The heat input into the material during welding significantly affects the properties of high-strength steels in the near-weld zone. A zone of hardness decrease forms, which is called the soft zone. The width of the soft zone also depends on the cooling time t8/5. An investigation of the influence of welding parameters on the resulting properties of welded joints can be performed by thermal physical simulation. In this study, the effect of the cooling rate on the mechanical properties of the heat-affected zone of the steel S960MC with a thickness of 3 mm was investigated. Thermal physical simulation was performed on a Gleeble 3500. Three levels of cooling time were used, which were determined from the reference temperature cycle obtained by metal active gas welding (MAG). A tensile test, hardness measurement, impact test with fracture surface evaluation, and microstructural evaluation were performed to investigate the modified specimen thickness. The shortest time t8/5 = 7 s did not provide tensile and yield strength at the minimum required value. The absorbed energy after recalculation to the standard sample size of 10 × 10 mm was above the 27 J limit at −40 °C. The hardness profile also depended on the cooling rate and always had a softening zone.
1 January 2020 in Zavarivanje i zavarene konstrukcije
The TMCP (thermo-mechanically controlled processed) steels belong to the group of ultra-high strength steels, which exhibit exceptional combination of high tensile and yield strength, toughness and ductility. These steels were introduced in the heavy machinery constructions, such as heavy mobile cranes, chassis trucks and other to reduce their weight, what increases their loading capacity and ecology of transport. The high tensile and yield strength of this type of steels is obtained by the combination of the chemical composition, heat treatment and the mechanical processing. However, the heat input into the material during the welding significantly affect properties of the steel and the whole joint. In this paper are presented results of mechanical properties evaluation and structural analysis of the welds of the thin sheets made of the S960MC steel, which were welded using the GMAW procedure. The microstructural evaluation referred significant changes in the HAZ. This area contains the three sub-zones, coarse grain (CGHAZ), fine grain (FGHAZ) and intercritical zone (ICHAZ). Analysis of microhardness and the tensile tests results showed, that ICHAZ is the most critical area of the whole welded joint.