This work evaluates the behavior of a martensitic stainless steel (AISI 410) thermally treated by quenching and tempering with a tungsten carbide (86WC-10Co-4Cr) coating obtained by high-velocity oxygen fuel (HVOF) thermal spray deposition, analyzing the volume loss under erosive attacks at 30 and 90 incidence angles by using jet slurry erosion equipment with electrofused alumina erodent particles. Firstly, the characterization of the samples was carried out in terms of the microstructure (SEM), thickness, roughness, porosity, and microhardness. Then, samples were structurally characterized in the identification of the phases (XRD and EDS) present in the coating, as well as the particle size distribution (LG) and morphology of the erodent. It was determined that the tungsten carbide coating presented better resistance to jet slurry erosion wear when compared to the martensitic stainless steel analyzed, which is approximately two times higher for the 30 angle. The more ductile and brittle natures of the substrate and the coating, respectively, were evidenced by their higher volumetric erosion at 30 for the first and 90 for the latter, as well as their particular material removal mechanisms. The enhanced resistance of the coating is mainly attributed to its low porosity and high WC-Co content, resulting in elevated mechanical resistance.
In this study, compositions containing green glass bottles and desiccated and crushed yerba mate (Ilex paraguarinensis) of different mass fractions (10-30%) were prepared to obtain glass foams for thermal insulation purposes. These compositions were uniaxially pressed (at 40 MPa), and the compact powders were fired at 850°C and 900°C for 60 min in order to investigate the effect of yerba mate and temperature on the formation of pores and the thermal and mechanical properties of the processed glass foams. The results indicated that the glass foams displayed porosities ranging from 65.3-88.3%, compressive strengths ranging from 15-1.5 MPa, and thermal conductivities ranging from 0.6-0.04 W·m-1·K-1. Cumulatively, these glass foams are candidate thermal insulators that have advantageous properties for various industrial applications.
1 October 2019 in IOP Conference Series: Materials Science and Engineering
Due to their enhanced tribological properties that contribute to an increased useful life of components, martensitic stainless steels are an excellent option for industrial applications such as hydroelectric, petrochemical, civil construction and mineral processing plants. In the present investigation, the erosive wear of AISI 410 martensitic stainless steel is evaluated after thermal treatment by quenching and tempering by mass loss, under erosive attack at 30° and 90° incidence angles, using a self-made jet slurry erosion equipment controlling parameters such as speed, volume of fluid, temperature and concentration of erosive particles of erodent. The characterization of the eroded samples was carried out in terms of the microstructure (SEM) and microhardness as well as the particle size distribution (LG) and morphology of the erodent. It was possible to establish the relationship between the slurry erosive wear and the physical properties inherent of stainless steel for this particular experimental configuration, concluding that the steel presents better resistance to jet slurry erosion wear when compared to austenitic steel commonly used in the industry.