Monitoring fine particulate matter with diameters of less than 2.5 μm (PM2.5) is a critical endeavor in the Beijing–Tianjin–Hebei (BTH) region, which is one of the most polluted areas in China. Polar orbit satellites are limited by observation frequency, which is insufficient for understanding PM2.5 evolution. As a geostationary satellite, Himawari-8 can obtain hourly optical depths (AODs) and overcome the estimated PM2.5 concentrations with low time resolution. In this study, the evaluation of Himawari-8 AODs by comparing with Aerosol Robotic Network (AERONET) measurements showed Himawari-8 retrievals (Level 3) with a mild underestimate of about −0.06 and approximately 57% of AODs falling within the expected error established by the Moderate-resolution Imaging Spectroradiometer (MODIS) (±(0.05 + 0.15AOD)). Furthermore, the improved linear mixed-effect model was proposed to derive the surface hourly PM2.5 from Himawari-8 AODs from July 2015 to March 2017. The estimated hourly PM2.5 concentrations agreed well with the surface PM2.5 measurements with high R² (0.86) and low RMSE (24.5 μg/m³). The average estimated PM2.5 in the BTH region during the study time range was about 55 μg/m³. The estimated hourly PM2.5 concentrations ranged extensively from 35.2 ± 26.9 μg/m³ (1600 local time) to 65.5 ± 54.6 μg/m³ (1100 local time) at different hours.

With the rapid modernization, many remote-sensing sensors were developed for classifying urban land and environmental monitoring. Multispectral LiDAR, which serves as a new technology, has exhibited potential in remote-sensing monitoring due to the synchronous acquisition of three-dimension point cloud and spectral information. This study confirmed the potential of multispectral LiDAR for complex urban land cover classification through three comparative methods. Firstly, the Optech Titan LiDAR point cloud was pre-processed and ground filtered. Then, three methods were analyzed: (1) Channel 1, based on Titan data to simulate the classification of a single-band LiDAR; (2) three-channel information and the digital surface model (DSM); and (3) three-channel information and DSM combined with the calculated three normalized difference vegetation indices (NDVIs) for urban land classification. A decision tree was subsequently used in classification based on the combination of intensity information, elevation information, and spectral information. The overall classification accuracies of the point cloud using the single-channel classification and the multispectral LiDAR were 64.66% and 93.82%, respectively. The results show that multispectral LiDAR has excellent potential for classifying land use in complex urban areas due to the availability of spectral information and that the addition of elevation information to the classification process could boost classification accuracy.

Urban trees, as a characteristic element of the urban ecosystem, exert significant influences on climate supervision. Therefore, the extraction of individual trees in urban areas holds significant research value. However, the complexity of features in urban areas poses challenges to existing single tree segmentation algorithms, as they may be influenced by other non-tree features. In this study, to reduce the influence of non-tree categories, enhance identification of edge features between adjacent tree crowns and achieve precise delineation results of single urban tree, an improved multi-stage method was proposed for tree points extraction and individual tree segmentation in urban scenes using multispectral LiDAR. Firstly, the original three single-channel point clouds were pre-processed by intensity interpolation to generate three-wavelength multispectral point cloud. Secondly, the Point Transformer deep learning network was employed for extracting urban tree points. Thirdly, an improved tree mapping algorithm was introduced for individual tree segmentation in urban scenes, utilizing the extracted tree points. Finally, manual individual tree labeling and the high-resolution Digital Orthophoto Map (DOM) of the region was incorporated to measure the delineation precision of individual tree. It shows that the IoU of tree category in urban scene reaches 96.0%. Moreover, the F1-score for overall individual tree segmentation attains 92.8%. And, a comparison with existing algorithms reveals that the proposed method outperforms traditional raster-based watershed method or point cloud clustering-based layer-stacking approach in urban scene, improving the overall accuracy of single tree segmentation by 21.9% and 16.0%, respectively. These results highlight the enhanced applicability of the proposed multi-stage algorithm for urban scenes.

