Due to various ecological problems, it is required to remove the ammonia nitrogen from wastewater. Industrial wastewater that was not subjected to any purification was used in this study, while most processes described in the literature were carried out using synthetically prepared solutions. The study investigated the removal of ammonium ions using ion exchange on various commercial minerals, in 3 h long batch ion-exchange experiments. Furthermore, research on the sodium chloride activation of the selected mineral was conducted. The screening of the mineral with the highest removal potential was conducted taking into account the adsorption capacity (q) and maximal removal efficiency (E), based on the NH₄⁺ ions changes determined using the selective electrode and spectrophotometric cuvette tests. The highest adsorption capacity (q = 4.92 mg/g) of ammonium ions with the maximum removal efficiency (52.3%) was obtained for bentonite, with a 0–0.05 mm particle size. After pretreatment with a 1 mol/L NaCl solution, maximum efficiency increments were observed (55.7%). The Langmuir adsorption isotherm corresponds well with the equilibrium adsorption data (R² from 0.97 to 0.98), while the Freundlich model was found to be mismatched (R² = 0.77). Based on these results it was concluded that natural sorbents may be effectively applied in wastewater treatment. It can be observed that as the size of sorbent particles gets lower, the adsorption capacity, as well as the removal efficiency, gets higher. The bentonite pretreatment with the NaCl solution did not result in the expected efficiency improvement. The 2 mol/L solution affected about 3.5% of the removal efficiency yield.

Anaerobic digestion (AD) is a commonly used method of processing waste. Regardless of the type of the used digestate (fertilizer, feedstock in case of solid-state fermentation, raw-material in case of thermal treatment) effective pathogen risk elimination, even in the case of high pathogen concentration is essential. An investigation of the survival time and inactivation rate of the Salmonella Senftenberg W₇₇₅, Enterococcus spp., and Ascaris suum eggs during thermophilic anaerobic digestion performed on laboratory scale and confirmation of hygienization in full-scale operation were performed in this study. Except for sanitization efficiency, the AD process performance and stability were also verified based on determination of pH value, dry matter content, acidity, alkalinity, and content of fatty acids. The elimination of pathogen was met within 6.06 h, 5.5 h, and about 10 h for the Salmonella Senftenberg W₇₇₅, Enterococcus spp., and Ascaris suum, respectively in the laboratory trials. The obtained results were confirmed in full-scale tests, using 1500 m³ Kompogas^® reactors, operating in MBT Plant located in Poland. Sanitization of the digestate was achieved. Furthermore, the process was stable. The pH value, suspended solids, and ammonium content remained stable at 8.5, 35%, and 3.8 g/kg, respectively. The acetic acid content was noted between almost 0.8 and over 1.1 g/kg, while the concentration of propionic acid was noted at maximum level of about 100 mg/kg. The AD conditions could positively affect the pathogen elimination. Based on these results it can be found that anaerobic digestion under thermophilic conditions results in high sanitation efficiency.

Agriculture affects both the quantity and the quality of water available for other purposes, which becomes problematic, especially during increasingly frequent severe droughts. This requires tapping into the resources that are typically neglected. One such resource is a by-product of anaerobic digestion, in which moisture content typically exceeds 90%. Application of hydrothermal carbonization process (HTC) to this residue could partially remove organic and inorganic material, improve dewatering, decrease the overall solid mass, sanitize the digestate, change its properties, and eliminate problems related with emissions of odors from the installation. However, a significant gap still exists in terms of the dewatering of the hydrochars and the composition of the effluents. This work presents results of experimental investigation focused on the removal of organic compounds from the HTC effluent. Results of qualitative and quantitative analysis of liquid by-products of HTC of the agricultural digestate showed that acetic acid, 3-pyridinol, 1-hydroxyacetone, and 1,3-propanediol were the main liquid organic products of the process. Application of ultrafiltration process with the use of 10 kDa membrane for liquid HTC by-product treatment allows for the reduction of chemical oxygen demand up to 30%, biological oxygen demand up to 10%, and dissolved organic carbon up to 21%.

