Natalie Wheeler

Dr. Natalie Wheeler


Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 September 2019 in Journal of Lightwave Technology
Verified
Journal Article
Open access
HSH. Sakr
H. Sakr
KBK. R. H. Bottrill
K. R. H. Bottrill
NTN. Taengnoi
N. Taengnoi
NWNatalie Wheeler
Natalie Wheeler
Periklis PetropoulosPeriklis Petropoulos
Periklis Petropoulos
YCY. Chen
Y. Chen
We report a Nested Antiresonant Nodeless hollow-core Fiber (NANF) operating in the first antiresonant passband. The fiber has an ultrawide operational bandwidth of 700 nm, spanning the 1240–1940 nm wavelength range that includes the O-, S-, C- and L- telecoms bands. It has a minimum loss of 6.6 dB/km at 1550 nm, a loss ≤ 7 dB/km between 1465–1655 nm and ≤ 10 dB/km between 1297–1860 nm. By splicing together two structurally matched fibers and by adding single mode fiber (SMF) pigtails at both ends we have produced a ~1 km long span. The concatenated and connectorized fiber has an insertion loss of approximately 10 dB all the way from 1300 nm to 1550 nm, and an effectively single mode behavior across the whole spectral range. To test its data transmission performance, we demonstrate 50-Gb/s OOK data transmission across the O- to L-bands without the need for optical amplification, with bit-error-rates (BERs) lower than the 7% forward error correction (FEC) limit. With the help of optical amplification, 100-Gb/s PAM4 transmission with BER lower than the KP4 FEC limit was also achieved in the O/E and C/L bands, with relatively uniform performance for all wavelengths. Our results confirm the excellent modal purity of the fabricated fiber across a broad spectral range, and highlight its potential for wideband, low nonlinearity, low latency data transmission.

25 December 2017 in Journal of Lightwave Technology
Verified
Journal Article
Open access
MNMubassira Banu Syed Nawazuddin
Mubassira Banu Syed Nawazuddin
NWNatalie Wheeler
Natalie Wheeler
JHJohn R. Hayes
John R. Hayes
SSSeyed Reza Sandoghchi
Seyed Reza Sandoghchi
TBThomas D. Bradley
Thomas D. Bradley
FPFrancesco Poletti
Francesco Poletti
We present a novel Lotus shaped negative curvature antiresonant hollow core fiber with the potential for low loss and very wide bandwidth. A minimum loss of ~10 dB/km at 1550 nm and less than 100 dB/km over a bandwidth of ~650 nm is demonstrated, with effectively single mode behaviour over lengths of a few tens of meters. We demonstrate power penalty free 10.5-Gbit/s data transmission through an 86 m length of fiber at both O and C telecom bands. The fiber macro bend sensitivity has also been tested, which is relevant for telecom as well as for other applications including beam delivery and gas based sensing. The bend loss is found to be below 0.2 dB/m for bend radii down to 8 cm at wavelengths away from the short wavelength edge of the transmission band.

5 April 2022 in Journal of Lightwave Technology
Verified
Journal Article
Open access
SRShuichiro Rikimi
Shuichiro Rikimi
YCYong Chen
Yong Chen
TKThomas W. Kelly
Thomas W. Kelly
IDIan A. Davidson
Ian A. Davidson
GJGregory T. Jasion
Gregory T. Jasion
NWNatalie Wheeler
Natalie Wheeler
We present a study into the gas pressure and composition within a hollow core optical fiber immediately after fabrication. Results from three different experimental techniques indicate that the initial absolute pressure inside of the hollow core is significantly lower than atmospheric pressure. By measuring the equilibrium height to which water ingresses into the hollow core, we estimate the absolute internal gas pressure to be 20 kPa < ${{\boldsymbol{P}}_{\boldsymbol{i}}}$ < 29 kPa for the fibers reported here that were fabricated using standard techniques. The initial gas composition within the hollow core was studied using Raman and absorption spectroscopy and the evolution of the gas composition provides indirect information about the condition of the silica surfaces inside the fiber. The measurements indicate that these internal surfaces become saturated with atmospheric water vapor as this is drawn into the open-ended fiber, initially due to a pressure gradient post-fabrication. Our findings are an essential foundation for the study of long-term optical and mechanical performance of hollow core fibers and important for accurate characterization of these specialty fibers. The first is becoming increasingly important as commercial applications of these fibers expand.

