Milk coagulation properties (MCP) are conventionally measured using computerized renneting meters, mechanical or optical devices that record curd firmness over time (CF(t)). The traditional MCP are rennet coagulation time (RCT, min), curd firmness (a(30), mm), and curd-firming time (k(20), min). The milk of different ruminant species varies in terms of CF(t) pattern. Milk from Holstein-Friesian and some Scandinavian cattle breeds yields higher proportions of noncoagulating samples, samples with longer RCT and lower a(30), and samples for which k(20) is not estimable, than does milk from Brown Swiss, Simmental, and other local Alpine breeds. The amount, proportion, and genetic variants (especially κ-casein) of milk protein fractions strongly influence MCP and explain variable proportions of the observed differences among breeds and among individuals of the same breed. In addition, other major genes have been shown to affect MCP. Individual repeatability of MCP is high, whereas any herd effect is low; thus, the improvement of MCP should be based principally on selection. Exploitable additive genetic variation in MCP exists and has been assessed using different breeds in various countries. Several models have been formulated that either handle noncoagulating samples or not. The heritability of MCP is similar to that of other milk quality traits and is higher than the heritability of milk yield. Rennet coagulation time and a(30) are highly correlated, both phenotypically and genetically. This means that the use of a(30) data does not add valuable information to that obtainable from RCT; both traits are genetically correlated mainly with milk acidity. Moreover, a(30) is correlated with casein content. The major limitations of traditional MCP can be overcome by prolonging the observation period and by using a novel CF(t) modeling, which uses all available information provided by computerized renneting meters and allows the estimation of RCT, the potential asymptotic curd firmness, the curd-firming rate, and the syneresis rate. Direct measurements of RCT obtained from both mechanical and optical devices show similar heritabilities and exhibit high phenotypic and genetic correlations. Moreover, mid-infrared reflectance spectroscopy can predict MCP. The heritabilities of predicted MCP are higher than those of measured MCP, and the 2 sets of values are strongly correlated. Therefore, mid-infrared reflectance spectroscopy is a reliable and cheap method whereby MCP can be improved at the population level; this is because such spectra are already routinely acquired from the milk of cows enrolled in milk recording schemes.

This study investigated the potential application of mid-infrared spectroscopy (MIR 4,000-900 cm(-1)) for the determination of milk coagulation properties (MCP), titratable acidity (TA), and pH in Brown Swiss milk samples (n = 1,064). Because MCP directly influence the efficiency of the cheese-making process, there is strong industrial interest in developing a rapid method for their assessment. Currently, the determination of MCP involves time-consuming laboratory-based measurements, and it is not feasible to carry out these measurements on the large numbers of milk samples associated with milk recording programs. Mid-infrared spectroscopy is an objective and nondestructive technique providing rapid real-time analysis of food compositional and quality parameters. Analysis of milk rennet coagulation time (RCT, min), curd firmness (a(30), mm), TA (SH degrees/50 mL; SH degrees = Soxhlet-Henkel degree), and pH was carried out, and MIR data were recorded over the spectral range of 4,000 to 900 cm(-1). Models were developed by partial least squares regression using untreated and pretreated spectra. The MCP, TA, and pH prediction models were improved by using the combined spectral ranges of 1,600 to 900 cm(-1), 3,040 to 1,700 cm(-1), and 4,000 to 3,470 cm(-1). The root mean square errors of cross-validation for the developed models were 2.36 min (RCT, range 24.9 min), 6.86 mm (a(30), range 58 mm), 0.25 SH degrees/50 mL (TA, range 3.58 SH degrees/50 mL), and 0.07 (pH, range 1.15). The most successfully predicted attributes were TA, RCT, and pH. The model for the prediction of TA provided approximate prediction (R(2) = 0.66), whereas the predictive models developed for RCT and pH could discriminate between high and low values (R(2) = 0.59 to 0.62). It was concluded that, although the models require further development to improve their accuracy before their application in industry, MIR spectroscopy has potential application for the assessment of RCT, TA, and pH during routine milk analysis in the dairy industry. The implementation of such models could be a means of improving MCP through phenotypic-based selection programs and to amend milk payment systems to incorporate MCP into their payment criteria.

The aim of this study was to investigate associations between pathogen-specific cases of subclinical mastitis and milk yield, quality, protein composition, and cheese-making traits. Forty-one multibreed herds were selected for the study, and composite milk samples were collected from 1,508 cows belonging to 3 specialized dairy breeds (Holstein Friesian, Brown Swiss, and Jersey) and 3 dual-purpose breeds of Alpine origin (Simmental, Rendena, and Grey Alpine). Milk composition [i.e., fat, protein, casein, lactose, pH, urea, and somatic cell count (SCC)] was analyzed, and separation of protein fractions was performed by reversed-phase high performance liquid chromatography. Eleven coagulation traits were measured: 5 traditional milk coagulation properties [time from rennet addition to milk gelation (RCT, min), curd-firming rate as the time to a curd firmness (CF) of 20 mm (k20, min), and CF at 30, 45, and 60 min from rennet addition (a30, a45, and a60, mm)], and 6 new curd firming and syneresis traits [potential asymptotical CF at an infinite time (CFP, mm), curd-firming instant rate constant (kCF, % × min-1), curd syneresis instant rate constant (kSR, % × min-1), modeled RCT (RCTeq, min), maximum CF value (CFmax, mm), and time at CFmax (tmax, min)]. We also measured 3 cheese yield traits, expressing the weights of total fresh curd (%CYCURD), dry matter (%CYSOLIDS), and water (%CYWATER) in the curd as percentages of the weight of the processed milk, and 4 nutrient recovery traits (RECPROTEIN, RECFAT, RECSOLIDS, and RECENERGY), representing the percentage ratio between each nutrient in the curd and milk. Milk samples with SCC > 100,000 cells/mL were subjected to bacteriological examination. All samples were divided into 7 clusters of udder health (UH) status: healthy (cows with milk SCC < 100,000 cells/mL and uncultured); culture-negative samples with low, medium, or high SCC; and culture-positive samples divided into contagious, environmental, and opportunistic intramammary infection (IMI). Data were analyzed using a linear mixed model. Significant variations in the casein to protein ratio and lactose content were observed in all culture-positive samples and in culture-negative samples with medium to high SCC compared to normal milk. No differences were observed among contagious, environmental, and opportunistic pathogens, suggesting an effect of inflammation rather than infection. The greatest impairment in milk quantity and composition, clotting ability, and cheese production was observed in the 2 UH status groups with the highest milk SCC (i.e., contagious IMI and culture-negative samples with high SCC), revealing a discrepancy between the bacteriological results and inflammatory status, and thus confirming the importance of SCC as an indicator of udder health and milk quality.