The replacement of fossil fuel with renewable energy sources seems as though it will be crucial in the future. On the other hand, waste generation increases year by year. Thus, waste-to-energy technologies fit in with the actual trends, such as the circular economy. The crucial type of generated waste is municipal solid waste, which is in the research area. Regarding the organic fraction of municipal solid waste (OFMSW), anaerobic digestion (AD) allows the recovery of biogas and energy. Furthermore, if it is supported by source segregation, it should allow the recovery of material as fertilizer. The AD process performance (biogas yield and stability) comparison of source-segregated OFMSW (ss-OFMWS) and mechanically sorted OFMSW (ms-OFMSW) as feedstocks was performed in full-scale conditions. The daily biogas volume and methane content were measured to assess AD efficiency. To verify the process stability, the volatile fatty acid (VFA) content, pH value, acidity, alkalinity, and dry matter were determined. The obtained biogas yield per ton was slightly higher in the case of ss-OFMSW (111.1 m³/ton), compared to ms-OFMSW (105.3 m³/ton), together with a higher methane concentration: 58–60% and 51–53%, respectively, and followed by a higher electricity production capacity of almost 700 MWh for ss-OFMSW digestion. The obtained VFA concentrations, at levels around 1.1 g/kg, pH values (slightly above 8.0), acidity, and alkalinity indicate the possibilities of the digester feeding and no-risk exploitation of either as feedstock.

This study investigated the applied methods for the collection and treatment of an organic fraction of municipal solid waste with anaerobic digestion (AD), including the effects of selective waste collection system introduction. As the research area, data from a waste treatment plant, which collects waste from about 260,000 inhabitants, was used as the selected waste management plan. Biowaste stream management was emphasized. Thus, research on energy recovery and the characteristics of digestate (nutrient and heavy metals content) obtained from biowaste AD was performed. The results of the studies and their quantitative data were interpreted. A significant discrepancy between the assumptions and the actual situation was revealed (up to 20% year-on-year regarding biowaste). An underestimation of the amount of waste when planning was noted. AD ensures energy recovery from biowaste, which can cover facility electricity needs and material recovery. The digestate might find agricultural usage and become an ecological product. The content of nitrogen (1.5%_{dry matter}), phosphorus (0.55%_{dry matter}), potassium (1.0%_{dry matter}), and organic carbon (16.0%_{dry matter}) indicate a positive impact on crops. Furthermore, it can improve the economic balance, by replacing costs with sales revenues.

Purpose: This study aimed to examine the possibilities of the treatment of the by-products generated in the anaerobic digestion (AD) of the organic fraction of municipal solid waste (OFMSW): oxygen stabilization (composting) of the solid digestate and pretreatment with air stripping of the effluents (liquid digestate and leachate from maturation field and reactors from composting). Methods: Oxygen stabilization (OS) was performed in full-scale in a mechanical–biological treatment (MBT) plant using three different methods, using an open field or enclosed box reactor with aeration. The ammonia stripping was performed in a pilot-scale installation using effluents from AD (liquid digestate) and OS (leachate from maturation field and reactors). Results: The lowest self-heating possibility after the OS was recorded at 28.5 °C, which proves that the most stabilized was the sample after processing with structuring material addition. Due to air stripping, the highest efficiency of ammonium ions removal was noted at the level of 50.6%, with an initial pH value of 10.5, after 12 h. Among the examined factors pH value was found to be significant [the determination coefficient (R²) of 0.93]. Conclusions: The oxygen stabilization of the digestate requires the structuring material addition before being placed in the reactor with aeration. The inert fraction from the ballistic separation of the OFMSW can be an interesting solution, as required structuring material. Air stripping as the effluents pre-treatment step can meet the MBT plants expectations. Graphic