Compared with the AC microgrids, the advantages of DC microgrids are notable. However, the development of DC microgrids is being constrained by the lack of mature protection schemes. As the foundation of designing protection schemes, the existing fault analysis almost all focused on the fault characteristics of voltage source converters (VSCs) and ignored other generators. While, in DC microgrids with high permeability of photovoltaic (PV) powers, the impacts from PV powers should be paid enough attention. In this paper, the cable fault characteristics of the PV powers are analyzed in detail and both the pole-to-ground fault and the pole-to-pole fault are involved. The fault processes are divided into several stages and the fault circuits and main equations are given for each stage. All the analysis are verified by the simulation model based on the PSCAD/EMTDC and with the help of simulation results, the two main challenges the protection system confronted with are emphasized and impacts of fault distance are analyzed. Finally, the paper proposes to employ a more reasonable converter structure and a transverse differential protection to overcome the main challenges, and the methods effectiveness is verified by the simulation.
An improved system structure and a corresponding protection system are proposed in this paper, which aims at providing future DC microgrids with suitable protection ideas. At first, the ring-bus system is adjusted to balance the system control and protection and make the system more conventional for the equipment expansion. In addition, based on this structure, a protection system is established. It consists of two parts, which are local protection and pilot centralized protection. The local protection is designed for protecting the vulnerable power electronic components in converters and the pilot protection is mainly proposed for the fault isolation. The combination between two parts makes the whole system overcome the contradiction between protection speed and reliability and the method also takes the protection suitability into consideration. Finally, all the methods are verified by the simulation system based on the PSCAD /EMTDC.