Biochar is a carbon-rich organic material, obtained by the thermochemical conversion of biomass in an oxygen-limited environment, used as a soil amendment to stimulate soil fertility and improve soil quality. There is a clear need in developing countries for access to low cost, low technology options for biochar production, for example, top-lit updraft (TLUD) stoves, which are popular and spread worldwide. However, TLUD biochars are inevitably very variable in their properties for a variety of reasons. We present laboratory triplicate tests carried out on TLUD biochars obtained from waste pinewood and a Guadua bamboo. Analyzed properties include specific surface area (A-BET), porosity, skeletal density, hydrophobicity, proximal and elemental composition, cation exchange capacity (CEC), relative liming capacity and pH. SEM images of the bamboo and wood biochars are compared. The biochars were mixed with composted human excreta at 5% and 10% biochar content, and available water content (AWC) was analyzed. Operating temperatures in the TLUD were recorded, showing different behaviors among the feedstocks during the process. Differences in operating temperatures during charring of the bamboo samples seem to have led to differences in A-BET, hydrophobicity and CEC, following unprecedented trends. For the mixtures of the biochars with compost, at 5% biochar no significant differences were observed for AWC. However, in the 10% biochar mixtures, bamboo biochar showed an unexpectedly high AWC. Overall, variations of chemical and physical properties between bamboo biochars were greater, while pinewood biochars showed similar properties, consistent with more homogeneous charring temperatures.

Soil degradation and water stress in Costa Rica challenge the production of highly sensitive crops. This work is aimed at evaluating the physical and chemical changes in sandy loam (SL) and a silt loam (SiL) soil when amended with bamboo biochar while estimating the enhancement of tomato productivity. Biochar, obtained from Guadua Angustifolia bamboo feedstock, was mixed into sieved bulk soil substrate from the topsoil, from Andosol and Umbrisol groups, at application rates of 1, 2.5, and 5% (dry mass). Physicochemical and morphological properties of biochar such as pH, hydrophobicity, scanning electron microscopy images, helium picnometry, specific surface area by the Brunauer–Emmett–Teller (BET) method, CHNS, and ash content were determined. Soil hydrophobicity, acidity, electrical conductivity, cation exchange capacity and water retention, available water content, and air capacity were analyzed for the amended soils. Tomato yield was quantified after a harvest period of two months. The admixture of biochar did not significantly increase soil cation exchange capacity but increased water retention in the range of available water content. Class A (>200 g) tomato yield increased 350% in the SL and 151% in the SiL. Class B (100–200 g) tomato yields increased 27% in the SL but decreased about 30% in the SiL. Tomato yield response seems attributable to variation of water retention capacity, available water content, and air capacity. These results support the use of adapted water management strategies for tomato production based on soil physical changes of biochar.

El desarrollo tecnológico de los vehículos aéreos no tripulados, VANT´s da acceso a nuevas aplicaciones en múltiples campos de la ciencia y la ingeniería. El uso de sensores remotos, el análisis satelital, la medición de datos en el sitio han sido las principales herramientas empleadas para la monitorización y el estudio de los recursos naturales. Los VANT´s son una tecnología de bajo costo capaz de recolectar información de manera rápida y precisa, con alta resolución espacial. El objetivo del presente trabajo fue realizar una revisión de las características principales y las aplicaciones de los vehículos aéreos no tripulados en el manejo de los recursos naturales, principalmente en la región latinoamericana. En este trabajo se describen los tipos de drones existentes, sus ventajas, desventajas y los diferentes tipos de sensores que se pueden adaptar. Además, se revisaron trabajos sobre VANTS realizados en Brasil, Perú y Colombia como una guía para América Latina. Se muestra una serie de posibles arreglos entre VANTS y sensores remotos., Próximamente, estos arreglos tendrán un amplio potencial de incrementar la eficiencia de adquisición de datos, incrementando su aplicabilidad en el campo del estudio de los recursos naturales. El futuro del uso de este tipo de tecnologías parece apuntar a una mayor automatización en la captura de datos, mejoras en el rendimiento de los tiempos de vuelo y sistemas automatizados con algoritmos complejos capaces de ofrecer información en tiempo real.

