This paper focuses on indirect biomass drying. It compares the operating characteristics of a laboratory-scale drum dryer and a pilot-scale rotary dryer. Before the design of an industrial dryer for a specific material, it is important to experimentally prove the process and to determine the drying characteristics of the material. To verify the portability of experimental results for indirect dryers, a drum dryer with indirect electric heating in a laboratory scale was designed and built to test and study the process of indirect drying. Based on the results obtained on a small-scale device, a prototype of a pilot steam-heated rotary dryer was designed and manufactured. A broad range of experiments with green wood chips and wet bark from open-air storage with moisture contents of 50 to 65 wt % were carried out on both dryers. The drying curves indicating the process, the square and volumetric evaporation capacities, and the drying energy consumption were obtained and compared, and the feasibility of indirect drying for these tested types of biomass was confirmed.
This article deals with the influence of the final drying degree of moist biomass used as fuel in a power or CHP plant on indirect dryer sizing. For a description of the drying process, experiments with wet bark containing approx. 50 wt% of water were carried out in a laboratory indirect dryer. A new parameter called drying effectivity was introduced, whose size varies according to the degree of biomass being dried. Its maximum value corresponds to the optimal biomass drying, when the relative size of the indirect dryer to evaporate the required mass of water from the biomass would be smallest. Based on the experimentally determined drying characteristics of wet bark, the optimal drying of 13 wt% of water content was evaluated. If the bark was dried to a lower water content, the required relative size and price of the dryer would increase. Similarly, drying a bark with water content above 31 wt% is not very advantageous because drying effectivity continues to increase rapidly at this stage, and the required relative size of the dryer therefore decreases.
1 January 2017 in JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
The present article presents the energy efficient concept of biomass indirect drying. The options for the integration of indirect biomass drying into the cycles of steam power plants and hot water heating plants were analyzed. New concepts of wet biomass utilization in energy systems with an integrated indirect biomass dryer and the utilization of latent heat of waste vapor released during drying were proposed. Prototypes of the dryer and the waste vapor condenser were designed and the feasibility of the proposed solution was experimentally verified. Drying characteristics and energy consumption were determined. The potential for recuperating the waste vapor heat was analyzed. In comparison with other drying methods, the designed solutions are energy efficient and effectively utilize the waste steam heat. The profitability of the proposed solution is apparent from the increase in the cycle efficiency in comparison with the case without drying. Integration of drying into energy cycles makes it possible to achieve higher energy efficiency of the systems and significant fuel savings, and to replace high quality biomass with low-grade moist forms.
This paper presents an analysis of heat transfer in the process of condensation of water vapor in a vertical shell-and-tube condenser. We analyze the use of the Nusselt model for calculating the condensation heat transfer coefficient (HTC) inside a vertical tube and the Kern, Bell-Delaware and Stream-flow analysis methods for calculating the shell-side HTC from tubes to cooling water. These methods are experimentally verified for a specific condenser of waste process vapor containing air. The operating conditions of the condenser may be different from the assumptions adopted in the basic Nusselt theory. Modifications to the Nusselt condensation model are theoretically analyzed.