Unmanned aerial vehicle (UAV)-assisted relay mobile edge computing (MEC) network is a prominent concept, where network deployment is flexible and network coverage is wide. In scenarios such as emergency communications and low-cost coverage, optimization of offloading methods and resource utilization are important ways to improve system effectiveness due to limited terminal and UAV energy and hardware equipment. A multilevel edge computing network resource optimization model on the basis of UAV fusion that provides relay forwarding and offload services is established by considering the initial energy state of the UAV, the green energy charging function, and the reliability of computing offload. With normalized system utility function maximization as the goal, a Markov decision process algorithm meets the needs of the practical application scene and provides a flexible and effective unloading mode. This algorithm is adopted to solve the optimal offloading mode and the optimal resource utilization scheme. Simulations verify the effectiveness and reliability of the proposed multilevel offloading model. The proposed model can optimize system resource allocation and effectively improve the utility function and user experience of computing offloading systems.
7 July 2020 in Wireless Communications and Mobile Computing
The mobile fog computing (MFC) network that integrates unmanned aerial vehicles (UAV) fully exerts its advantages of flexible deployment, load balance, and rapid response. Under complex network environment, proposing a reasonable offloading model and according resource optimization of the MFC network is important to satisfy high-requirement offloading standard. In this paper, a multilevel MFC offloading model where UAV and fog nod undertake relay nodes and offloading computing nodes are established for computation-intensive and latency-critical tasks, considering heterogeneous network selection , dynamic channel quality and central cloud access . With the total system utility optimality function including reward function maximization as the goal, the MDP algorithm is applied to solve the best offloading decision of the computing task and the balanced load mode of the MFC network. Finally, the simulation section verifies the excellent performance of the proposed multilevel MFC offloading model in network resource utilization. Simulation results show that the model can optimize the relative position of service nodes in MFC network and ensure the offloading reliability of terminal equipment.
Heterogeneous network, which is a key technology of fifth generation(5G) mobile communication system, can effectively solve the spectrum resource shortage in the communication system. However, with densified deployment of base stations (BSs) and growth of user quantity and communication data size, the system energy consumption of BSs has imposed enormous economic pressure on network operators. As a result, energy consumption decreases and cost of communication system becomes a problem that requires urgent solutions. Renewable energy power generation devices of BSs have provided an opportunity for solving this problem with the development of smart power grids. However, the production rate of renewable energy sources presents intense volatility because of the influence of weather factors. This condition brings new challenges to the energy allocation of communication system. Therefore, an energy sharing link between BSs was established in a heterogeneous wireless network, and the distance between macro-BS and micro-BS was taken as an index. The energy consumption-based energy and user joint allocation method and energy cost-based energy and user joint allocation method were proposed. The two multi-objective optimization problems were converted into two convex optimization problems, and the optimal allocation strategies were solved using convex optimization toolbox. Simulation results indicate that the energy consumption-based allocation method takes energy consumption as the optimization objective and makes the shared link transmit energy sources as few as possible. This way reduces energy consumptions of the link and the system. Starting from the economic angle, the energy cost-based allocation method considers the influence of energy price, coordinates energy allocation between BSs based on energy cost using the shared link, and optimizes energy allocation among BSs at each time slot. Therefore, the method can reduce the energy cost of the system by a large margin.
4 November 2019 in IEEE Internet of Things Journal
Power line and wireless hybrid communication address the problem that wireless and power line cannot communicate with each other in the Internet of Things (IoT). However, the theoretical performance of amplify-and-forward (AF) relay communication based on hybrid fading condition has no closed expression. This article takes a relay system model of wireless and power line hybrid media as a representative and investigates a unified performance analysis method for AF relay systems with hybrid fading. The mixture lognormal (LogN) approximate algorithm based on the moment-generating function (MGF) is applied to approximate a wireless fading coefficient to mixture LogN distribution. Moreover, we propose a joint optimization algorithm for determining the key parameters given that the adjustable variables in the MGF equations evidently affect the approximation accuracy. Importantly, this article is then extended to other fading models, taking general gamma (GG) as an example. The effectiveness and reliability of the algorithm are verified by the Monte Carlo simulation. Finally, closed analytic expressions of the system performance, such as bit error rate (BER), outage probability, and average channel capacity, are derived. The effects of hybrid fading factor, impulse noise parameter, and power allocation on system performance are analyzed using the theoretical formulas.
For low latency communication service of vehicles, it is critical to improve the delay performance of power line communication (PLC) for in-vehicle network, which can decrease the weight and cost of the vehicle. In order to minimize the total time slots used in a transmission task, an orthogonal frequency-division multiplexing (OFDM) subcarrier diversity combination algorithm of PLC based on the deep reinforcement learning (DRL) is proposed herein. The short packet communication theory is used to develop an optimal combination model with constraints on short packet reliability, transmitting power and the amount of data. The state, action, and reward function of double deep Q-learning network (DDQN) are defined, and diversity combination for OFDM subcarriers is performed using DDQN. An adaptive power allocation algorithm based on the thresholds of error rate and the data amount is used. Simulation results show that the proposed algorithm can effectively improve the delay performance of PLC under the constraints of power and data amount.
Wireless and power line communication hybrid networking can complement each other, save construction costs, and satisfy the needs of different services. Few studies have investigated the MAC layer mechanism when the two networks are mixed. This paper proposes an improved CSMA/CA algorithm suitable for power line and wireless hybrid networking scenarios. The algorithm is compatible with the CSMA/CA algorithm in the existing standards, namely, IEEE 1901 and 802.11, and adopts a two-choice method of power line and wireless first idle. As long as one of the wireless and power line channels is in idle state, it can be levied to transmit a data packet. Based on the decoupling hypothesis, this work establishes a system analysis model of the algorithm, uses simultaneous nonlinear equations to calculate the throughput and collision probability performance of the algorithm, and provides a uniqueness analysis of the solution. This work also determines the latency of the algorithm. Finally, simulation verifies the effectiveness and reliability of the algorithm model and analyzes the performance in terms of throughput, time delay, and collision probability. Compared with the existing wireless and power line CSMA/CA algorithm, the proposed algorithm can improve the throughput and ensure the effectiveness of the network.