The monitoring of extreme precipitation events is an important task in environmental research, but the ability of the Integrated Multi-satellitE Retrievals for Global Precipitation Measurement (IMERG) precipitation products to monitor extreme precipitation events remains poorly understood. In this study, three precipitation products for IMERG version 6, early-, late-, and final-run products (IMERG-E, IMERG-L, and IMERG-F, respectively), were used to capture extreme precipitation, and their applicability to monitor extreme precipitation events over Hubei province in China was evaluated. We found that the accuracy of the three IMERG precipitation products is inconsistent in areas of complex and less complex topography. Compared with gauge-based precipitation data, the results reveal the following: (1) All products can accurately capture the spatiotemporal variation patterns in precipitation during extreme precipitation events. (2) The ability of IMERG-F was good in areas of complex topography, followed by IMERG-E and IMERG-L. In areas of less complex topography, IMERG-E and IMERG-L produced outcomes that were consistent with those of IMERG-F. (3) The three IMERG precipitation products can capture the actual hourly precipitation tendencies of extreme precipitation events. (4) In areas of complex topography, the rainfall intensity estimation ability of IMERG-F is better than those of IMERG-E and IMERG-L.

Leaf area index (LAI) is an important biophysical parameter, which can be effectively applied in the estimation of vegetation growth status. At present, amounts of studies just focused on the LAI estimation of a single plant type, while plant types are usually mixed rather than single distribution. In this study, the suitability of GF-1 data for multi-species LAI estimation was evaluated by using Gaussian process regression (GPR), and a look-up table (LUT) combined with a PROSAIL radiative transfer model. Then, the performance of the LUT and GPR for multi-species LAI estimation was analyzed in term of 15 different band combinations and 10 published vegetation indices (VIs). Lastly, the effect of the different band combinations and published VIs on the accuracy of LAI estimation was discussed. The results indicated that GF-1 data exhibited a good potential for multi-species LAI retrieval. Then, GPR exhibited better performance than that of LUT for multi-species LAI estimation. What is more, modified soil adjusted vegetation index (MSAVI) was selected based on the GPR algorithm for multi-species LAI estimation with a lower root mean squared error (RMSE = 0.6448 m²/m²) compared to other band combinations and VIs. Then, this study can provide guidance for multi-species LAI estimation.

Leaf area index (LAI) is a key biophysical variable to characterize vegetation canopy. Accurate and quantitative LAI estimation is significant for monitoring vegetation growth status. ZhuHai-1 (ZH-1), which is a commercial remote sensing micro-nano satellite, provides a possibility for quantitative detection of vegetation with high spatial and spectral resolution. However, the band characteristics of ZH-1 are closely related to the accuracy of vegetation monitoring. In this study, a simulation dataset containing 32 bands of ZH-1 was generated by using the PROSAIL model, which was used to analyze the performance of 32 bands for LAI estimation by using the hybrid inversion method. Meanwhile, the effect of different band combinations on LAI estimation was discussed based on sensitivity analysis and the correlation between bands. Then, the optimal band combination from ZH-1 hyperspectral satellite data for LAI estimation was obtained. LAI estimation was performed based on the selected optimal band combination of ZH-1 satellite images in Xiantao city, Hubei province, and compared with the Sentinel-2 normalized difference vegetation index (NDVI) values and LAI product. The results demonstrated that the obtained LAI map based on the optimal band combination of ZH-1 was generally consistent with the overall distribution of Sentinel-2 NDVI and the LAI product, but had a moderate correlation with Sentinel-2 LAI (R = 0.60), which may not favorably indicate the validity of indirect validation. However, the method of this study on the analysis of hyperspectral data bands has application potential to provide a reference for selecting appropriate bands of hyperspectral satellite data to estimate LAI and improve the application of hyperspectral data such as ZH-1 in vegetation monitoring.