Polymer flooding is one of the most promising techniques for the recovery of remaining oil from light oil reservoirs. Water soluble polymers are used to enhance the viscosity of displacing fluid and to improve the sweep efficiency. In this paper, water soluble polymers used for chemical enhanced oil recovery are reviewed. Conventional and novel modified polymers are discussed along with their limitations. The review covers thermal stability, rheology, and adsorption behavior of various polymer systems in sandstone and carbonate reservoirs. Field and laboratory core flooding data of several polymers are covered. The review describes the polymer systems that are successfully applied in low-temperature and low-salinity reservoirs. Comprehensive review of current research activities aiming at extending polymer flooding to high-temperature and high-salinity reservoirs is performed. The review has identified current and future challenges of polymer flooding.

Solar energy is an abundant and accessible source of renewable energy available on earth, and many types of photovoltaic (PV) devices like organic, inorganic, and hybrid cells have been developed to harness the energy. PV cells directly convert solar radiation into electricity without affecting the environment. Although silicon based solar cells (inorganic cells) are widely used because of their high efficiency, they are rigid and manufacturing costs are high. Researchers have focused on organic solar cells to overcome these disadvantages. DSSCs comprise a sensitized semiconductor (photoelectrode) and a catalytic electrode (counter electrode) with an electrolyte sandwiched between them and their efficiency depends on many factors. The maximum electrical conversion efficiency of DSSCs attained so far is 11.1%, which is still low for commercial applications. This review examines the working principle, factors affecting the efficiency, and key challenges facing DSSCs.

Activated carbon (AC), a porous material with high pore volume, attracts increasing attention owing to its potential applications in several fields. The development of a porous structure in AC marginally relies on both the treatment methods and the type of precursor. Thus far, both renewable and nonrenewable precursor sources have been used to synthesize AC with high surface area and pore volume. This study presents the synthesis of AC via physicochemical treatment of waste oil fly ash (OFA), a waste material produced from power plants. The aim was to produce AC by adding surface pores and surface functional groups to the basal plane of OFA. Toward this objective, OFA was first chemically leached/activated with various combinations of H2SO4 and H3PO4, and then physically activated with CO2 at 900 °C. The chemical activation step, synergistically combined with CO2 activation, resulted in an increase of 24 times the specific surface area of the OFA. The maximum increase in surface area was obtained for the sample physicochemically treated with 100% H2SO4 . Moreover, the spectroscopic analysis confirmed the presence of acid functional groups after the chemical treatment step. To explore the surface heterogeneity, adsorptive potential distribution in terms of surface energy was also discussed as a function of the surface coverage. Following chemical activation, the OFA surface became heterogeneous. A major portion of the AC showed surface energy in the range of 40–50 erg/K, which was further increased as a result of physical activation at a higher temperature. Thus, the synergism created by physicochemical activation resulted in a material with high surface area and pore volume, and excellent adsorption characteristics. From the findings of this study, it was concluded that OFA is a cost-effective and environmentally benign precursor for the synthesis of AC.