The aim of this study is to analyze the thermal properties of sago fiber-epoxy composite. The sago fiber-based composite has been prepared using epoxy resin as the matrix, via a simple mixing followed by compression. The compression process includes hot compression (100 °C/10 kgf cm−2) and cold compression (ambient/10 kgf cm−2). The composite series was prepared with 9%, 13%, 17%, 20%, and 23% (w/w) of epoxy resin. Microstructures of all materials used were observed using an SEM (scanning electron microscope) instrument. The thermal properties of the composite and its components were examined through TG/DTA characterization. The samples were heated using the heating rate of 10 °C/min from room temperature to 400 °C, except for epoxy resin, which was heated to 530 °C. TG/DTA results depict three stages of thermal processes of sago fiber-epoxy composite: evaporation of water molecules at below 100 °C with the peak point within the range of 51.3 and 57.3 °C, the damage of sago fiber within the range of 275 and 370 °C with the peak point within the range of 333.3 and 341.3 °C and the damage of epoxy resin at above 350 °C with the peak point at 376.2 °C.
1 January 2013 in International Journal of Applied Physics and Mathematics
The granular materials phenomenon known as Brazil-nut effect is discussed in this work, where its grain configurations are constructed artificially as time-independent using 2-d disks. Single intruder with 2.6 cm diameter is introduced to granular bed consisted of 1.3 cm diameter disks. Each created configuration is designed similar to observed one in experiments and simulations. Potential energy and number of contact points between grains are observed between initial and final configurations. Contactopy parameter change is also discussed. As comparison results from real experiment and simulation are also presented.
A two-phase copolymer DA-coPUs containing of 50% hard-segment has been prepared using a polyoxypropylene-diol with molecular weight of 2000 (Voranol 2000), 4,4 -diphenylmethane diisocyanate (MDI) and 2,4-hexadiyne-1,6-diol (HDD) via a one-shot, bulk polymerization process. Solution of linear, as-prepared DA-coPUs in N,N-Dimethylacetamide (DMAc) was coated onto pre-heated steel beam. Cross polymerization of the DA-coPUs were carried out using heating under nitrogen at 100◦C for 5 hours. Deformation micromechanics of the DA-coPUs has been studied using simultaneous 4-point bending testing and Raman spectroscopy. The results showed that the coating has poorer strain- induced Raman band shift factors than that of pure DA-coPUs [1]
This work presents a new approach which demonstrates that the degree of fiber-matrix bonding can be quantified by means of the friction coefficient, rather than by using a adhesion parameter. ABAQUS finite element analysis software is used to simulate bonding behavior in term of friction coefficient between fiber and matrix of aligned continuous fiber composite. Simulation result shows that Young modulus of the composite increases linearly with the increase of friction coefficient between matrix and fiber. This shows that if the value of Young's modulus of the fiber is far greater than the Young's modulus of the matrix, then the value of Young's modulus of the resulting composite will tend to get closer to the value of Young's modulus of the fiber. It means that the influence of coefficient of friction between the fiber and the matrix is getting insignificant.