Milk coagulation properties (MCP) are an important aspect in assessing cheese-making ability. Several studies showed that favorable conditions of milk reactivity with rennet, curd formation rate, and curd strength, as well as curd syneresis, have a positive effect on the entire cheese-making process and subsequently on the ripening of cheese. Moreover, MCP were found to be heritable, but little scientific literature is available about their genetic aspects. The aims of this study were to estimate heritability of MCP and genetic correlations among MCP and milk production and quality traits. A total of 1,071 Italian Holstein cows (progeny of 54 sires) reared in 34 herds in Northern Italy were sampled from January to July 2004. Individual milk samples were collected during the morning milking and analyzed for coagulation time (RCT), curd firmness (a30), pH, titratable acidity, fat, protein, and casein contents, and somatic cell count. About 10% of individual milk samples did not coagulate in 31 min, so they were removed from the analyses. Estimates of heritability for RCT and a30 were 0.25 +/- 0.04 and 0.15 +/- 0.03, respectively. Estimates of genetic correlations between MCP traits and milk production traits were negligible except for a30 with protein and casein contents (0.44 +/- 0.10 and 0.53 +/- 0.09, respectively). Estimates of genetic correlations between MCP traits and somatic cell score were strong and favorable, as well as those between MCP and pH and titratable acidity. Selecting for high casein content, milk acidity, and low somatic cell count might be an indirect way to improve MCP without reducing milk yield and quality traits.

Cheese yield (CY) is the most important technological trait of milk, because cheese-making uses a very high proportion of the milk produced worldwide. Few studies have been carried out at the level of individual milk-producing animals due to a scarcity of appropriate procedures for model-cheese production, the complexity of cheese-making, and the frequent use of the fat and protein (or casein) contents of milk as a proxy for cheese yield. Here, we report a high-throughput cheese manufacturing process that mimics all phases of cheese-making, uses 1.5-L samples of milk from individual animals, and allows the simultaneous processing of 15 samples per run. Milk samples were heated (35°C for 40 min), inoculated with starter culture (90 min), mixed with rennet (51.2 international milk-clotting units/L of milk), and recorded for gelation time. Curds were cut twice (10 and 15 min after gelation), separated from the whey, drained (for 30 min), pressed (3 times, 20 min each, with the wheel turned each time), salted in brine (for 60 min), weighed, and sampled. Whey was collected, weighed, and sampled. Milk, curd, and whey samples were analyzed for pH, total solids, fat content, and protein content, and energy content was estimated. Three measures of percentage cheese yield (%CY) were calculated: %CY(CURD), %CY(SOLIDS), and %CY(WATER), representing the ratios between the weight of fresh curd, the total solids of the curd, and the water content of the curd, respectively, and the weight of the milk processed. In addition, 3 measures of daily cheese yield (dCY, kg/d) were defined, considering the daily milk yield. Three measures of nutrient recovery (REC) were computed: REC(FAT), REC(PROTEIN), and REC(SOLIDS), which represented the ratio between the weights of the fat, protein, and total solids in the curd, respectively, and the corresponding components in the milk. Energy recovery, REC(ENERGY), represented the energy content of the cheese compared with that in the milk. This procedure was used to process individual milk samples obtained from 1,167 Brown Swiss cows reared in 85 herds of the province of Trento (Italy). The assessed traits exhibited almost normal distributions, with the exception of REC(FAT). The average values (± SD) were as follows: %CY(CURD)=14.97±1.86, %CY(SOLIDS)=7.18±0.92, %CY(WATER)=7.77±1.27, dCY(CURD)=3.63±1.17, dCY(SOLIDS)=1.74±0.57, dCY(WATER)=1.88±0.63, REC(FAT)=89.79±3.55, REC(PROTEIN)=78.08±2.43, REC(SOLIDS)=51.88±3.52, and REC(ENERGY)=67.19±3.29. All traits were highly influenced by herd-test-date and days in milk of the cow, moderately influenced by parity, and weakly influenced by the utilized vat. Both %CY(CURD) and dCY(CURD) depended not only on the fat and protein (casein) contents of the milk, but also on their proportions retained in the curd; the water trapped in curd presented an higher variability than that of %CY(SOLIDS). All REC traits were variable and affected by days in milk and parity of the cows. The described model cheese-making procedure and the results obtained provided new insight into the phenotypic variation of cheese yield and recovery traits at the individual level.