Broadband broadcast and multicast wireless systems usually employ OFDM modulations (Orthogonal Frequency Division Multiplexing) combined with non-uniform hierarchical constellations. However, these schemes are very prone to nonlinear distortion effects and have high carrier synchronization requirements. SC-FDE (Single-Carrier with Frequency-Domain Equalization) is an attractive alternative for OFDM, especially when an efficient power amplification is intended. In this paper we consider the use of SC-FDE schemes combined with non-uniform hierarchical constellations in broadband broadcast and multicast wireless systems. We study the impact of residual CFO (Carrier Frequency Offset) on the performance of multi-resolution schemes and we propose iterative frequency domain receivers with joint detection and carrier synchronization to cope with residual CFO estimation errors (a coarse CFO estimation and compensation is assumed before the equalization procedure). Our results show that while a very high carrier synchronization accuracy is required for the least protected bits, the most protected bits are relatively robust to the CFO. By employing the proposed receiver we increase significantly the robustness to residual CFO estimation errors.
Although millimeter-wave (mmWave) and massive multiple input multiple output (mMIMO) can be considered as promising technologies for future mobile communications (beyond 5G or 6G), some hardware limitations limit their applicability. The hybrid analog-digital architecture has been introduced as a possible solution to avoid such issues. In this paper, we propose a two-step hybrid multi-user (MU) equalizer combined with low complexity hybrid precoder for wideband mmWave mMIMO systems, as well as a semi-analytical approach to evaluate its performance. The new digital non-orthogonal multi carrier modulation scheme generalized frequency division multiplexing (GFDM) is considered owing to its efficient performance in terms of achieving higher spectral efficiency, better control of out-of-band (OOB) emissions, and lower peak to average power ratio (PAPR) when compared with the orthogonal frequency division multiplexing (OFDM) access technique. First, a low complexity analog precoder is applied on the transmitter side. Then, at the base station (BS), the analog coefficients of the hybrid equalizer are obtained by minimizing the mean square error (MSE) between the hybrid approach and the full digital counterpart. For the digital part, zero-forcing (ZF) is used to cancel the MU interference not mitigated by the analog part. The performance results show that the performance gap of the proposed hybrid scheme to the full digital counterpart reduces as the number of radio frequency (RF) chains increases. Moreover, the theoretical curves almost overlap with the simulated ones, which show that the semi-analytical approach is quite accurate.
22 June 2022 in IEEE Transactions on Wireless Communications
The use of efficient high-power amplifiers (HPAs) is critical for future millimeter-wave (mmWave) systems. HPAs can become highly nonlinear when operated near saturation, distorting the transmission signal. Therefore, the design of efficient solutions to mitigate nonlinear distortion (NLD) is of paramount importance. This article proposes a hybrid multiuser equalizer for the uplink of wideband mmWave massive MIMO systems. The equalizer is designed to mitigate both the multiuser interference (MUI) and inter-symbol interference (ISI), introduced by the multiple access channel, and the NLD, introduced by the user terminals HPA. The digital part of the hybrid equalizer is iterative and computed on a per subcarrier basis, to minimize the mean squared error between the transmitted and detected data. In the iterative processing, a feedback loop estimates and removes the distortion. The analog part is frequency-flat and its design assumes that the digital part efficiently removes the MUI, ISI and NLD. Performance results show a huge gain of the proposed hybrid nonlinear equalizer, when compared with linear ones. The nonlinear effects are almost completely removed, without significant error propagation effects, allowing a more efficient operation of the HPAs.
Most of the previous work on hybrid transmit and receive beamforming focused on narrowband channels. Because the millimeter wave channels are expected to be wideband, it is crucial to propose efficient solutions for frequency-selective channels. In this regard, this paper proposes an iterative analog–digital multi-user equalizer scheme for the uplink of wideband millimeter-wave massive multiple-input-multiple-output (MIMO) systems. By iterative equalizer we mean that both analog and digital parts are updated using as input the estimates obtained at the previous iteration. The proposed iterative analog–digital multi-user equalizer is designed by minimizing the sum of the mean square error of the data estimates over the subcarriers. We assume that the analog part is fixed for all subcarriers while the digital part is computed on a per subcarrier basis. Due to the complexity of the resulting optimization problem, a sequential approach is proposed to compute the analog phase shifters values for each radio frequency (RF) chain. We also derive an accurate, semi-analytical approach for obtaining the bit error rate (BER) of the proposed hybrid system. The proposed solution is compared with other hybrid equalizer schemes, recently designed for wideband millimeter-wave (mmWave) massive MIMO systems. The simulation results show that the performance of the developed analog–digital multi-user equalizer is close to full-digital counterpart and outperforms the previous hybrid approach.
The high Doppler effects in satellite communications make the equivalent channels fast varying, which leads to channel estimation difficulties and the need for high channel estimation overheads. In this paper we propose a state-space approach for tracking channel variations for satellite links with high Doppler frequency shifts. We consider the communication between satellite links where a multi-antenna receiving satellite is connected to several transmitting satellites, which can have substantially different Doppler drifts. The proposed channel tracking technique follows the individual Doppler drifts for the different satellites. Finally, our performance results indicate that the proposed channel tracking is able to cope with strong Doppler drifts, without the need for high channel estimation overheads, making it a promising technique for future systems using satellite mega-constellations.