We present a comparison of two interband cascade detectors optimized for long-wavelength infrared region: with equal and matched-absorbers. In matched-absorbers architecture the first absorber determinates the thickness of the subsequent active layer, in order to meet equal quantum efficiency in all stages (QE condition). The simulations showed that quantum efficiency, for both types of architectures, decreases, while the detectivity increases versus number of stages. Detectors with equal absorbers (no QE condition) allow to build more stages in the cascade being the possible way to improve detectivity. On the other hand, structures with matched-absorbers show more flexibility in detectivity improvement by optimal selection of individual active layers. It is shown that structures assumed in literature do not fully exploit the potential offered by the matched-absorbers approach. The optimal absorber selection allows to reach two times higher quantum efficiency. Moreover, interband cascade detectors optimized for long-wavelength were compared with intersubband quantum cascade infrared photodetectors and HgCdTe showing potential for room temperature operation.
The paper presents electrical and optical properties of interband cascade infrared photodetectors with InAs/GaSb type-II superlattice absorbers. We compare the detection parameters of detectors grown on the native GaSb substrate and lattice-mismatched GaAs substrate and seek solutions to enhance device performance, specifically with using an optical immersion. The detectors grown on GaAs have better detection parameters at room temperature, but, at lower temperatures, the misfit dislocations become more important, and detectors grown on GaSb become better.
9 June 2020 in IEEE Transactions on Electron Devices
This article concerns the temperature dependence of low-frequency noise measured in the temperature range of 77–300 K in InAs/InAsSb superlattice photoconductors optimized for long-wavelength infrared (LWIR) and very long-wavelength infrared (VLWIR) spectral range. The differences in the T-dependence and the magnitude of 1/f noise, observed for LWIR and VLWIR photoconductors, are connected with different scattering mechanisms. Using the Hooge empirical model of 1/f noise and modeling of the total mobility, it is suggested that either the phonon-related or the defect-related mobility fluctuations can be responsible for the measured noise depending on the mechanism which determines the total mobility. In the VLWIR photoconductors, the defect-related 1/f noise prevails, while the phonon-related component dominates in the LWIR detector. The latter is best described by the Melkonyan et al. ’s mobility fluctuation model, which assumes the phonon scattering as the origin of 1/f noise. It roughly explains the T-dependence and predicts the value to within the one order of magnitude.
The flagship monthly journal of SPIE, Optical Engineering (OE) publishes peer-reviewed papers reporting on research and development in all areas of optics, photonics, and imaging science and engineering.
In this article we present the research on optoelectronic system for stand-off detection of alcohol vapours in moving cars. The idea of using commercially available cascade lasers was presented. Special attention was paid to the optical characteristics of the car windowpanes. It was shown that using 3.45 μm and 3.59 μm wavelengths the alcohol vapours inside a car can be successfully detected even for cars with different windows