The design and development of a plastic optical fiber (POF) macrobend temperature sensor is presented. The sensor has a linear response versus temperature at a fixed bend radius, with a sensitivity of . The sensor system used a dummy fiber-optic sensor for reference purposes having a resolution below 0.3 °C. A comprehensive experimental analysis was carried out to provide insight into the effect of different surrounding media on practical macro-bend POF sensor implementation. Experimental results are successfully compared with bend loss calculations.

Polymer optical fibers (POFs) doped with organic dyes can be used to make efficient lasers and amplifiers due to the high gains achievable in short distances. This paper analyzes the peculiarities of light amplification in POFs through some experimental data and a computational model capable of carrying out both power and spectral analyses. We investigate the emission spectral shifts and widths and on the optimum signal wavelength and pump power as functions of the fiber length, the fiber numerical aperture and the radial distribution of the dopant. Analyses for both step-index and graded-index POFs have been done.

A novel self-referencing fiber optic intensity sensor based on bending losses of a partially polished polymer optical fiber (POF) coupler is presented. The coupling ratio (K) depends on the external liquid in which the sensor is immersed. It is possible to distinguish between different liquids and to detect their presence. Experimental results for the most usual liquids found in industry, like water and oil, are given. K value increases up to 10% from the nominal value depending on the liquid. Sensor temperature dependence has also been studied for a range from 25 ºC (environmental condition) to 50 ºC. Any sector requiring liquid level measurements in flammable atmospheres can benefit from this intrinsically safe technology.

The behavior of tapered graded-index polymer optical fibers is analyzed computationally for different refractive indices of the surrounding medium. This serves to clarify the main parameters affecting their possible performance as refractive-index sensors and extends an existing study of similar structures in glass fibers. The ray-tracing method is employed, its specific implementation is explained, and its results are compared with experimental ones, both from our laboratory and from the literature. The results show that the current commercial graded-index polymer optical fibers can be used to measure a large range of refractive indices with several advantages over glass fibers.

Tip clearance is critical to the performance of rotating turbomachinery. The objective of this paper is to develop a noncontact sensor with a precision of 30 μm to measure tip clearance in a turbine rig assembled in a wind tunnel. To carry out the measurements, an optical sensor whose main component is a bundle of optical fibers is employed. We use four different configurations of this sensor, which are tested in two distinct turbines with the aim of minimizing the effect of the noise on the repeatability of the measurements. Each configuration serves to increase the precision until the required performance is achieved for the measurement of the tip clearance. Our results may be helpful to develop applications related to structural health monitoring or active clearance-control systems.

The emission properties of a graded-index thermoplastic polymer optical fiber and a step-index thermosetting one, both doped with rhodamine 6G, have been studied. The work includes a detailed analysis of the amplified spontaneous emission together with a study of the optical gains and losses of the fibers. The photostability of the emission of both types of fibers has also been investigated. Comparisons between the results of both doped polymer optical fibers are presented and discussed.