With the increasing focus on irrigation management, it is crucial to consider cost-effective alternatives for soil water monitoring, such as multi-point monitoring with low-cost soil moisture sensors. This study assesses the accuracy and functionality of low-cost sensors in a sandy loam (SL) soil amended with biochar at rates of 15.6 and 31.2 tons/ha by calibrating the sensors in the presence of two nitrogen (N) and potassium (K) commercial fertilizers at three salinity levels (non/slightly/moderately) and six soil water contents. Sensors were calibrated across nine SL-soil combinations with biochar and N and K fertilizers, counting for 21 treatments. The best fit for soil water content calibration was obtained using polynomial equations, demonstrating reliability with $R^2$ values greater than 0.98 for each case. After a second calibration, low-cost soil moisture sensors provide acceptable results concerning previous calibration, especially for non- and slightly saline treatments and at soil moisture levels lower than 0.17 cm³cm⁻³. The results showed that at low frequencies, biochar and salinity increase the capacitance detected by the sensors, with calibration curves deviating up to 30% from the control sandy loam soil. Due to changes in the physical and chemical properties of soil resulting from biochar amendments and the conductive properties influenced by fertilization practices, it is required to conduct specific and continuous calibrations of soil water content sensor, leading to better agricultural management decisions.

Costa Rica produces a considerable, important quantity of wood residues. This waste can be pyrolyzed to produce charcoals as main products that can be effectively used as an energy source or to immobilize carbon for soil treatment. However, there is a lack of information about the pyrogenic carbonaceous materials (PCMs), such as charcoal or biochar, obtained at different pyrolysis temperatures. Hence, this study aimed to evaluate the quality of PCMs (physical, mechanical, ultimate analysis, and FTIR analysis) and charcoal characteristics (energetic properties and thermogravimetric analysis—TGA) and biochar characteristics (conductivity, pH, initial contact angle, and wetting rates) for four tropical wood residues produced in five temperatures (300 °C, 350 °C, 400 °C, 450 °C, and 500 °C). In general, pyrolysis temperature between 450 °C and 500 °C produced charcoals with lower values of density, moisture content, compression strength, volatiles, H and O content, and higher values of C and ash contents, conductivity, pH, initial contact angle, and wetting rates. FTIR and TGA analyses show that celluloses and lignin are pyrolyzed at these temperatures, so these temperatures are recommended. The range of 300–350 °C is not recommended, as these parameters were inverse. Multivariate analysis shows that (i) PCMs obtained at lower temperatures (300–350 °C) from Dipteryx panamensis, Hieronyma alchorneoides, and Tectona grandis belong to a cluster with poorer properties, indicating that these temperatures are not adequate for pyrolysis of these species; (ii) all the PCMs obtained from Gmelina arborea were grouped into one cluster, suggesting different PCM quality; and (iii) the PCMs produced from D. panamensis, H. alchorneoides, and T. grandis at 400–500 °C were grouped into another cluster with better properties, suggesting this pyrolysis temperature range as the best for these species.

The occurrence of pharmaceutical pollutants in aquatic matrices has been reported as an increasing concern around the world. Sustainable and feasible water treatment technologies are necessary to mitigate water pollution. In this study, we developed an environmentally friendly biochar electro-degradative system using biomass derived through green technologies. The system demonstrated exceptional removal efficiency, achieving over 99% removal of acetaminophen, sulindac, and carbamazepine following biochar electro-degradative treatment. Similar results were achieved from the mixture of the three compounds. The biochar column reusability confirmed the system stability, even after repeating the degradation cycles. Our findings highlight the potential of this novel electro-degradative system as an effective solution for the removal of pharmaceutical residues from wastewater.