This paper presents a Ku-band monolithic multifunction transmitter and receiver chipset fabricated in 0.25-μm GaAs pseudomorphic high-electron mobility transistor technology. The chipset achieves a high level of integration, including a 4-bit 360° digital phase shifter, 5-bit 15.5-dB digital attenuator, amplifier and 9-bit digital serial-to-parallel converter for digital circuit control. Since the multifunction chipset includes a medium power amplifier and a low-noise amplifier, it features high P1dB and low noise figures over the full Ku-band frequencies. The multifunction transmitter shows a peak gain of 16.5 dB with output P1dB of 19.2 dBm at 15 GHz. The multifunction receiver shows a peak gain of 17.3 dB with noise figure of 2.5 dB at 15 GHz. The attenuation range is 15.5 dB with a step of 0.5 dB and the phase shift range is 360° with a step of 22.5°. Each chip area of the transmitter and receiver is 4.2 × 2.8 mm2.
This paper presents a CMOS W-band amplifier adopting a novel neutralization technique for high gain and stability. The W-band amplifier consists of four common-source differential gain cells that are neutralized by a cross-coupled MOS–varactor pair. Contrary to conventional neutralizations, the proposed technique enables tunable neutralization, so that the gate-to-drain capacitance of transistors is accurately tracked and neutralized as the varactor voltage is adjusted. This makes the neutralization tolerant of capacitance change caused by process–voltage–temperature (PVT) variation or transistor model inaccuracy, which commonly occurs at mm-wave frequencies. The proposed tunable neutralization is experimentally confirmed by measuring gain and stability of the W-band amplifier fabricated in a 65-nm CMOS process. The amplifier achieves a measured gain of 17.5 dB at 79 GHz and a 3-dB bandwidth from 77.5 to 84 GHz without any stability issue. The DC power consumption is 56.7 mW and the chip area is 0.85 mm2.
30 April 2019 in Journal of Electromagnetic Engineering and Science
A compact wideband crossover coupler with fully lumped elements is presented. To achieve a wideband operation, a three-section branch-line structure is employed for the crossover coupler. The size is significantly minimized by replacing transmission lines with lumped elements. The measurement shows that the insertion loss, isolation, and return loss are 1.7 dB, 24 dB, and 14.5 dB, respectively, at 2 GHz. The fractional bandwidth of 20-dB isolation and 3-dB insertion loss is 27%. The size of the crossover coupler is 11 mm × 9 mm, which corresponds to 0.07λ × 0.06λ at 2 GHz. This is significantly smaller than a conventional three-section branch-line crossover coupler by 95%.
21 October 2019 in IEEE Microwave and Wireless Components Letters
This letter presents an injection-locked frequency octupler (ILFO) fabricated using a 100-nm GaAs pHEMT. A frequency quadrupler, followed by an injection-locked push-push oscillator, is employed to achieve a high multiplication factor of eight with a simple structure. Compared to conventional amplifier-multiplier chains, the proposed structure is advantageous for dc power and chip area consumption, phase noise, and circuit stability. The high multiplication factor allows the use of a low-frequency, high-performance, phase-locked-loop (PLL) as input. The ILFO achieves a locking range from 90.5 to 95.2 with 1-dBm input power. The output power is measured to be -0.4 dBm at 91.2 GHz. The phase-noise degradation from the input source to the output is 19.7 dB at 100-kHz offset.