Ni Tianming

Dr. Ni Tianming


Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 June 2020 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
Verified
Journal Article
Closed access
NTNi Tianming
Ni Tianming
DLDongsheng Liu
Dongsheng Liu
QXQi Xu
Qi Xu
ZHZhengfeng Huang
Zhengfeng Huang
HLHuaguo Liang
Huaguo Liang
Yan AibinYan Aibin
Yan Aibin
In this brief, a cobweb-based redundant through-silicon-via (TSV) design is proposed with efficient hardware as well as high repair rate to repair clustered faulty TSVs (FTSVs). The experimental simulation results demonstrate that for highly clustered faults, the repair rate of the proposed RTSV method is 48.59% and 1.75% higher than that of the ring-based and router-based RTSV methods, respectively. Furthermore, the proposed design can achieve 63.93% and 16.34% hardware reductions compared with the router-based and the ring-based design, respectively.

22 September 2020 in IEEE Transactions on Emerging Topics in Computing
Verified
Journal Article
Closed access
Yan AibinYan Aibin
Yan Aibin
ZXZhelong Xu
Zhelong Xu
XFXiangfeng Feng
Xiangfeng Feng
Jie CuiJie Cui
Jie Cui
ZCZhili Chen
Zhili Chen
XWXiaoqing Wen
Xiaoqing Wen
With the rapid advancement of CMOS technologies, nano-scale CMOS latches have become increasingly sensitive to multiple-node upset (MNU) errors caused by radiations. First, this paper proposes a novel latch design, namely QNUTL that can completely tolerate MNUs such as double-node upsets, triple-node upsets (TNUs), and even quadruple-node upsets (QNUs). The latch is mainly constructed from three dual-interlocked-storage-cells (DICEs) and a triple-level soft-error interceptive module (SIM) that consists of six 2-input C-elements. Due to the single-node-upset self-recoverability of DICEs and the soft-error interception of the SIM, the latch can completely tolerate any QNU. Next, by replacing the DICEs in the QNUTL latch by clock-gating (CG) based ones, a QNUTL-CG latch is proposed to significantly reduce power consumption. Simulation results demonstrate the MNU-tolerance of the proposed latches. Moreover, owing to the use of a high-speed transmission path, clock-gating, and a few transistors, the proposed QNUTL-CG latch has low overhead in terms of area, D-Q delay, CLK-Q delay, and setup time, compared with the state-of-the-art TNU-tolerant latch (TNUTL) which is not QNU-tolerant.

8 October 2019 in IEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems
Verified
Journal Article
Closed access
NTNi Tianming
Ni Tianming
YYYao Yao
Yao Yao
HCHao Chang
Hao Chang
LLLin Lu
Lin Lu
HLHuaguo Liang
Huaguo Liang
XWXiaoqing Wen
Xiaoqing Wen
Due to the winding level of the thinned wafers and the surface roughness of silicon dies, the quality of through-silicon vias (TSVs) varies during the fabrication and bonding process. If one TSV exhibits a defect during its manufacturing process, the probability of multiple defects occurring in the TSVs neighboring the faulty TSV increases, i.e., the TSV defects tend to be clustered, which significantly reduces the yield of 3-D integrated circuit. To resolve the clustered TSV faults, router-based, ring-based, group-based, and cellular-based redundant TSV (RTSV) architectures were proposed. However, the repair rate is low and the hardware overhead as well as delay overhead is high. In this article, we propose a honeycomb-based RTSV architecture to utilize the area and delay more efficiently as well as to maintain high yield. The simulation results show that the proposed architecture has a 99.84% repair rate for uniform faults and an 81.42% repair rate for highly clustered faults. The proposed design achieves a 51.66% reduction of hardware overhead compared with the router-based design and a 20.69%, 46.93%, 34.17%, and 11.15% reduction of total delay compared with ring-based, router-based, group-based, and cellular-based methods, respectively.

