The dynamic response of a simply supported double-beam system under moving loads was studied. First, in order to reduce the difficulty of solving the equation, a finite sin-Fourier transform was used to transform the infinite-degree-of-freedom double-beam system into a superimposed two-degrees-of-freedom system. Second, Duhamel’s integral was used to obtain the analytical expression of Fourier amplitude spectrum function considering the initial conditions. Finally, based on finite sin-Fourier inverse transform, the analytical expression of dynamic response of a simply supported double-beam system under moving loads was deduced. The dynamic response under successive moving loads was calculated by the analytical method and the general FEM software ANSYS. The analysis results show that the analytical method calculation results are consistent with ANSYS’ calculation, thus validating the analytical calculation method. The simply supported double-beam system had multiple critical speeds, and the flexural rigidity significantly affected both peak vertical displacement and critical speed.

Rail irregularity is the leading cause of enhancing train-track coupling vibration and, therefore, should be studied in detail for safety requirements. In this study, the differences between existing rail irregularities without being subjected to an earthquake between different countries were first studied. Results show that existing power spectrum density and time-domain displacement samples of rail irregularities in the American code are the largest, while the irregularities of the Germany railway are higher than those of China in a specific range of rail wavelengths. Afterward, the effects of earthquake intensity, soil site, and duration on the rail irregularity of a Chinese typical high-speed railway bridge were investigated. For this purpose, a finite element model was established and validated by the shaking table test of a 1/12-scaled high-speed railway bridge experimental specimen. The calculation results indicated that the influences of earthquakes on the rail alignment irregularity were evident.

This study proposed a dynamic characteristic analytical method (ANM) of a composite box girder bridge with corrugated steel web (CBGCSW) by completely considering the impact of shear lag effect and accordion effect of corrugated steel webs. Based on energy principles and variational principles, a vibration differential equation and the natural boundary conditions of a CBGCSW were developed. The analytical calculation formula for solving the vibration differential equation was then obtained. The results calculated using the ANM agreed well with previous experimental results, which validated the correctness of ANM. To demonstrate the superiority of the ANM, the vibration frequencies of several abstract CBGCSWs with varying ratios of span–width, obtained using the elementary beam theory (EBT) and the finite element method (FEM), were compared with those obtained by ANM. The efficacy of the ANM was verified and some meaningful conclusions were drawn which are helpful to relevant engineering design, such as the observation that a higher natural vibration frequency and smaller span–width ratio significantly magnified the shear lag effect of CBGCSW. The first five-order natural vibration frequencies of the CBGCSW were significantly lower than those of the composite box girder bridge with general steel web (CBGGSW), which indicates that the impact of the accordion effect is significant.

A nonlinear train-track-bridge system (TTBS) considering the random track irregularity and mass of train is discussed. Based on the Karhunen–Loéve theory, the track irregularity is expressed and input into the TTBS, and the result of random response is calculated using the point estimation method. Two cases are used to compare and validate the applicability of the proposed method, which show that the proposed method has a high precision and efficiency. Then, taking a 7-span bridge and a high-speed train as an example, the calculation results of random response of the nonlinear and linear wheel-rail model are compared, and the results show that for the bridge and rail response, the nonlinear and linear models are almost the same. Finally, comparing the calculated probability distribution results with the test results, it shows that the method can be applied to the prediction of actual response range.