The data validity of safe driving in the Internet of Vehicles (IoV) is the basis of improving the safety of vehicles. Different from a traditional information systems, the data anomaly analysis of vehicle safety driving faces the diversity of data anomaly and the randomness and subjectivity of the driver’s driving behavior. How to combine the characteristics of the IOV data with the driving style analysis to provide effective real-time anomaly data detection has become an important issue in the IOV applications. This paper aims at the critical safety data analysis, considering the large computing cost generated by the real-time anomaly detection of all data in the data package. We preprocess it through the traffic cellular automata model which is built to achieve the ideal abnormal detection effect with limited computing resources. On the basis of this model, the Anomaly Detection based on Driving style (ADD) algorithm is proposed to realize real-time and online detection of anomaly data related to safe driving. Firstly, this paper designs the driving coefficient and proposes a driving style quantization model to represent the driving style of the driver. Then, based on driving style quantization model and vehicle driving state information, a data anomaly detection algorithm is developed by using Gaussian mixture model (GMM). Finally, combining with the application scenarios of multi-vehicle collaboration in the Internet of Vehicles, this paper uses real data sets and simulation data sets to analyze the effectiveness of the proposed ADD algorithm.
Convolution forms one of the most essential operations for the FPGA-based hardware accelerator. However, the existing designs often neglect the inherent architecture of FPGA, which puts forward an austere challenge on hardware resource. Even though some previous works have proposed approximate multipliers or convolution acceleration algorithms to deal with this issue, the inevitable accuracy loss and resource occupation easily lead to performance degradation. Toward this, we first propose two kinds of resource-efficient optimized accurate multipliers based on LUTs or carry chains. Then, targeting FPGA-based platforms, a generic multiply–accumulate structure is constructed by directly accumulating the partial products produced by our proposed optimized radix-4 Booth multipliers without intermediate multiplication and addition results. Experimental results demonstrate that our proposed multiplier achieves a maximum 51% look-up-table (LUT) reduction compared to the Vivado area-optimized multiplier IP. Furthermore, the convolutional process unit using the proposed structure achieves a 36% LUT reduction compared to existing methods. As case studies, the proposed method is applied to DCT transform, LeNet, and MobileNet-V3 to achieve hardware resource saving without loss of accuracy.
As the device feature size shrinks, the dissipation of power increases and further raises the carrier and lattice temperature, which finally affects device performance. In this paper, we analyze the comprehensive influence of the self-heating effect and hot carrier injection (HCI) using TCAD simulations. Based on the hydrodynamic and thermodynamic models, it is demonstrated that the thermal surface resistance had a positive impact on the carrier and lattice temperature and that the drain saturation current is reduced dramatically due to the self-heating effect. Moreover, the impact of HCI on device performance is discussed. Finally, it is concluded that the self-heating effect exacerbates the influence of HCI on device characteristics.