Complex interaction mechanism exists between the pile group and soil. To realize the pile‐soil load transmission mechanism in detail, the failure pattern of pile groups installed in dense sand considering different pile spacing was investigated by means of laboratory experimental model test and three‐dimensional discrete element method. The results suggested that the narrow pile spacing was beneficial to the development of the pile tip resistance, and it enhanced the bearing performance of the pile group at the initial stage of settlement. The pile spacing changed the shaft resistance pattern with modification of the strain energy mechanism released within the subsoil. The pile group with 6b pile spacing had higher composite group efficiency. A joint fan‐shaped displacement zone was formed beneath the pile tip for the pile group with 3b pile spacing; this pile foundation presented the block failure mechanism. The sand displacement beneath the cap for the pile group with 6b pile spacing mainly located on the upper part of the piles, the sand displacement around both sides of the piles presented asymmetric, and a relatively independent fan‐shaped displacement zone was formed beneath the pile tip.

When the mountain tunnel projects passing through the complex formation with coal, it happened along with disaster accidents such as gas outburst, gas combustion, and gas explosion. These disasters should seriously threaten the safety and life of the construction personnel and affect the normal operation of the tunnel construction. Ventilation is the most effective means to control gas, fire, dust, heat, and other disasters. To study the effects of different ventilation modes in highway gas tunnels, Fluent software was used to simulate forced ventilation, exhaust ventilation, and mixed ventilation in a high gas tunnel of a highway in Hunan. The distribution law of the airflow velocity and gas concentration of these three ventilation modes were obtained to determine the optimal ventilation system. It was shown that vortex zones of different ranges formed in the tunnel for all three ventilation modes, and the gas concentration was higher in the vortex zone than in other regions. Mixed ventilation of them is superior to the other two modes, showing the best ventilation effect with regard to airflow velocity and gas concentration.

As urbanization gathers pace, projects involving adjacent subway tunnels are increasing, thereby amplifying the need for robust tunnel protection measures. Currently, there exists a notable lack of precise analyses on the three‐dimensional (3D) deformation laws and mechanisms of tunnels affected by adjacent deep excavation. Moreover, the influence patterns of retaining wall stiffness and deep excavation depth on the 3D deformation of pit‐side tunnels remain unclear. The purpose of this research is to bridge the existing disparity by adopting the hypoplastic model, which effectively captures soil stiffness that is dependent on soil state, strain, and stress path, even at small strains, as well as soil strength, based on reported centrifuge model tests. This approach facilitates a comprehensive, precise numerical analysis of the interaction between deep excavation and preexisting tunnels located outside the retaining wall. The analysis sheds light on the deformation mechanisms and trends of pit‐side tunnels not solely confined to the longitudinal axis but extending to the transverse plane as well, while systematically examining the influence of varying excavation depths and retaining wall stiffness on key tunnel parameters, including longitudinal deformation, diameter changes, bending strains, and soil pressure distributions around the tunnels. The study reveals that if the tunnel situated outside the retaining structure lies beneath the foundation pit’s base, deep excavation only slightly deforms the tunnel. However, when the tunnel outside the retaining structure is positioned above the pit’s base, its deformation progressively intensifies with deeper excavation, but the growth rate has a decreasing trend. An enhancement in the stiffness of the retaining wall results in a notable decrease in the deformation exhibited by the adjacent tunnels. The findings contribute to a deeper understanding of the complex responses of pit‐side tunnels to excavation activities, ultimately facilitating the design and construction of safer and more resilient urban subway infrastructure.