This review presents the state-of-the-art MEAs, including key components and the preparation technologies. Especially, the overall design strategies of MEAs are discussed to promote high-performance alkaline water electrolysis.
The generation of hydrogen via alkaline electrolyzers is a promising approach for addressing the severe energy crisis. However, alkaline electrolyzers with alkaline electrolytes or pure water suffer from poor performance compared to proton exchange membrane (PEM) electrolyzers. Here, in order to improve the energy conversion efficiency and durability, especially at high current density, a novel three-dimensionally (3D)-ordered membrane electrode assembly (MEA) based on highly porous catalyst layers (CLs) with unique vertical channels, an ultrathin membrane layer (ML) and 3D CL/ML interface structures was nanoengineered for alkaline electrolyzers. Benefiting from the mass-transfer highways constructed by the overall design of the 3D-ordered MEA, a high current density of 4200 mA cm−2 was achieved at 2.0 V in 1 M KOH, which is superior compared with the other best-performing alkaline electrolyzers. Moreover, alkaline electrolyzers fed with pure water achieved a performance of 3100 mA cm−2 at 2.0 V. Notably, the pure-water-fed alkaline electrolyzers can maintain over 600 h at a high current density of 1 A cm−2. By revealing the relationship between the MEA structure and mass transfer, our work opens a simple, cost-effective, and scalable route to prepare 3D-ordered MEAs for alkaline electrolyzers.
The application of membrane electrode assemblies is considered a promising approach for increasing the energy efficiency of conventional alkaline water electrolysis. However, previous investigations have mostly focused on improving membrane conductivity and electrocatalyst activity. This study reports an all-in-one membrane electrode assembly obtained by de novo design. The introduction of a porous membrane readily enables the oriented intergrowth of ordered catalyst layers using solvothermal methods, leading to the formation of an all-in-one MEA for alkaline water electrolysis. This all-in-one MEA features ordered catalyst layers with large surface areas, a low-tortuosity pore structure, integrated catalyst layer/membrane interfaces, and a well-ordered OH- transfer channel. Owing to this design, a high current density of 1000 mA cm−2 is obtained at 1.57 V in 30 wt% KOH, resulting in a 94% energy efficiency. This work highlights the prospects of all-in-one membrane electrode assemblies in designing next-generation high-performance alkaline water electrolysis.
8 December 2021 in ACS Applied Materials & Interfaces
Electrosynthesis of ammonia from nitrate reduction receives extensive attention recently for its relatively mild conditions and clean energy requirements, while most existed electrochemical strategies can only deliver a low yield rate and short duration for the lack of stable ion exchange membranes at high current density. Here, a bipolar membrane nitrate reduction process is proposed to achieve ionic balance, and increasing water dissociation sites is delivered by constructing a three-dimensional physically interlocked interface for the bipolar membrane. This design simultaneously boosts ionic transfer and interfacial stability compared to traditional ones, successfully reducing transmembrane voltage to 1.13 V at up to current density of 1000 mA cm−2. By combining a Co three-dimensional nanoarray cathode designed for large current and low concentration utilizations, a continuous and high yield bipolar membrane reactor for NH3 electrosynthesis realized a stable electrolysis at 1000 mA cm−2 for over 100 h, Faradaic efficiency of 86.2% and maximum yield rate of 68.4 mg h−1 cm−2 with merely 2000 ppm NO3- alkaline electrolyte. These results show promising potential for artificial nitrogen cycling in the near future.