A vertical offset model for Vietnam and its surrounding areas was determined based on the differences between height anomalies derived from 779 Global Navigation Satellite System (GNSS)/levelling points and those derived from a dedicated high-resolution gravimetric-only quasigeoid model called GEOID_LSC. First, the deterministic transformation model to effectively fit the differences between the quasigeoid and GNSS/levelling heights was based on a third-order polynomial model. Second, the residual height anomalies have been interpolated to a grid employing Least-Squares Collocation. Finally, the distortions were restored to the residual grid. This model can be used for combination with a gravimetric quasigeoid model in GNSS levelling. The quality of GNSS/levelling data in Vietnam was analyzed and evaluated in this study. The annual subsidence rate from ALOS-1 was also used to analyze the effects of subsidence on the quality of GNSS/levelling data in the Mekong Delta. From this we made corrections to improve the accuracy of GNSS/levelling data in this region. The offset model was evaluated using cross-validation technique by comparing with GNSS/levelling data. Results indicate that the offset model has a standard deviation of 5.9 cm in the absolute sense. Based on this offset model, GNSS levelling can be carried out in most of Vietnam’s territory complying third-order levelling requirements, while the accuracy requirements for fourth-order levelling networks is met for the entire country. This model in combination with the developed gravimetric quasigeoid model should also contribute to the modernization of Vietnam’s height system. We also used high-quality GNSS/levelling data and the determined quasigeoid model to determine the geopotential value W0 for the Vietnam Local Vertical Datum. The gravity potential of the Vietnam Local Vertical Datum is estimated equal to = 62,636,846.81 ± 0.70 m2s−2 with the global equipotential surface realized by the conventional value W0 = 62,636,853.4 m2s−2.
A high-resolution gravimetric quasigeoid model for Vietnam and its surrounding areas was determined based on new gravity data. A set of 29,121 land gravity measurements was used in combination with fill-in data where no gravity data existed. Global Gravity field Models plus Residual Terrain Model effects and gravity field derived from altimetry satellites were used to provide the fill-in information over land and marine areas. A mixed model up to degree/order 719 was used for the removal of the long and medium wavelengths and the calculation of the quasigeoid restore effects. The residual height anomalies have been determined employing the Stokes integral using the Fast Fourier Transform approach and deterministic kernel modification proposed by Wong–Gore, as well as by means of Least-Squares Collocation. The accuracy of the resulting quasigeoid models was evaluated by comparing with height anomalies derived from 812 co-located GNSS/levelling points. Results are very similar; both local quasigeoid models have a standard deviation of 9.7 cm and 50 cm in mean bias when compared to the GNSS/levelling points. This new local quasigeoid model for Vietnam represents a significant improvement over the global models EIGEN-6C4 and EGM2008, which have standard deviations of 19.2 and 29.1 cm, respectively, for this region.
High-resolution Moho and lithosphere–asthenosphere boundary depth models for Vietnam and its surrounding areas are determined based on a recently released geoid model constructed from surface and satellite gravity data (GEOID_LSC_C model) and on 3ʹʹ resolution topography data (mixed SRTM model). A linear density gradient for the crust and a temperature-dependent density for the lithospheric mantle were used to determine the lithospheric structure under the assumption of local isostasy. In a first step, the impact of correcting elevation data from sedimentary basins to estimate Moho depth has been evaluated using CRUST1.0 model. Results obtained from a test area where seismic data are available, which demonstrated that the sedimentary effect should be considered before the inversion process. The geoid height and elevation-corrected sedimentary layer were filtered to remove signals originating below the lithosphere. The resulting Moho and lithosphere–asthenosphere boundary depth models computed at 1ʹ resolution were evaluated against seismic data as well as global and local lithospheric models available in the study region. These comparisons indicate a consistency of our Moho depth estimation with the seismic data within 1.5 km in standard deviation for the whole Vietnam. This new Moho depth model for the study region represents a significant improvement over the global models CRUST1.0 and GEMMA, which have standard deviations of 3.2 and 3.3 km, respectively, when compared to the seismic data. Even if a detailed geological interpretation of the results is out of scope of this paper, a joint analysis of the obtained models with the high-resolution Bouguer gravity anomaly is finally discussed in terms of the main geological patterns of the study region. The high resolution of our Moho and lithosphere–asthenosphere boundary depth models contribute to better constrain the lithospheric structure as well as tectonic and geodynamic processes of this region. The differences in Moho depth visible in the northeast and southwest sides of the Red River Fault Zone confirmed that the Red River Fault Zone may be considered the boundary between two continental blocks: South China and Indochina blocks. However, no remarkable differences in lithosphere–asthenosphere boundary depth were obtained from our results. This suggests that the Red River Fault Zone developed within the crust and remained a crustal fault.
