Arman Rashidi

Dr. Arman Rashidi

orcid

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 February 2018 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
ARArman Rashidi
Arman Rashidi
MMMorteza Monavarian
Morteza Monavarian
AAAndrew Aragon
Andrew Aragon
ARAshwin Rishinaramangalam
Ashwin Rishinaramangalam
DFDaniel Feezell
Daniel Feezell
We demonstrate a high-speed nonpolar m-plane InGaN/GaN micro-scale light-emitting diode (LED) with a record electrical -3dB modulation bandwidth of 1.5 GHz at a current density of 1 kA/cm2. A differential carrier lifetime (DLT) of 200 ps at 1 kA/cm2 was extracted using a rate-equation model. The short DLT is attributed to the high electron-hole wavefunction overlap in polarization-free nonpolar InGaN/GaN quantum wells, which leads to a higher spontaneous emission rate at low current densities compared to polar c-plane quantum wells. LEDs with improved high-speed performance at low current densities will help reduce power dissipation and increase efficiency in Gb/s visible-light communication systems.

27 December 2018 in Physica Status Solidi (a)
Verified
Journal Article
Open access
PDF file
MMMorteza Monavarian
Morteza Monavarian
ARArman Rashidi
Arman Rashidi
DFDaniel Feezell
Daniel Feezell
The performance of III‐nitride devices is degraded by polarization in a wurtzite crystal structure. Nonpolar and semipolar III‐nitrides have been extensively studied since the early 2000s as a solution to the polarization‐related issues. Removal of polarization is expected to improve the radiative efficiency, optical gain, charge transport, and potentially offer solutions to the challenging problems in III‐nitride light‐emitting diodes (LEDs) known as efficiency droop and the green gap. In addition, use of nonpolar and semipolar orientations is also predicted to offer polarization pinning in some devices due to anisotropic in‐plane strain. Despite the many potential advantages over c‐plane, nonpolar and semipolar optoelectronic devices have not successfully replaced conventional c‐plane devices in the commercial sector. Here, nonpolar and semipolar III‐nitrides are reviewed after more than a decade of development. The successes and challenges of nonpolar and semipolar orientations for applications such as LEDs, laser diodes, superluminescent diodes, and vertical‐cavity surface emitting lasers are discussed. New potential avenues for nonpolar and semipolar III‐nitrides are also highlighted, including visible‐light communication and power electronics. The availability of low‐cost, high‐crystal‐quality substrates with nonpolar or semipolar orientation is discussed and alternative approaches for realizing these orientations are presented, including selective‐area bottom‐up nanostructures.

9 January 2017 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
ARArman Rashidi
Arman Rashidi
MMMorteza Monavarian
Morteza Monavarian
AAAndrew Aragon
Andrew Aragon
SOSerdal Okur
Serdal Okur
MNMohsen Nami
Mohsen Nami
DFDaniel Feezell
Daniel Feezell
Free-standing nonpolar GaN substrates provide an excellent platform for the fabrication of high-speed blue and green light-emitting diodes (LEDs), which are attractive for visible-light communication, plastic optical fiber communication, and short-range under water optical communication. Nonpolar LEDs on free-standing GaN exhibit a large electron-hole wave function overlap, low extended defect density, and favorable thermal properties. Here, we demonstrate high-speed nonpolar InGaN/GaN LEDs with a peak emission wavelength between 455 and 465 nm on free-standing nonpolar GaN substrates. A large frequency modulation bandwidth of 524 MHz is demonstrated at a current density of 10 kA/cm 2 .

