Mohsen Hasan Babayi Nozadian

Dr. Mohsen Hasan Babayi Nozadian

orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 March 2017 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
MNMohsen Hasan Babayi Nozadian
Mohsen Hasan Babayi Nozadian
EBEbrahim Babaei
Ebrahim Babaei
SHSeyed Hossein Hosseini
Seyed Hossein Hosseini
EAElias Shokati Asl
Elias Shokati Asl
In this paper, a new topology for Z-source inverter based on switched Z-source network is proposed. The proposed switched Z-source inverter can provide high voltage gain in low duty cycles. The continuous input current is one of the other advantages of the proposed inverter. The performance of the proposed inverter is investigated in different operating modes and the voltage and current equations of all elements and equations of critical inductance are calculated. Furthermore, the power losses and efficiency analyses are presented. The comprehensive comparison between the proposed inverter and the other conventional Z-source inverters shows its excellent performance. Finally, to prove the correct operation of the proposed topology, the experimental and simulation results using PSCAD/EMTDC software are presented.

3 February 2016 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
EBEbrahim Babaei
Ebrahim Babaei
EAElias Shokati Asl
Elias Shokati Asl
MNMohsen Hasan Babayi Nozadian
Mohsen Hasan Babayi Nozadian
In this paper, a new topology for half-bridge switched boost inverter (HB-SBI) is proposed. The proposed half-bridge inverter uses more active elements rather than capacitors and inductors in comparison with the conventional half-bridge Z-source inverter with two Z-networks, which results in reduction of weight, size, and cost. Moreover, the proposed inverter has the capability of eliminating inverter leg short-circuit issues and is able to further increase the output voltage level in comparison with its conventional types. Generating zero-level output voltage is also another advantage of this topology. Based on theoretical calculations, the steady-state and small-signal analysis of the proposed topology in different operating modes are performed and the ripple of inductors' current and capacitors' voltage are also calculated. A comprehensive comparison is also made between the proposed inverter and the conventional types. Finally, the experimental results are provided to reconfirm the performance of the proposed inverter.

13 September 2017 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
EAElias Shokati Asl
Elias Shokati Asl
EBEbrahim Babaei
Ebrahim Babaei
MSMehran Sabahi
Mehran Sabahi
MNMohsen Hasan Babayi Nozadian
Mohsen Hasan Babayi Nozadian
CCCarlo Cecati
Carlo Cecati
In this paper, new half-bridge and full-bridge topologies for a switched-boost inverter are proposed. These topologies have a high boost factor in comparison with conventional types. In addition, the proposed topologies have continuous input current and can generate zero-voltage level in output. In this paper, the operation of the proposed inverters in different operating modes is analyzed. Then, the values of inductors and capacitors are designed. Moreover, the used switching pattern and its logical diagram are introduced. A comprehensive comparison between the proposed and conventional topologies in terms of the boost factor, the number of elements, and the efficiency shows the good features of the proposed inverters. Finally, to verify correct operation of the proposed topologies and derived equations, simulation and experimental results are presented.

12 June 2019 in IET Power Electronics
Verified
Journal Article
Closed access
MNMohsen Hasan Babayi Nozadian
Mohsen Hasan Babayi Nozadian
EBEbrahim Babaei
Ebrahim Babaei
SHSeyed Hossein Hosseini
Seyed Hossein Hosseini
EAElias Shokati Asl
Elias Shokati Asl
This study reviews and categorises different structures of switched Z‐source networks. Generally, these structures are divided into two groups of basic switched Z‐source networks and switched Z‐source networks with the capability of high boost. Each of these groups is divided into several subgroups and different structures are introduced. For each subsection, the general power circuit is proposed and the extraction method from general power circuit for each structure is obtained. This study also provides a complete analysis of structures by using a conventional control method with two shoot‐through and non‐shoot‐through modes. Small signal analysis for structures with a basic switched Z‐source network is conducted and the general signal flow graph is extracted. A comprehensive analysis of all structures with a switched Z‐source network is done and the tree diagram for the division of these structures is provided. Finally, different industrial applications and outlook of Z‐source networks are introduced.

26 May 2019 in Energies
Verified
Journal Article
Open access
PDF file
GAGOLAMALI ALIZADEH
GOLAMALI ALIZADEH
Tohid RahimiTohid Rahimi
Tohid Rahimi
MNMohsen Hasan Babayi Nozadian
Mohsen Hasan Babayi Nozadian
Sanjeevikumar PadmanabanSanjeevikumar Padmanaban
Sanjeevikumar Padmanaban
Zbigniew LeonowiczZbigniew Leonowicz
Zbigniew Leonowicz
Frequency stability is an important issue for the operation of islanded microgrids. Since the upstream grid does not support the islanded microgrids, the power control and frequency regulation encounter serious problems. By increasing the penetration of the renewable energy sources in microgrids, optimizing the parameters of the load frequency controller plays a great role in frequency stability, which is currently being investigated by researchers. The status of loads and generation sources are received by the control center of a microgrid via a communication system and the control center can regulate the output power of renewable energy sources and/or power storage devices. An inherent delay in the communication system or other parts like sensors sampling rates may lead microgrids to have unstable operation states. Reducing the delay in the communication system, as one of the main delay origins, can play an important role in improving fluctuation mitigation, which on the other hand increases the cost of communication system operation. In addition, application of ultra-capacitor banks, as a virtual inertial tool, can be considered as an effective solution to damp frequency oscillations. However, when the ultra-capacitor size is increased, the virtual inertia also increases, which in turn increases the costs. Therefore, it is essential to use a suitable optimization algorithm to determine the optimum parameters. In this paper, the communication system delay and ultra-capacitor size along with the parameters of the secondary controller are obtained by using a Non-dominated Sorting Genetic Algorithm II (NSGA-II) algorithm as well as by considering the costs. To cover frequency oscillations and the cost of microgrid operation, two fitness functions are defined. The frequency oscillations of the case study are investigated considering the stochastic behavior of the load and the output of the renewable energy sources.

1 January 2025 in IET Power Electronics
Verified
Journal Article
Open access
MNMohsen Hasan Babayi Nozadian
Mohsen Hasan Babayi Nozadian
DVDmitri Vinnikov
Dmitri Vinnikov
HMHamed Mashinchi Maheri
Hamed Mashinchi Maheri
This paper investigates the impact of parasitic elements on the performance of switched impedance inverters. This work develops a non‐ideal impedance source inverter model, enabling more accurate predictions of voltage gain, current relationships, and overall converter behaviour under practical operating conditions. By quantifying the influence of parasitic components on key parameters such as voltage, current, and component selection, this research provides valuable insights for optimising the design of switched impedance inverters. Furthermore, the reliability modelling highlights the sensitive elements in the operation of the inverter. The analysis examines power transfer characteristics within the inverter bridge, considering both zero and non‐zero states, and investigates the impact of switching frequency, output frequency, and duty cycle on the DC‐link current. Experimental results validate the findings, demonstrating the practical significance of considering parasitic elements in the design and optimisation of switched impedance inverters. By improving the accuracy of theoretical predictions, this research contributes to reducing experimental iterations, minimising costs, and mitigating the risk of encountering unforeseen issues during the development and implementation of these converters.