This paper proposes a demagnetization fault detection, mode recognition, magnetic pole positioning, and degree evaluation method for permanent magnet synchronous motors. First, the analytical model of the single-coil no-load back electromotive force (EMF) of demagnetization fault for Permanent magnet synchronous motor (PMSM) arbitrary magnetic poles is established. In the analytical model, the single-coil no-load back EMF residual of the health state and the single magnetic pole sequential demagnetization fault are calculated and normalized. Model results are used as the fault sample database. Second, the energy interval database of the single-coil no-load back EMF residual with different numbers of magnetic pole demagnetization is established. Demagnetization fault detection and degree evaluation are performed by the real-time acquired amplitudes of the single-coil no-load back EMF residual. The number of demagnetization poles is determined by comparing the energy of the single-coil no-load back EMF residual with the energy interval database. Demagnetization mode recognition and magnetic pole positioning are realized by analyzing the correlation coefficients between normalized the single-coil no-load back EMF residual and the fault sample database. Finally, results of analysis of the finite element simulation validate the feasibility and effectiveness of the proposed method.
1 January 2017 in Journal of Robotics, Networking and Artificial Life
Aiming at the problems of low efficiency when long distance and high-inclination belt conveyor driven by multimotor is in light or idle run as well as electrical power unbalance. Control strategy for belt conveyor driven by fourmotor via fuzzy self-tuning PID control algorithm was proposed. The Speed setting algorithm of belt conveyor and fuzzy self-tuning PID algorithm for speed control and power balance control are introduced. The application shows that, according to the coal flow changes of the belt conveyor in real-time, the speed can be automatically adjusted through this algorithm, making the power of the four motors convergence both speed control error and the power control error of which are lower than 2.6%.
21 September 2017 in Lecture Notes in Electrical Engineering