20 July 2017 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
ARArman Rashidi
Arman Rashidi
MNMohsen Nami
Mohsen Nami
MMM. Monavarian
M. Monavarian
AAA. Aragon
A. Aragon
KDK. DaVico
K. DaVico
DFD. Feezell
D. Feezell
This work describes a small-signal microwave method for determining the differential carrier lifetime and transport effects in electrically injected InGaN/GaN light-emitting diodes (LEDs). By considering the carrier diffusion, capture, thermionic escape, and recombination, the rate equations are used to derive an equivalent small-signal electrical circuit for the LEDs, from which expressions for the input impedance and modulation response are obtained. The expressions are simultaneously fit to the experimental data for the input impedance and modulation response for nonpolar InGaN/GaN micro-LEDs on free-standing GaN substrates. The fittings are used to extract the transport related circuit parameters and differential carrier lifetimes. The dependence of the parameters on the device diameter and current density is reported. We also derive approximations for the modulation response under low and high injection levels and show that the transport of carriers affects the modulation response of the device, especially at low injection levels. The methods presented are relevant to the design of high-speed LEDs for visible-light communication.

22 January 2018 in Applied Physics Letters
Verified
Journal Article
Closed access
MMM. Monavarian
M. Monavarian
ARArman Rashidi
Arman Rashidi
AAA. A. Aragon
A. A. Aragon
SOS. H. Oh
S. H. Oh
ARA. K. Rishinaramangalam
A. K. Rishinaramangalam
DFD. Feezell
D. Feezell
High-speed InGaN/GaN blue light-emitting diodes (LEDs) are needed for future gigabit-per-second visible-light communication systems. Large LED modulation bandwidths are typically achieved at high current densities, with reports close to 1 GHz bandwidth at current densities ranging from 5 to 10 kA/cm2. However, the internal quantum efficiency (IQE) of InGaN/GaN LEDs is quite low at high current densities due to the well-known efficiency droop phenomenon. Here, we show experimentally that nonpolar and semipolar orientations of GaN enable higher modulation bandwidths at low current densities where the IQE is expected to be higher and power dissipation is lower. We experimentally compare the modulation bandwidth vs. current density for LEDs on nonpolar (101¯0) , semipolar (202¯1¯) , and polar 0001 orientations. In agreement with wavefunction overlap considerations, the experimental results indicate a higher modulation bandwidth for the nonpolar and semipolar LEDs, especially at relatively low current densities. At 500 A/cm2, the nonpolar LED has a 3 dB bandwidth of ∼1 GHz, while the semipolar and polar LEDs exhibit bandwidths of 260 MHz and 75 MHz, respectively. A lower carrier density for a given current density is extracted from the RF measurements for the nonpolar and semipolar LEDs, consistent with the higher wavefunction overlaps in these orientations. At large current densities, the bandwidth of the polar LED approaches that of the nonpolar and semipolar LEDs due to coulomb screening of the polarization field. The results support using nonpolar and semipolar orientations to achieve high-speed LEDs at low current densities.

24 January 2023 in Physical Review Letters
Verified
Journal Article
Closed access
PDF file
ALAlexander C. Lygo
Alexander C. Lygo
BGBinghao Guo
Binghao Guo
ARArman Rashidi
Arman Rashidi
VHVictor Huang
Victor Huang
PCPablo Cuadros-Romero
Pablo Cuadros-Romero
SSSusanne Stemmer
Susanne Stemmer
Two-dimensional topological insulators (2D TIs) are a highly desired quantum phase but few materials have demonstrated clear signatures of a 2D TI state. It has been predicted that 2D TIs can be created from thin films of three-dimensional TIs by reducing the film thickness until the surface states hybridize. Here, we employ this technique to report the first observation of a 2D TI state in epitaxial thin films of cadmium arsenide, a prototype Dirac semimetal in bulk form. Using magnetotransport measurements with electrostatic gating, we observe a Landau level spectrum and quantum Hall effect that are in excellent agreement with those of an ideal 2D TI. Specifically, we observe a crossing of the zeroth Landau levels at a critical magnetic field. We show that the film thickness can be used to tune the critical magnetic field. Moreover, a larger change in film thickness causes a transition from a 2D TI to a 2D trivial insulator, just as predicted by theory. The high degree of tunability available in epitaxial cadmium arsenide heterostructures can thus be used to fine-tune the 2D TI, which is essential for future topological devices.