Ni/60WC coatings on copper substrate were placed via laser deposition (LD). A structural study was conducted using electron microscopy and a microhardness evaluation. Two body abrasive wear tests were conducted with a pin-on-plate reciprocating technique. A tool steel X12MF GOST 5960 (C-Cr-Mo-V 1.6-12-0.5-0.2) with a hardness of 63 HRC was used as a counterpart. The following results were obtained: Precipitation of the secondary carbides takes place in the thicker layers. Their hardness is lower than that of the primary carbides in the deposition (2425 HV vs. 2757 HV) because they mix with the matrix material. In the thin layers, precipitation is restricted due to a higher cooling rate. For both LD coatings, the carbide’s hardness increases compared to the initial mono-tungsten carbide (WC)-containing powder (2756 HV vs. 2200 HV). Such a high level of microhardness reflects the combined influence of a low level of thermal destruction of carbides during laser deposition and the formation of a boride-strengthening phase from the matrix powder. The thicker layer showed a higher wear resistance; weight loss was 20% lower. The changes in the thickness of the laser deposited Ni-WC coating altered its structure and wear resistance.
1 February 2023 in Diagnostics, Resource and Mechanics of materials and structures
The study of the applicability of magnetic and optical methods to the detection of prefracture zones under fatigue degradation of structural materials is exemplified by the 09G2S steel. The regularities of changes in the signal of an attached fluxgate gradiometer with the increasing number of loading cycles have been revealed; namely, significant changes in the gradiometer readings on individual specimen surface areas prove to result from the formation of fracture zones. The change in the value of the coefficient of correlation among the speckle images is studied at different stages of cyclic testing. Speckle image heterogeneity is shown to appear due to fracture nucleation. Thus, the applicability of magnetic and speckle-interferometric methods to detecting prefracture zones in objects under cyclic loading is substantiated.
Nitride layers on the high-speed steel 1.3343 were produced by means of transmitted plasma arc. The surface treatment with plasma arc leads to high thermal stress reliefs caused by the tracing point of the arc. To use the plasma arc to build up a nitrided layer without a deep heat penetration of the base metal requires a good knowledge of the temperature profile on and under the surface. The investigations show that the steel needs a stable temperature on the surface to reach maximum nitrogen input. At the same time the surface temperature must not reach the melting point of the material. To satisfy these two conflicting conditions an accurate temperature control is necessary. Surface temperatures, temperatures in the bulk and under the surface were measured by conductive and thermographic methods and were correlated with investigations of the resulting metallographic structure. It was shown that the temperature distribution in and under the surface zone during the atmospheric plasma-nitriding shows a large gradient and the material temperature at a depth of 100 µm is not more than 200 °C.
In the hypereutectoid steel U13 different morphologies and distribution types of excess cementite can be implemented by heat treatment and heat treatment combined with deformation. Excess hypereutectoid cementite can be represented in two-dimensional arrangements, such as a network on the boundaries of former austenite grains and a Widmanstätten-type plates in the inner volumes of former austenite grains. A globular form of the excess hypereutectoid cementite is characterized by uniform or nonuniform layered distribution. Coercive force Hc measured for different morphologies of excess cementite under conditions of an equal globular pearlite matrix ranges between 10.8 and 14.0 A/cm. The layered distribution of cementite globules provides a smaller coercive force value in comparison with uniform distribution. For two-dimensional forms, the cementite network provides a smaller coercive force value in comparison with Widmanstätten cementite.