This critical review reveals the technologies and potentials to recover water, energy, fertilizers and products from municipal WWTPs but also analyses the various bottlenecks that may their hinder successful implementation.

The aim of this study was to assess the potential environmental impacts associated with high rate algal ponds (HRAP) systems for wastewater treatment and resource recovery in small communities. To this aim, a Life Cycle Assessment (LCA) was carried out evaluating two alternatives: i) a HRAP system for wastewater treatment where microalgal biomass is valorized for energy recovery (biogas production); ii) a HRAP system for wastewater treatment where microalgal biomass is reused for nutrients recovery (biofertilizer production). Additionally, both alternatives were compared to a typical small-sized activated sludge system. An economic assessment was also performed. The results showed that HRAP system coupled with biogas production appeared to be more environmentally friendly than HRAP system coupled with biofertilizer production in the climate change, ozone layer depletion, photochemical oxidant formation, and fossil depletion impact categories. Different climatic conditions have strongly influenced the results obtained in the eutrophication and metal depletion impact categories. In fact, the HRAP system located where warm temperatures and high solar radiation are predominant (HRAP system coupled with biofertilizer production) showed lower impact in those categories. Additionally, the characteristics (e.g. nutrients and heavy metals concentration) of microalgal biomass recovered from wastewater appeared to be crucial when assessing the potential environmental impacts in the terrestrial acidification, particulate matter formation and toxicity impact categories. In terms of costs, HRAP systems seemed to be more economically feasible when combined with biofertilizer production instead of biogas. On the whole, implementing HRAPs instead of activated sludge systems might increase sustainability and cost-effectiveness of wastewater treatment in small communities, especially if implemented in warm climate regions and coupled with biofertilizer production.

The aim of this study was to assess the environmental impact of microbial fuel cells (MFCs) implemented in constructed wetlands (CWs). To this aim a life cycle assessment (LCA) was carried out comparing three scenarios: 1) a conventional CW system (without MFC implementation); 2) a CW system coupled with a gravel-based anode MFC, and 3) a CW system coupled with a graphite-based anode MFC. All systems served a population equivalent of 1500 p.e. They were designed to meet the same effluent quality. Since MFCs implemented in CWs improve treatment efficiency, the CWs coupled with MFCs had lower specific area requirement compared to the conventional CW system. The functional unit was 1m3 of wastewater. The LCA was performed with the software SimaPro® 8, using the CML-IA baseline method. The three scenarios considered showed similar environmental performance in all the categories considered, with the exception of Abiotic Depletion Potential. In this impact category, the potential environmental impact of the CW system coupled with a gravel-based anode MFC was around 2 times higher than that generated by the conventional CW system and the CW system coupled with a graphite-based anode MFC. It was attributed to the large amount of less environmentally friendly materials (e.g. metals, graphite) for MFCs implementation, especially in the case of gravel-based anode MFCs. Therefore, the CW system coupled with graphite-based anode MFC appeared as the most environmentally friendly solution which can replace conventional CWs reducing system footprint by up to 20%. An economic assessment showed that this system was around 1.5 times more expensive than the conventional CW system.

The aim of this study was to investigate the cultivation of Nostoc sp., Arthrospira platensis and Porphyridium purpureum in industrial wastewater to produce phycobiliproteins. Initially, light intensity and growth medium composition were optimized, indicating that light conditions influenced the phycobiliproteins production more than the medium composition. Conditions were then selected, according to biomass growth, nutrients removal and phycobiliproteins production, to cultivate these microalgae in food-industry wastewater. The three species could efficiently remove up to 98%, 94% and 100% of COD, inorganic nitrogen and PO43--P, respectively. Phycocyanin, allophycocyanin and phycoerythrin were successfully extracted from the biomass reaching concentrations up to 103, 57 and 30 mg/g dry weight, respectively. Results highlight the potential use of microalgae for industrial wastewater treatment and related high-value phycobiliproteins recovery.