geometry allows an area efficient impedance matching design and an effective input signals routing to the individual PA stages without phase mismatch. The measurements show that the PA delivers a maximum output power of 23.4 dBm, an output-referred P1dB of 20 dBm, a gain of 23.8 dB, and a maximum power added efficiency of 12.5%, at 66 GHz, with a record power density (output power/active area) of 1.29 W/mm2 among PAs on silicon technologies operating beyond 40 GHz.
17 September 2024 in IEEE Microwave Magazine
Silicon germanium (SiGe) BiCMOS technology, often simply called SiGe , is used for high-performance SiGe heterojunction bipolar transistors (HBTs, versus Si bipolar junction transistors) and high-quality passive devices on a CMOS platform (see Figure 1 [1] ). This combination offers better performance at lower cost than CMOS and III–V technologies and is able to address most demanding analog and RF applications, while benefiting from the advantages of SiGe HBTs and CMOS for digital functions [2] .