Gravity on Earth is of great interest in geodesy, geophysics, and natural resource exploration. Ship-based gravimeters are a widely used instrument for the collection of surface gravity field data in marine regions. However, due to the considerable distance from the sea surface to the seafloor, the spatial resolution of surface gravity data collected from ships is often insufficient to image the detail of seafloor geological structures and to explore offshore natural minerals. Therefore, the development of a mobile underwater gravimetry system is necessary. The GraviMob gravimeter, developed for a moving underwater platform by Geo-Ocean (UMR 6538 CNRS-Ifremer-UBO-UBS), GeF (UR4630, Cnam) and MAPPEM Geophysics, has been tested over the last few years. In this study, we report on the high-resolution gravity measurements from the GraviMob system mounted on an Autonomous Underwater Vehicle, which can measure at depths of up to several kilometres. The dedicated GraviMob underwater gravity measurements were conducted in the Mediterranean Sea in March 2016, with a total of 26 underwater measurement profiles. All these measurement profiles were processed and validated. In a first step, the GraviMob gravity measurements were corrected for temperature based on a linear relationship between temperature and gravity differences. Through repeated profiles, we acquired GraviMob gravity measurements with an estimated error varying from 0.8 to 2.6 mGal with standard deviation after applying the proposed temperature correction. In a second step, the shipborne gravity data were downward continued to the measurement depth to validate the GraviMob measurements. Comparisons between the corrected GraviMob gravity anomalies and downward continued surface shipborne gravity data revealed a standard deviation varying from 0.8 to 3.2 mGal and a mean bias value varying from −0.6 to 0.6 mGal. These results highlight the great potential of the GraviMob system in measuring underwater gravity.
21 April 2021 in Geophysical Journal International
In the realisation of the International Height Reference System, the determination of the geopotential value and its variations in time plays an important role. In this study, the geodetic boundary value problem approach is applied for direct determination of the gravity potential value using a GOCE global gravity field model enhanced with terrestrial gravity data. This determination is carried out on the Global Navigation Satellite System-Continuously Operating Reference Stations (GNSS-CORS) stations towards the realisation of the International Height Reference System in Vietnam. First, the effects of the GOCE global gravity field model omission error, the indirect bias term on the disturbing potential and the systematic cumulative errors in levelling data are estimated. These errors affect the estimated geopotential value. The results calculated on the GNSS/levelling points show that the effect of the GOCE DIR-R5 (up to degree/order 260) omission error on the offset potential value is quite significant. This effect was eliminated using high-resolution terrestrial gravity data using the remove-compute-restore technique. The indirect bias term on the disturbing potential can be safely neglected by using a GOCE global gravity field model for degrees higher than 60 for this study region. The systematic cumulative errors in levelling data can be modelled and removed using a third-order polynomial model. Then, the mean zero-height gravity potential of the Vietnam local vertical datum is estimated equal to |${\rm{W}}_0^{{\rm{LVD}}}$| = 62 636 846.69 m2 s–2 with standard deviation of 0.70 m2 s–2 based on the proposed approach. Finally, the geodetic boundary value problem approach was used to determine the geopotential on the surface of three GNSS-CORS stations in Vietnam. Based on time-series of the vertical component derived from the GNSS observations as well as InSAR data, temporal variations in geopotential are also estimated on these permanent GNSS stations. The purpose is to monitor deformation of the vertical datum. The results indicate that the geopotential value needs to be monitored and determined with the time-dependent component on the three Vietnamese permanent GNSS stations for a vertical datum. These stations may contribute to increase the density of reference points in the International Terrestrial Reference Frame, which is being researched and implemented by the International Association of Geodesy.
We investigate using the GIRAFE cold-atom gravimeter during an airborne gravity survey for improving gravity field and quasigeoid modelling. The study is conducted over the Bay of Biscay, France. Geoid/quasigeoid determination is usually a major challenge over such coastal areas due to scarce and inconsistent gravity data. In a first step, the GIRAFE dataset is analysed and compared with available surface gravity data as well as with global altimetry models from UCSD and DTU. The comparisons indicate that the DTU model is better than the UCSD model within around 10 km from the coastline. Furthermore, recent satellite altimeter missions significantly improve the altimetry models in coastal areas. A significant bias (− 4.00 mGal) in shipborne data is also found from this comparison. In a second step, eight quasigeoid solutions are calculated to evaluate the contribution of GIRAFE data. This contribution reaches 3 cm in terms of height anomaly for DTU21 while being much larger for UCSDv31 and shipborne data. Finally, the quasigeoid solutions are validated using GNSS-levelling data. The results indicate that using GIRAFE data improves by approximately 50% the quality of quasigeoid models over land near the coast. The highest accuracy, around 1 cm, is achieved when GIRAFE data are merged with refined gravity data. Importantly, the standard deviation is just 1.2 cm when compared with GNSS-levelling points if using only GIRAFE data over marine areas, which is very close to the 1 cm goal of geoid/quasigeoid model determination in modern geodesy. This study thus confirms the benefits of performing airborne gravity survey using quantum sensors.