Edible films and coatings gained renewed interest in the food packaging sector with polysaccharide and protein blending being explored as a promising strategy to improve properties of edible films. The present work studies composite edible films in different proportions of pectin (P), alginate (A) and whey Protein concentrate (WP) formulated with a simplex centroid mixture design and evaluated for physico-chemical characteristics to understand the effects of individual components on the final film performance. The studied matrices exhibited good film forming capacity, except for whey protein at a certain concentration, with thickness, elastic and optical properties correlated to the initial solution viscosity. A whey protein component in general lowered the viscosity of the initial solutions compared to that of alginate or pectin solutions. Subsequently, a whey protein component lowered the mechanical strength, as well as the affinity for water, as evidenced from an increasing contact angle. The effect of pectin was reflected in the yellowness index, whereas alginate and whey protein affected the opacity of film. Whey protein favored higher opacity, lower gas barrier values and dense structures, resulting from the polysaccharide-protein aggregates. All films displayed however good thermal stability, with degradation onset temperatures higher than 170 °C.

Stinging nettle (Urtica dioica L.) is a ubiquitous, multi-utility, and under-utilized crop with potential health benefits owing to its nutritional and bioactive components. The objective of the work is to produce powders by drying wild stinging nettle leaves as a storable, low-cost functional additive to be used in bakery and ready-to-cook products. Convective drying (CD) and freeze-drying (FD) were applied on unblanched (U) or blanched (B) leaves, which were then milled to nettle powders (NPs). The obtained NPs were evaluated for selected physicochemical (moisture, color), techno-functional (flow indices, hygroscopicity), and phytochemical (pigments, phenols) characteristics as well as mineral contents. Blanching improved mass transfer and reduced the oxidative degradation of pigments during drying, but it caused a loss of total phenols content, antioxidant activity, and potassium content. As for the drying method, CD resulted in better flow properties (i.e., Carr Index and Hausner Ratio), while FD retained better the color, pigments, magnesium content, phenolic, and antioxidant parameters. Overall, the evaluated processing methods resulted in different technological properties that can allow for better evaluation of NPs as a food additive or ingredient. Among the NPs, blanched and freeze-dried powders despite showing inferior technological properties can be recommended as more suitable ingredients targeted f or food enrichment owing to better retention of bio-active components.