1 August 2022 in Physical Review A
Verified
Journal Article
Closed access
PDF file
VMVincent Michaud-Belleau
Vincent Michaud-Belleau
EFEric R. Numkam Fokoua
Eric R. Numkam Fokoua
PHPeter Horak
Peter Horak
NWNatalie Wheeler
Natalie Wheeler
SRShuichiro Rikimi
Shuichiro Rikimi
RSRadan Slavík
Radan Slavík
Fluctuations of the optical length induced by fundamental thermal noise are known to set the ultimate phase resolution of fiber-based interferometers. Although this noise has been studied in detail for optical fibers made of solid glass material, its impact on the performance of hollow-core optical fibers has not yet been assessed. In such fibers, the guided light interacts only weakly with the glass material whose thermal and thermo-optic properties normally determine the thermal noise level, suggesting that a difference in performance should be expected. Based on the comparison of several interferometers optimized for phase sensitivity, we present measurements of thermal noise in the 20 to 200 kHz range in hollow-core nested antiresonant nodeless fibers (NANF) with their core filled with air at different pressures. In this frequency range, our measurements are in good agreement with the adapted thermoconductive noise model we introduce, suggesting that the thermo-optic contribution from the gas that fills the core is generally dominant, regardless of the exact hollow-core fiber design. While we show that an antiresonant hollow-core fiber filled with air at atmospheric pressure is noisier at 1550 nm than a silica fiber of equal optical length and mode-field area, we also demonstrate the lowest thermal noise power per unit optical length ever measured in a fiber (≈1.3×10−17(rad2/Hz)/m at 30 kHz) using a large-mode-area NANF evacuated and sealed at 0.15 atm. In addition to lowering the internal pressure, we predict that the noise density in this spectral range can be reduced by filling the core with a low-polarizability noble gas. Our results indicate that low-loss antiresonant hollow-core fibers can compete with ultrastable cavities for the purpose of laser frequency stabilization; when evacuated, such fibers should constitute the best option to significantly decrease the fundamental noise floor in interferometric applications currently based on conventional solid-core fibers.

7 May 2024 in IEEE Journal of Selected Topics in Quantum Electronics
Verified
Journal Article
Closed access
EEElizaveta Elistratova
Elizaveta Elistratova
TKThomas W. Kelly
Thomas W. Kelly
IDIan Davidson
Ian Davidson
HSHesham Sakr
Hesham Sakr
TBThomas D. Bradley
Thomas D. Bradley
NWNatalie Wheeler
Natalie Wheeler
Recent progress in reducing the loss of hollow-core fibres (HCFs) makes them great candidates for many fibre applications. However, as the fibre's optical properties depend on the gas pressure and composition within the core and cladding holes, it is essential to understand the gas dynamics at play when the fibres are pressurised, vented or evacuated. Here, we investigate the gas flow dynamics along the core of an HCF with a more complex microstructure design, as is typical of recent state-of-the-art HCFs. We use a novel distributed technique based on optical time-domain reflectometry (OTDR). This technique enables measurement of the evolution of the pressure distribution within the hollow core during the gas-filling process over long fibre lengths. Using these results, we show that the pressure distribution inside the HCF can be simulated using simplified Navier-Stokes equations and approximating the fibre core as a simple cylindrical tube of $\sim$ 0.7 times the fibre core diameter.

12 April 2024 in Sensors
Verified
Journal Article
Open access
PDF file
MSMarzanna Szwaj
Marzanna Szwaj
IDIan Davidson
Ian Davidson
PJPeter B. Johnson
Peter B. Johnson
GJGreg Jasion
Greg Jasion
YJYongmin Jung
Yongmin Jung
SMSumeet Mahajan
Sumeet Mahajan
Label-free and multiphoton micro-endoscopy can transform clinical histopathology by providing an in situ tool for diagnostic imaging and surgical treatment in diseases such as cancer. Key to a multiphoton imaging-based micro-endoscopic device is the optical fiber, for distortion-free and efficient delivery of ultra-short laser pulses to the sample and effective signal collection. In this work, we study a new hollow-core (air-filled) double-clad anti-resonant fiber (DC-ARF) as a high-performance candidate for multiphoton micro-endoscopy. We compare the fiber characteristics of the DC-ARF with a single-clad anti-resonant fiber (SC-ARF) and a solid core fiber (SCF). In this work, while the DC-ARF and the SC-ARF enable low-loss (<0.2 dBm−1), close to dispersion-free excitation pulse delivery (2000% of pulse width increase at 900 nm per 1 m fiber). An ideal optical fiber endoscope needs to be several meters long and should enable both excitation and collection through the fiber. Therefore, we performed multiphoton imaging on endoscopy-compatible 1 m and 3 m lengths of fiber in the back-scattered geometry, wherein the signals were collected either directly (non-descanned detection) or through the fiber (descanned detection). Second harmonic images were collected from barium titanate crystals as well as from biological samples (mouse tail tendon). In non-descanned detection conditions, the ARFs outperformed the SCF by up to 10 times in terms of signal-to-noise ratio of images. Significantly, only the DC-ARF, due to its high numerical aperture (NA) of 0.45 and wide-collection bandwidth (>1 µm), could provide images in the de-scanned detection configuration desirable for endoscopy. Thus, our systematic characterization and comparison of different optical fibers under different image collection configurations, confirms and establishes the utility of DC-ARFs for high-performing label-free multiphoton imaging-based micro-endoscopy.