China is in a development period of urbanization construction, while its environment is threatened by an increasing amount of construction and demolition (C&D) waste. Due to the excessive pursuit of profits and a general lack of environmental awareness of stakeholders, illegal behaviors such as illegal dumping universally exist in the waste disposal process. Meanwhile, supervision departments face many challenges in collaborative management and decision-making, which lead to inefficiencies in C&D waste supervision and management in China. To address the above challenges, we propose an informatization scheme integrating multiple technologies, which will contribute to real-time monitoring of illegal behaviors in the waste disposal process, accurate data collection for evaluating the performance of stakeholders, and the enhancement of the collaboration between supervisory departments. A case study of the Ningbo Construction Waste Transportation Supervision System is introduced to verify the feasibility and effectiveness of the proposed scheme; results show that the total number of illegal cases has decreased from 510 to 89 per year since the system was put into operation.
Steel sleeve grouting connections are widely used in prefabricated concrete structures. It is well known that insufficient grouting increases the chance of structural failure. As such, it is critical to monitor the density and compactness of grouting sleeve during the construction process, which however remains significant challenges as it is deeply buried in the beam and column. In this study, a lead zirconate titanate (PZT)-based sleeve grouting compactness detection method was systematically investigated. Five grouting sleeves samples with different degrees of compactness were prepared and four PZT transducers were surface-bonded on opposite sides of the outer wall of each sleeve. Two acts as actuators to generate stress wave signals, and the other two operate as sensors to receive the signals. The wavelet packet energy and Hilbert–Huang transform methods were applied to process the stress wave signals, and with the chosen characteristic parameters, the correction model of the grouting compactness was established. Experimental results show that the wavelet packet total energy values and the Hilbert energy peak values are related to the grouting compactness, indicating the feasibility of using PZT sensors to detect the compactness of grouting sleeves.
The uniaxial piezoelectric sensor was developed to overcome the problem of reflecting the output charge of the piezoelectric element as a combination of vectors in the three stress directions. The work performance of the uniaxial piezoelectric sensor under varying load patterns and load rates was investigated. The sensor was embedded in concrete to monitor stress, and its elastic modulus was used as the intermediate bridge to establish the correlation between the embedded sensor and the external sensor. Furthermore, a correction factor for the charge transformation strain was suggested to overcome the mismatching of the sensor’s medium and the concrete. Considering related circumstances, a new stress monitoring method based on a uniaxial piezoelectric sensor was proposed, which can achieve stress whole-process monitoring in concrete and confining stress monitoring in the reinforced concrete column. The results reveal that through the proposed method, the output charge curve of the sensor has a substantial overlap with the stress waveform and high fitting linearity. The work performance of the sensor was stable, and its sensitivity was not affected by loading rate and load pattern. The sensor was embedded in concrete and can coordinate with the concrete deformation. The correction factor of strain obtained by the sensor embedded in concrete was 1.07. The relationship between the charge produced by the embedded sensor and its external calibration sensitivity may be used to implement the whole process of stress monitoring in concrete.
16 November 2024 in Journal of Materials Research and Technology