The paper deals with a capacitive micromachined ultrasonic transducer (CMUT)-based sensor dedicated to the detection of acoustic emissions from damaged structures. This work aims to explore different ways to improve the signal-to-noise ratio and the sensitivity of such sensors focusing on the design and packaging of the sensor, electrical connections, signal processing, coupling conditions, design of the elementary cells and operating conditions. In the first part, the CMUT-R100 sensor prototype is presented and electromechanically characterized. It is mainly composed of a CMUT-chip manufactured using the MUMPS process, including 40 circular 100 µm radius cells and covering a frequency band from 310 kHz to 420 kHz, and work on the packaging, electrical connections and signal processing allowed the signal-to-noise ratio to be increased from 17 dB to 37 dB. In the second part, the sensitivity of the sensor is studied by considering two contributions: the acoustic-mechanical one is dependent on the coupling conditions of the layered sensor structure and the mechanical-electrical one is dependent on the conversion of the mechanical vibration to electrical charges. The acoustic-mechanical sensitivity is experimentally and numerically addressed highlighting the care to be taken in implementation of the silicon chip in the brass housing. Insertion losses of about 50% are experimentally observed on an acoustic test between unpackaged and packaged silicon chip configurations. The mechanical-electrical sensitivity is analytically described leading to a closed-form amplitude of the detected signal under dynamic excitation. Thus, the influence of geometrical parameters, material properties and operating conditions on sensitivity enhancement is clearly established: such as smaller electrostatic air gap, and larger thickness, Young’s modulus and DC bias voltage.
22 February 2021 in IEEE Robotics and Automation Letters
Current digital microrobots are mainly composed of bistable modules and flexible structures. Unlike conventional microrobots, they are based on mechanical stability instead of complex control strategies in order to reach precise and repeatable discrete positioning. By design, their number of stable positions depends on the number of bistable modules. As a consequence, increasing the robot workspace requires using several modules. In this case, the robot size increases and its miniaturization becomes complex and non-intuitive. To address this issue, a multistable module has been developed to reach several stable positions. In this letter, a new generation of digital microrobots is proposed. Based on two multistable modules and flexible structures, the new microrobot can reach a large workspace while having a small footprint. Concretely, the robot size decreases by 26% while the number of stable positions increases by 950% in comparison with the first generation of the digital microrobot. A prototype is designed, fabricated and characterized experimentally. Preliminary results show a good agreement between the expected and the achieved workspace. The robot achieves 169 stable positions with a discrete step of 4.125 $\mu$m and a resolution of 150 nm. With these capabilities, the robot paves the way for promising perspectives and applications, in particular precise micro-manipulation in confined environment such as a Scanning Electron Microscope.
This paper presents a nonlinear analytical model of MEMS mass sensor, which is composed of two cantilevers of 98 µm and 100 µm length, 20 µm width and 1.3 µm thick. They are connected by a coupling beam and only the shortest cantilever is actuated by a combined AC-DC voltage. The DC voltage is used to equilibrate the system and the phenomenon of mode localization is investigated when a mass perturbation is applied. The sensor is modeled as a continuous system with beam theory and non-ideal boundary conditions are considered by using flexible supports. With a low AC voltage of 10 mV, a DC voltage of 5.85 V can counterbalance the length difference. This DC voltage decreases at 5.60 V when we increase the AC voltage, due to the effect of electrostatic nonlinearities. For a relative added mass of 0.1%, the amplitude change in the two cantilevers is more important when the coupling is weaker.
15 June 2002 in Japanese Journal of Applied Physics