This article investigates the presence of a new interferometric signal in multilooked synthetic aperture radar (SAR) interferograms that cannot be attributed to the atmospheric or Earth-surface topography changes. The observed signal is short-lived and decays with the temporal baseline; however, it is distinct from the stochastic noise attributed to temporal decorrelation. The presence of such a fading signal introduces a systematic phase component, particularly in short temporal baseline interferograms. If unattended, it biases the estimation of Earth surface deformation from SAR time series. Here, the contribution of the mentioned phase component is quantitatively assessed. The biasing impact on the deformation-signal retrieval is further evaluated. A quality measure is introduced to allow the prediction of the associated error with the fading signals. Moreover, a practical solution for the mitigation of this physical signal is discussed; special attention is paid to the efficient processing of Big Data from modern SAR missions such as Sentinel-1 and NISAR. Adopting the proposed solution, the deformation bias is shown to decrease significantly. Based on these analyses, we put forward our recommendations for efficient and accurate deformation-signal retrieval from large stacks of multilooked interferograms.
3 December 2020 in IEEE Transactions on Geoscience and Remote Sensing
This article deals with the analysis of InSAR performance for large-scale deformation measurement. The study evaluates the use of models, especially numerical weather prediction reanalysis, to mitigate disturbances in SAR interferograms. The impact of such corrections is evaluated by analyzing short-time baseline phase variograms in order to derive a lower bound for the interferometric accuracy, especially at large distances. The variance is then propagated from single interferograms to deformation rates. Finally, using GNSS measurements, the predicted error bars are validated on a large Sentinel-1 data set.
This paper deals with the integration of deformation rates derived from Synthetic Aperture Radar Interferometry (InSAR) and Global Navigation Satellite System (GNSS) data. The proposed approach relies on knowledge of the variance/covariance of both InSAR and GNSS measurements so that they may be combined accounting for the spectral properties of their errors, hence preserving all spatial frequencies of the deformation detected by the two techniques. The variance/covariance description of the output product is also provided. A performance analysis is carried out on realistic simulated scenarios in order to show the boundaries of the technique. The proposed approach is finally applied to real data. Five Sentinel-1A/B stacks acquired over two different areas of interest are processed and discussed. The first example is a merged deformation map of the northern part of the Netherlands for both ascending and descending geometries. The second example shows the deformation at the junction between the North and East Anatolian Fault using three consecutive descending stacks.
7 January 2016 in IEEE Geoscience and Remote Sensing Letters
A conventional interferometric synthetic aperture radar (SAR) system provides 1-D line-of-sight motion measurements from repeat-pass observations. Two-dimensional motions may be measured by combining two observations from ascending and descending geometries. The third motion component may be retrieved by adding a third geometry and/or by integrating along-track measurements although with much reduced precision compared to the other two components. Several options exist to improve the accuracy of retrieving the third motion component, such as combining left- and right-looking observations or exploiting recently proposed innovative SAR acquisition modes (BiDiSAR and SuperSAR). These options are, however, challenging for future SAR systems based on large reflector antennae, due to lack of capability to electronic beam steering or frequent toggle between left- and right-looking modes. Therefore, in this letter, we assess and compare the realistic acquisition scenarios for a reflector-based SAR in an attempt to optimize the achievable 3-D precision. Investigating the squinted SAR geometry as one of the feasible scenarios, we show that a squint of 13.5° will yield comparable performance to the left-looking acquisition, while further squinting outperforms this or other feasible configurations. As an optimum configuration for 3-D retrieval, the squinted acquisition is further elaborated: the different acquisition plans considering a constellation of two satellites as well as the challenges for data processing are addressed.
14 February 2025 in IEEE Transactions on Geoscience and Remote Sensing
Repeat-pass interferometric SAR (InSAR) is widely used for a variety of application scenarios, such as terrain displacement and subsidence monitoring or measuring the state of infrastructures. In this context, the development of effective algorithms to detect temporal and spatial changes in the radar targets becomes of paramount importance. Typically, state-of-the-art methods only return the spatial, temporal, or both locations of the occurred changes without any information about the causes. In this article, we present a novel change detection method able to infer not only whether a target has changed and when but also the reason why a change is detected, defining the concepts of definitive and temporary changes (TCs). This is done by jointly exploiting four radar amplitude images and the corresponding six interferometric coherences computed at different temporal baselines. To this aim, we propose a new deep learning (DL)-based framework based on a fully convolutional neural network (CNN) called deep analysis for nonstable InSAR targets network (DANI-NET). The network design and training strategy are driven by explainable AI (XAI) principles. Here, we rely on the development of fully synthetic training and testing datasets by following a robust statistical derivation, which allows for a full understanding of the network outcomes. We evaluate the DANI-NET performance on an independent synthetic dataset and we compare it to the state-of-the-art permutational change detection (PCD), a nonparametric statistical approach, achieving extremely competitive results. Moreover, we also provide a feature analysis on the prediction explainability using the SHAP method. Finally, we apply DANI-NET to two real-case scenarios, by considering a Sentinel-1 repeat-pass dataset acquired over Iceland during the 2023–2024 Sundhnúkur eruptions and a TanDEM-X multitemporal stack acquired over an open-pit mining site. We validate the method over the Iceland dataset, where we compare the predicted lava field extension with external reference measurements. In both cases, DANI-NET produces high-quality results and adds the possibility of investigating the nature of the changes caused by either natural or man-induced phenomena.
13 September 2025 in ISPRS Journal of Photogrammetry and Remote Sensing