28 August 2020 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
Yan AibinYan Aibin
Yan Aibin
YCYan Chen
Yan Chen
YHYuanjie Hu
Yuanjie Hu
JZJun Zhou
Jun Zhou
NTNi Tianming
Ni Tianming
XWXiaoqing Wen
Xiaoqing Wen
The continuous advancement of CMOS technologies makes SRAMs more and more sensitive to soft errors. This paper presents two novel radiation-hardened SRAM cell designs, namely S4P8N and S8P4N, with enhanced self-recoverability from single-node upsets (SNUs) and Double-node upsets (DNUs). First, the S4P8N cell that has more redundant nodes and more access transistors is proposed. The cell has the following advantages: (1) it can self-recover from all possible SNUs; (2) it can self-recover from a part of DNUs; (3) it has small overhead in terms of power dissipation. Then, to reduce read and write access time, the S8P4N cell that uses a special feedback mechanism among its internal nodes is proposed. The cell has similar soft error tolerability as the S4P8N cell. Simulation results validate the high robustness of the proposed SRAM cells. These results also show that the write access time, read access time, and power dissipation of the S8P4N cell are reduced approximately by 29%, 20%, and 21% on average, at the cost of moderate silicon area, when compared with the state-of-the-art radiation-hardened SRAM cells.

16 May 2022 in IEEE Transactions on Device and Materials Reliability
Verified
Journal Article
Closed access
Yan AibinYan Aibin
Yan Aibin
JXJing Xiang
Jing Xiang
ACAoran Cao
Aoran Cao
ZHZhihui He
Zhihui He
Jie CuiJie Cui
Jie Cui
PGPatrick Girard
Patrick Girard
Aggressive technology scaling makes modern advanced SRAMs more and more vulnerable to soft errors such as single-node upsets (SNUs) and double-node upsets (DNUs). This paper proposes two SRAM cells; the first one is called Quadruple Cross-Coupled SRAM (QCCS) and the second one is called Sextuple Cross-Coupled SRAM (SCCS). The QCCS cell comprises four cross-coupled input-split inverters to keep stored values, and provides self-recoverability from SNUs at low cost. To improve reliability, the SCCS cell uses six cross-coupled input-split inverters to construct a large error-interceptive feedback loop and hence robustly keep stored values. The SCCS cell can self-recover from all possible SNUs and one part of DNUs; for remaining DNUs, a node-separation mechanism is used to avoid their occurrence. Simulation results demonstrate the robustness of the proposed cells. Moreover, compared with the state-of-the-art hardened cells, i.e., NASA13T, RHBD12T, We-Quatro, Zhang14T, QUCCE12T, DNUSRM, QCCM10T, QCCM12T, S4P8N, and S8P4N, the QCCS cell reduces read access time by 17%, write access time by 19%, power dissipation by 4% and silicon area overhead by 10% on average, while the SCCS cell reduces read access time by 44% as well as write access time by 13% on average at the cost of moderate increase in power dissipation and silicon area overhead.

25 September 2023 in IEEE Transactions on Emerging Topics in Computing
Verified
Journal Article
Closed access
Yan AibinYan Aibin
Yan Aibin
ACAoran Cao
Aoran Cao
ZHZhengfeng Huang
Zhengfeng Huang
Jie CuiJie Cui
Jie Cui
NTNi Tianming
Ni Tianming
JZJiliang Zhang
Jiliang Zhang
The continuous advancement of complementary metal-oxide-semiconductor technologies makes flip-flops (FFs) vulnerable to soft errors. Single-node upsets (SNUs), as well as double-node upsets (DNUs), are typical soft errors. This paper proposes two radiation-hardened FF designs, namely DNU-tolerant FF (DUT-FF) and DNU-recoverable FF (DUR-FF). First, the DUT-FF which mainly consists of four dual-interlocked-storage-cells (DICEs) and three 2-input C-elements, is proposed. Then, to provide complete self-recovery from DNUs, the DUR-FF which mainly uses six interlocked DICEs is proposed. They have the following advantages: (1) They can completely protect against SNUs as well as DNUs; (2) the DUT-FF is cost-effective but the DUR-FF can provide complete self-recovery from any DNU. Simulations show the complete SNU/DNU tolerance of DUT-FF and the complete SNU/DNU self-recovery of DUR-FF but at the cost of indispensable area overhead when compared to the SNU hardened FFs. Besides, compared to the FFs of the same-type, the proposed FFs achieve a low delay making them suitable for high-performance applications.