Longitudinal critically refracted (L_CR) waves are considered bulk longitudinal waves and penetrate into an effective depth beneath the surface parallel to the material surface. Such L_CR waves can be employed to measure residual stresses because the acoustoelastic effect is the basis for ultrasonic residual stress measurements. This effect is described by the relationship between change of wave travel time and stress applied when such waves propagate in a stressed medium. In this paper, stresses applied in a rail were evaluated by using a developed L_CR probe. With this transducer, it was verified how the difference in the arrival times of the L_CR waves showed a trend as the tensile stresses increased. The acoustoelastic coefficients were calculated using the relationship between the stresses and the travel times, and the residual stresses of the used rails were measured using these coefficients. In addition, the difference in residual stress distribution according to the characteristics of the wheel-rail contact surface was analyzed from the obtained residual stress value. It was concluded that this non-destructive evaluation technique using L_CR waves could be employed for accurate stress measurement of rails because differences in stress applied to the rail can be detected.

Residual stress, a factor affecting the fatigue and fracture characteristics of rails, is formed during the processes of fabrication and heat treatment, and is also generated by vertical loads on wheels due to the weight of vehicles. Moreover, damage to rails tends to accelerate due to the continuous increase in the number of passes and to the high speed of passing vehicles. Because this can have a direct effect on safety accidents, having a technique to evaluate and analyze the residual stresses in rails accurately is very important. In this study, stresses due to tensile loads applied to new rails and residual stresses remaining in used rails were measured by using magnetic Barkhausen noise method. First, a magnetization frequency and noise band suitable for the rails were selected. Moreover, by applying tensile loads to specimens and comparing the difference in magnetization amplitudes for each load, the stresses applied to the rails by using the magnetic Barkhausen noise method were measured, and the analysis of the results was verified. Based on these results, the difference in the results for the loads asymmetrically applied according to the wheel shape was analyzed by measuring for the head parts of used rails.