Understanding the response of crop growth to water and fertilizer is helpful to improve their management and use efficiency. Three water and fertilizer coupling treatments were designed to carry out a two-season trial on two cabbage (Brassica oleracea L. var. capitata) cultivars in spring and autumn in the Beijing–Tianjin–Hebei region. The irrigation timings of the three treatments were controlled by the soil moisture content of 0–20 cm soil layer. Treatment 1 (LWHF): when the soil moisture content was decreased to 75% of the field capacity (θf), irrigation was carried out (i.e., the lower limit of irrigation was 75%θf), the critical soil moisture content for stopping irrigation was 90%θf (upper limit of irrigation), and the nitrogen (N) application amount was 400 kg/ha; treatment 2 (HWLF): the lower and upper limits of irrigation were 85%θf and 100%θf, respectively, and the N application amount was 200 kg/ha; and treatment 3 (MWMF): the lower and upper limits of irrigation were 75%θf and 100%θf, respectively, and the N application amount was 300 kg/ha. The results showed that the yield and its related parameters of cabbage in spring were higher than those in autumn because of the use of different cultivars and seasons. The growth indices of HWLF and MWMF in the two seasons were larger than that of LWHF, and the yields of HWLF were the highest, 78.37 t/ha (spring) and 64.42 t/ha (autumn), respectively. The nitrogen use efficiencies (NUEs) of LWHF in spring and HWLF in autumn were the highest, 213.29 kg/kg and 391.83 kg/kg, respectively. In general, there were statistically significant differences in the cumulative increment in plant height, stem diameter and leaf area in the two-season trial, yield in autumn and NUE in spring among the three treatments. In addition, there was a significant positive linear correlation between almost all indices in different growth stages and the corresponding evapotranspiration (ETi). It is suggested that the application of drip irrigation under mulch should be approximately 114.7–125.0 mm, and the N fertilization should be about 200 kg/ha.
Unreasonable fertilizer and irrigation applications and dosages in orchards in northern China result in poor vegetative growth and fruit quality. To reveal the combined effect of water and fertilizer coupling on vegetative growth and fruit quality, this study used pear as a field experiment material, considering: (1) irrigation lower limits (55%, 65%, 75%θf, θf is field capacity) and (2) nitrogen fertilizer application (162, 324, 486 kg·ha−1). Nine coupling schemes and a control treatment (C) were set up in the orthogonal combination. The results showed that, under the higher irrigation rate and nitrogen dose, the spring shoot length, base diameter, and leaves relative chlorophyll content values were increased by 36.77%, 31.86% and 12.91%, respectively. The response of each coupling scheme was different. However, selected water and nitrogen coupling schemes improved the fruit quality. The evaluation results indicated that medium irrigation and high fertilizer scheme were optimal. In conclusion, integrating the vegetative growth and fruit quality, it is recommended that the water and fertilizer coupling scheme for pear in the northern China is as follows: a lower irrigation limit of 65%θf and a nitrogen fertilizer amount of 486.00 kg·ha−1.
This study investigates the impact of pipe installation height on the hydraulic performance of a combined canal–pipe water conveyance system (CCPS) and provides practical recommendations. A combined experimental and numerical simulation approach was conducted to systematically analyze and evaluate the impact of different pipe installation heights (0, 1, 3, and 5 cm) and flow rates (18.40, 21.21, 24.74, 28.27, 33.58, and 38.88 L/s) on the system’s behavior. The results indicated that the canal water depths obtained from the numerical simulations were in close agreement with the measurements from the experiments. The water depth in the upstream canal remained nearly parallel to the canal bottom. At the junction, the trend of water depth varies under different flow rates. When the flow rate is low, the water depth sharply decreases. Conversely, when the flow rate is higher, the water depth rises significantly. Cross sections farther from the junction exhibit a higher uniformity in flow velocity distribution. As the height of the pipe installation increases, the range of influence of the junction on the flow velocity distribution in the upstream canal decreases. The elevation of the pipe installation height has been instrumental in enhancing the uniformity of flow velocity distribution across the section. However, the local head loss gradually increases as the installation height increases. Turbulent kinetic energy (TKE) and turbulent eddy dissipation rate (TED) are negatively correlated with the distance between the section and the junction point, and the maximum value decreases gradually with increasing values of the pipe installation height. Considering the hydraulic performance and engineering construction investment, the recommended pipe installation height under the conditions of this study is 1 cm.
Water distribution pipe systems (WDPSs) are critical for delivering irrigation water in an irrigation district. Ensuring the WDPS operates with good operational performance has become a key focus for irrigation water management. Assessing the operational performance of WDPS from both water delivery capacity and pressure changes is compatible with the system, but such an approach has rare been proposed systematically. This paper establishes an integrated framework to assess the performance of WDPS by combining a performance indicator system with a simulation model. The performance indicator system encompasses Adequacy, Efficiency, Equity, and Pressure Reliability, capturing both water delivery capacity and pressure changes. The simulation model is established for providing required data for calculating the performance indicators. Applied to a case study, the framework demonstrates its applicability. Under the specified conditions of the case study, the overall assessment results of WDPS are Adequacy (0.99), Efficiency (0.993), Equity (0.0484), and Pressure Reliability (0.82). Meanwhile, the assessment results at different outlet nodes of the WDPS indicate that there may be insufficient pressure and excessive water supply at some outlet nodes of the WDPS. Further interpretation of the results indicates that the proposed method has the potential to be beneficial for irrigation water management, as it enables strategic assessment of the future operational performance of water distribution pipe systems (WDPSs) and provides effective management guidance for irrigation district managers.