We present a high yield and high sensitivity on-chip biosensing system by combining subwavelength grating coupling and high sensitivity photonic crystal microcavity side coupled to a photonic crystal waveguide. 80% yield of working devices was experimentally demonstrated for sensitivity engineered L13 photonic crystal microcavities and 70% for L21 photonic crystal microcavities. Subwavelength grating couplers significantly improved the quality of the output transmission spectrum. By engineering the optical loss rate from the cavity to the waveguide, we experimentally detected 1 pM (67 pg/ml) and 50 femto-molar (3.35 pg/ml) concentration of avidin binding to biotin in phosphate buffered saline for L21 and L55 PC microcavities respectively, which represents the highest sensitivity versus other chip-based optical biosensors.
High-rate roll-to-roll (R2R) tracker systems are utilized for large volume flexible electronic device manufacturing, and the current alignment mechanism between layers is mainly achieved by relying on passive techniques. In this paper, we present a machine vision based alignment strategy that is used to achieve precise registration for stacking multilayers. Based on this strategy, we demonstrate two-layer printing with alignment accuracy better than 100 μm in web moving direction and 200 μm in lateral direction at a web rate of 5 m/min.
In this paper, we report the transfer and characterization of in-plane silicon nanomembrane based photonic devices on a Kapton polyimide flexible substrate. Compared with electronic devices and surface normal optical devices, in-plane photonic devices have stringent requirements on transfer precision because any shift in the position or breakage can affect the performance of devices. Therefore, a supporting layer consisting of a photoresist is exploited to protect the device during the transfer process. A modified stamp-assisted transfer technique is employed in order to transfer nanomembrane devices onto the flexible film and the transfer of large aspect ratio (up to 4000) waveguides and 1x6 multimode interference (MMI) couplers on a flexible Kapton substrate is demonstrated. A two-step cleaving method is developed in order to prepare the facets of the transferred waveguides and in-plane light coupling into a 60μm wide, 8mm long flexible waveguide from a lensed fiber is demonstrated. This demonstration opens limitless possibilities for a whole new area of high performance flexible photonic components using silicon nanomembrane technology.
We demonstrate board-to-board optical communication utilizing 45 degree mirrors and print-on-demand micro-lenses as surface-normal coupler. The presented system which includes polymer waveguides, embedded 45 degree mirrors and micro-lenses, realizes back-to-back optical interconnects between two boards. The waveguide and mirrors are fabricated using molding method using a low-cost electroplated nickel mold. Micro-lenses (80 μm in diameter) are fabricated using a material inkjet-printer, on top of the 45 degree mirrors. Experimental results show that each 45 degree mirror contributes about 1.88 dB loss (65% coupling efficiency) to the total optical loss. When propagating in free space without a lens, a 2 mm separation between boards results in a 9.9 dB loss, which is reduced to 7.5 dB when a micro-lens is inserted in the path. High speed data transmission test is performed at various separations. At a separation of 1mm, the system can provide 10Gbps error free transmission. At 2mm separation, the maximum error free data rate was measured to be 3.5Gbps and 7.5Gbps, with and without the micro-lens, respectively. Printing the micro-lenses on both the input 45 degree mirror and the photodiode or the receiving 45 degree mirror in a confocal setup will significantly reduce the freespace propagation loss. To the best of our knowledge, this is the first report of free-space coupling between waveguides on separate boards.