Traffic congestion usually occurs in certain areas or sections, which could be regarded as the reflection of road network disequilibrium caused by the traffic flow distribution, network structure, etc. It is found that unbalance analysis of the road network and the unbalanced points study could provide great support for the road network structure optimization, traffic capacity adjustment, and the efficiency improvement of road network resources. Furthermore, it is helpful to reduce the traffic congestion significantly. In order to design a method to analyze the disequilibrium of road networks to find out the unbalanced or bottleneck points, the road network structure, traffic flow distribution and the location of sections are considered in the analysis of road network disequilibrium, and the disequilibrium is measured using Gini coefficient and Theil index from road network attributes of influence and capability in this paper. First, section influence degree and section flow betweenness are employed to separately represent the differences in the influence relationship and capability distribution of a section from others in the network. Second, these two indicators are taken respectively as the input, and the road network equilibrium is analyzed multi-dimensionally using Gini coefficient and Theil index. The level of the disequilibrium is analyzed from the view of the overall network. Meanwhile, the contributions of a certain section to the disequilibrium of the whole network is also analyzed from the perspective of the section. Finally, a case study based on Beijing’s regional road network is conducted, and the result shows the similar performance compared with the actual road network traffic situation, which verifies the feasibility and validity of the method in multi-dimension analysis of road network disequilibrium.
We have developed a micro-infrared photoelastic system to evaluate the stress of through-silicon-vias (TSV). It was found that the stresses of some TSVs increased after thermal cycling, and the scanning electron microscope revealed that those TSVs with stress increased had Cu filler pumped under thermal loading, but no interfacial fracture were observed. Then the annealed samples were heated up to 400°C and stresses of those TSVs were monitored during thermal cycling in real time mode. It was observed that stress of those TSVs decreased first and then increased again. However, with the continuous increase of temperature, the stress of each TSV finally vanished at different temperatures and their stress-free states were kept until 400C was reached. During and after the cooling process, photo-elastic fringes pattern appeared around each TSV again and some fringes became even brighter than before, which indicated that the stress of some TSVs had increased after experiencing another high temperature cycling.