Recently, the usage of wood–plastic composite (WPC) products has increased, mainly for exterior decking. The shape of fillers is one of the important factors deciding the mechanical and physical properties of WPCs. Surface-fibrillated wood flour (WF) improves the mechanical properties of WPCs, although it requires a lot of energy and time to produce the fibrous structure during the pulverization process. Therefore, the adsorptive interaction between cellulose nanofiber (CNF) and WF by hydrogen bonding was investigated. We considered that CNF could form the fibrous structures on the WF surface by mixing CNF and WF. Also, it is thought that the addition of CNF could increase mechanical and physical properties of WPC because CNF has better physical and mechanical properties than most other fibers. The objective of this study was to produce WF-CNF fillers and to evaluate the mechanical and physical properties of WPCs containing WF-CNF fillers. WF-CNF fillers could be produced by freeze-drying after mixing WF, CNF, and water. The fibrous structures on the WF surface were observed through scanning electron microscope images of WF-CNF filler containing 3 weight percent CNF. A WPC with WF-CNF filler containing 22 percent (by weight) WF and 3 percent (by weight) CNF showed improved mechanical properties compared with WPCs without CNF. The water absorption of WPCs containing CNF was found to decrease with increasing CNF content.
The addition of maleic anhydride (MA)-modified polypropylene (MAPP) as a compatibilizer increases mechanical and physical properties of wood/plastic composites (WPCs). It is thought that MA graft ratio (Gr), molecular weight (weight-average molecular weight [Mw]), and mixing methods of MAPP affect physical and mechanical properties of WPCs. However, evaluation, especially for mixing order, is not enough. The objective of this study was to investigate the effect of Gr and Mw of MAPP and its mixing methods on the mechanical and physical properties of WPCs. Two types of mixing methods were used: mixing the MAPP with the filler using a Henschel mixer before kneading with PP (premixing method) and mixing all of the materials at one time (one-step mixing method). The WPCs made with the premixing method had lower shear viscosity and higher flexural modulus than those made with the one-step mixing method. The particle size, moisture content, and surface morphology of fillers are thought to be more important in determining the shear viscosity of WPCs than the MAPP itself. The highest tensile, impact, and flexural strengths of WPCs were obtained in the WPC with premixing with low-Gr and high-Mw MAPP. It may be due to the effective reaction of the wood flour with MAPP and higher entanglement between the MAPP and PP. These results suggest that the premixing method could improve productivity and mechanical properties of WPCs.