In this paper, a non-Fourier heat conduction model of ultra-short pulsed laser ablation of metal is established that takes into account the effect of the heat source, laser heating of the target, the evaporation and phase explosion of target material, the formation and expansion of the plasma plume, and interaction of the plasma plume with the incoming laser. Temperature dependent optical and thermophysical properties are also considered in the model due to the properties of the target will change over a wide range during the ultra-short pulsed laser ablation process. The results show that the plasma shielding has a great influence on the process of ultra-short pulsed laser ablation, especially at higher laser fluence. The non-Fourier effect has a great influence on the temperature characteristics and ablation depth of the target. The ultra-short pulsed laser ablation can effectively reduce the heat affected zone compared to nanosecond pulsed laser ablation. The comparison between the simulation results and the experimental results in the literature shows that the model with the plasma shielding and the non-Fourier effect can simulate the ultra-short pulsed laser ablation process better.
To study the plasma plume expansion dynamics of nanosecond laser ablating Al/PTFE, the Al/PTFE propellant was prepared by a molding sintering method and the rapid expansion process of the plasma plume was photographed using fast photography technology. The effects of the proportion of Al, laser energy and ambient pressure on plasma plume expansion dynamics are analyzed. The results show that the plume expansion process of laser ablating Al/PTFE plasma can be divided into three stages and this phenomenon has not been reported in the literature. The Al powder doped in PTFE will block part of the laser transmission into the propellant, thus reducing the laser absorption depth of the propellant. In the case of short pulse laser ablation, the reaction rate between Al and PTFE is optimal when the reductant is slightly higher than the oxidant. As the laser energy increases, the light intensity of the plasma becomes stronger, the plasma size becomes larger and the existence time of plasma becomes longer. In the first stage plume, the plume expands freely at the ambient pressure of 0.005 Pa and the plume expansion distance is linearly related to time, while the shock wave formed at the interface between the plume front and the ambient gas at the ambient pressure of 5 Pa and the expansion can be described by S-T theory.
Atmosphere-breathing electric propulsion (ABEP) systems capture atmospheric particles for use as propellant. In the best-case scenario, such systems can undertake long-life space missions without carrying propellant from the ground. The present research mainly focuses on plasma discharge processes based on inductively coupled plasma generation from atmospheric particles in very low Earth orbit (120–250 km). The optical diagnosis is done when the N2 and O2 mixture is injected into the low-pressure discharge chamber. Numerous active groups can be identified from the emission spectra, including excited molecules, molecular ions, atoms, and excited atoms. The generation mechanism of active groups is also clarified to understand the ionization process. The variations of plasma parameters are analyzed for different ratios of N2 to O2, which can also be expanded to describe the potential behavior of ABEP systems in low Earth orbit. Note that this research is only a preliminary study and is not fully representative of the potential of ABEP systems. However, to develop ABEP systems, it is essential to understand the plasma behavior of discharge systems.
Ablative pulsed plasma thrusters (APPTs) are considered as an attractive propulsion option for station-keeping and drag makeup purposes for mass- and power-limited satellites. In order to understand the physical mechanism of APPTs, high-speed camera and optical emission spectroscopy are utilized to investigate the plasma characteristics including the spatial distribution and composition between the electrodes. The plume images and spectra at different times and positions are experimentally recorded, and the spatial distribution, composition, and trajectory of plasmas can be concluded through analyzing them. With the increase of the distance from the ablation surface, two clusters of plasmas near the anode and cathode meet downstream, and the species and density of plasmas tend to be uniform.
A new, to the best of our knowledge, thrust measurement system based on the photoelasticity theory has been developed to infer the thrust from the stress of the cantilever beam. In this method, the cantilever beam is employed as the loading element to convert the low thrust into high stress, and the modified dynamic photoelasticity is used to infer the stress value of the cantilever beam from the Stokes parameters of the emergent light. The experimental results validated that the thrust stand could measure the thrust in the range of millinewton or millisecond, and the thickness of the beam was negatively correlated with the measurement accuracy. The average errors of the experimental measurements for ampere forces were higher than 25 mN and the pulse ampere forces whose widths were longer than 45 ms were less than ${\pm 5}\% .$ As for the real plasma discharges, the errors of the measured thrust were less than ${\pm 10}\% $.
In order to clarify the discharge principle of the self-field magnetoplasmadynamic thruster (MPDT), a two-dimensional axisymmetric particle-in-cell/Monte Carlo collision (PIC/MCC) model is proposed. The spatial distribution and the collision characteristics of discharge plasma were calculated using this model. In addition, the influence of the operation parameters on the plasma was analyzed including the voltage and mass flow rate. The effectiveness of the model was verified by comparison to the experimentally induced magnetic field. It was found that the electrons were mainly accelerated by the electric field in the cathode sheath and the electric field shielding effect of plasma was obvious in the bulk plasma region. Due to the pinch effect, the charged particles were constrained near the cathode. The results of the present work implied that the PIC/MCC model provides an approach to investigate the plasma distribution and a kinetic description of particles for the discharge of the self-field MPDT.