Magnetic iron oxide-silica shell nanocomposites with different iron oxide/silica ratio were synthesized and structurally characterized by Fourier transform infrared (FT-IR) spectroscopy, X-ray diffraction (XRD), small-angle neutron scattering, magnetic and N₂-sorption studies. The composite that resulted with the best properties in terms of contact surface area and saturation of magnetization was selected for Pb²⁺ adsorption studies from aqueous media. The material presented good absorption capacity (maximum adsorption capacity 14.9 mg·g⁻¹) comparable with similar materials presented in literature. Its chemico-physical stability and adsorption capacity recommend the nanocomposite as a cheap adsorbent material for lead.

The aim of this study is the rapid detection of food pressed oils adulteration with their refined versions, using UV–Vis spectroscopy. The study investigates some common oil physico-chemical parameters such are: density, viscosity, refractive index, acid index, peroxide value, saponification index, to detect differences between cold pressed oils versus refined ones, for some food-grade oils found on Romanian market, as well as FT-IR spectroscopy and GC–MS analytical method, obtaining similar results to those presented in the literature data. The difference between some of the obtained results is not relevant for telling the cold-pressed oils from their refined version for adulteration investigation purpose. Colour analysis instead is a very good method to differentiate a cold pressed oil from a refined one. Taking this into account, the cold pressed oils and their refined versions were mixed in different proportions, and their colour properties were analyzed, obtaining linear dependences for a* and b* CIE L*a*b* parameters with cold pressed oil content in the mixture. Dependence equations were proposed.

Adsorption recovery of precious metals on a variety of solid substrates has steadily gained increased attention in recent years. Special attention was paid to the studies on the characterization of the adsorptive properties of materials with a high affinity for gold depending on the nature of the pendant groups present in the structure of the material. The aim of the present work was to synthesize and characterize a new material by using the sol-gel synthesis method (designated as BCb/CB). In this case, synthesis involved the following precursors: bismuth carbonate (III), carbon black, and IGEPAL surfactant (octylphenoxypolyethoxyethanol). Immobilization of the heterojunction as bismuth oxide over a flexible support such as carbon black (CB) can prevent their elution in solution and make it versatile for its use in a system. In this work, a new adsorbent material based on bismuth carbonate supported over carbon black (BCb/CB) was developed and used further for gold recovery from aqueous solutions. The required material was characterized physically/chemically by scanning electron microscopy (SEM); energy dispersive X-ray spectrometry (EDX); X-ray diffraction (XRD); thermal analysis (DTG/DTA); atomic force microscopy (AFM). The Brunauer–Emmett–Teller (BET) method was used to determine the specific surface area indicating a value of approximately 40 m²/g, higher than the surface of CB precursor (36 m²/g). The adsorptive properties and the adsorption mechanism of the materials were highlighted in order to recover Au(III). For this, static adsorption studies were carried out. The parameters that influence the adsorption process were studied, namely: the pH, the contact time, the temperature, and the initial concentration of the gold ions in the used solution. In order to establish the mechanism of the adsorption process, kinetic, thermodynamic, and equilibrium studies were carried out. Experimental data proved that the gold recovery can be conducted with maximum performance at pH 3, at room temperature. Thermodynamic studies proved that the gold adsorption on BCb/CB material is a spontaneous and endothermal process. The results indicate a total adsorption capacity of 13.1 mg Au(III)/g material. By using this material in real solutions, a recovery efficiency of 90.5% was obtained, concomitant with a higher selectivity (around 95%).