Rapid increase in operating frequencies and power density necessitate the importance of examining electromagnetic compatibility/electromagnetic emissions (EMEs) from high-frequency and high-power integrated circuits (ICs). In this paper, a simulation method is demonstrated to study the EME using gallium nitride high electron mobility transistor power amplifier IC chip as a device under test. Simulation model is developed by collaborating a high-frequency structure simulator with a Keysight Advance Design System for simulation of three-dimensional layout of IC. The simulated EME results are verified with experimental measurement results; the hotspots obtained with higher EME as identified by a near-field scanner and simulation results are identical. With this simulation method, optimization is done using a response surface methodology to reduce the EME for the IC chip. It is found that small changes in the IC layout can make a significant difference in the EME. Simulation model developed with RSM optimization technique opens a gateway for the IC industry to investigate EME of their chip design without going through a costly and time-consuming process of fabrication for testing its EME.
31 July 2019 in IEEE Transactions on Industrial Electronics
Owing to the high frequency and high power requirements for communication integrated circuits (ICs) in today rapid development of electronic technology, the intensity of electromagnetic field from the ICs can be significant. This work shows a failure due to this enhanced electromagnetic field in a Gallium Nitride based High Electron Mobility Transistor (GaN-HEMT) high frequency power amplifier. Inputs were provided as per the rated values and failures are observed on the drain and gate terminals. Detail failure analysis on the failed samples, using focus ion beam (FIB) technique for cross sectioning the damaged area and examining under scanning electron microscopy/ energy dispersive X-Ray spectroscopy (SEM/EDS), reveals the meltdown of the materials at the drain and gate terminals. Electromagnetic simulations and measurements are performed, and the failure mechanism is confirmed to be due to the magnetic field induced eddy current in the drain metal plate of the transistor, on top of the designed operating current in the metal plate.
Advancements in the functionalities and operating frequencies of integrated circuits (IC) have led to the necessity of measuring their electromagnetic Interference (EMI). Three-dimensional integrated circuit (3D-IC) represents the current advancements for multi-functionalities, high speed, high performance, and low-power IC technology. While the thermal challenges of 3D-IC have been studied extensively, the influence of EMI among the stacked dies has not been investigated. With the decreasing spacing between the stacked dies, this EMI can become more severe. This work demonstrates the potential of EMI within a 3D-IC numerically, and determines the minimum distance between stack dies to reduce the impact of EMI from one another before they are fabricated. The limitations of using near field measurement for the EMI study in stacked dies 3D-IC are also illustrated.
In this paper, optimization of a miniaturized multiple-inputs multiple-outputs (MIMO) antenna was performed. This antenna was composed of a T-shape radiating element with stub and reduced ground plane and a compact size of 25 mm × 25 mm × 1.6 mm. The behavior of antenna was evaluated in terms of return loss (S-parameter < −10 dB), electromagnetic interference (EMI), and operation frequency. The antenna design is applicable to many applications. A 2K factorial design combined with a genetic algorithm (GA) optimization technique were used to identify the key design parameters responsible for affecting the performance quality of the antenna. Optimization of the antenna design for EMI reduction was utilized, and the optimal design showed enhanced bandwidth of the antenna and reduced power consumption.